The front headlight goes on/off it is no safe to drive on night. please help me how can I fix it? 2008 Chrysler town and country
I think it is a loose connection. If you know how to access the headlight bulb(s), gently, with a soft cloth check if bulb is loose. if so, gently tighten it and you are ok.
See the diagram attached use the VOM , and fix it. God bless you
clean all contacts corroded, and loose.tight any connector loose or bad contacts
Testimonial: "I don't know if this is going to work .I'm going to try and let you know. gracias y Dios te bendiga por ayudarnos :} "
SOURCE: How do I adjust headlights on a Chrysler town and country 1996
Look around the edge of the headlight. You may have to pull a cover off from around the headlight if you cannot see them. Normally there are 2 screws that can be adjusted with a cross tip screwdriver. One screw on top of the light, and on on the side. Loosen the top screw to adjust down, tighten the screw to adjust up. If the side screw on the light is towards the inside, then loosen the screw to adjust towards the outside of the road and tighten it to adjust the light towards the inside of the road. If the screw is towards the outside of the light, then it is reversed. tighten to bring the light towards the edge of the road and loosen to bring the light towards the inside of the road. Hope this helps!
SOURCE: where is the cooling fan relay on 2005 chrysler town and country
I am not sure on this one but I think the left front headlight has to be removed. Also I think these are riveted on and you will have to drill the rivets and gently use a chisel to get them off.
SOURCE: Early wear on front brakes /rotors for 2008 Town and Country
I work for a brake repair shop and trust me you are not alone.Enterprise and alot of other people bought the same van and had the same trouble.I hate to say but it doesnt stop there.About every 14 to 15 thousand miles you have to replace the front pads.As of now they dont have an upgrade,for instance ceramic pads, but I am sure they will very soon
SOURCE: how to replace our low beam headlight on 1999 town and country
1.) Open the hood of your van
2.) On the passenger side of the vehicle, look behind the headlight
enclosure. You will see a set of wires running into the back of it.
This is the power clip. Either with your hand or a flat-head
screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the
ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful
not to touch the glass part of the new bulb. The oils in your skin can
substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.
SOURCE: Front PCV Valve on chrysler town and country
PCV valve location-2.4L engine
PCV valve location-3.3L and 3.8L engines
173 views
Usually answered in minutes!
well. I tried a new bulb but doing the same on and off both headlights
×