Question about 2004 Mazda RX-8

Open Question

Aatcc, aa1, aa2 codes

Attempting to get info on these three codes but can't seem to locate any. this is for my aunt's rx8 and the "crooks" are taking advantage of her. any help would be greatly appreciated!

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 44 Answers

SOURCE: 2004 Maxda RX8 codes U0101 & U0155

These are transmission control module can communications codes. ealer will need to repair these for sure.

Posted on Sep 10, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What do the codes aa1 and aa2 mean


Where did you get these codes from ?

Dec 20, 2014 | 2002 Buick LeSabre

1 Answer

1998 dodge carevan/ccdbusine aa1 aa2-tcm


check bus communication voltage

Aug 27, 2014 | 1998 Dodge Caravan

1 Answer

Ford p0743


This code can be caused by low or dirty fluid I would start with a flush and a filter . If not you need a new valve body in the transmission .

Oct 28, 2013 | Lincoln Cars & Trucks

1 Answer

I have a 2003 Cadillac Escalade, and I recently had a print out done on my vehicle. I'm not understanding these codes: aa1 poor connection at the TAC module, aa2 failed TAC module, aa3 check TPP or TP


I always ask---If you went to the trouble to have
it scanned & get a nice print out & I would assume
asked all these questions at the shop,then why
did you not leave it,to be further component tested
& issue resolved?

TAC -throttle actuator control

The drive by wire motor that opens the throttle
body plate

TPS Sensor--throttle position sensor on the same

Try spraying some CRC Throttle Body Cleaner in
there around the throttle plate

After that you need to have to tps sensor tested
I wouldn't be in a hurry to change a throttle body,
they cost hundreds & the codes don't tell you it's bad

The only time you replace a throttle body is if you can not
get the motor by it's self

Oct 02, 2012 | Cars & Trucks

2 Answers

P0446 code 1998 gmc jimmy how do I fix this? where is it located?


Hi there:

A code P0446 could mean one or more of the following has happened:
- Faulty vent valve
- Open, short or excessive resistance on Vent valve control circuit
- Blockage of vent valve
- Bad PCM




With a P0446 OBD-II trouble code, here are some things to try:
- Replace Vent valve
- Repair open, short, or resistance problem in control circuit
- Repair open, or short, or resistance problem in power circuit

- Replace PCM




Hope this helps.

May 30, 2012 | 1998 GMC Jimmy

1 Answer

How do I fix P0442?


check the egr, common reason for this code, that is not listed in the solus

Mar 01, 2012 | 2005 Kia Sorento

1 Answer

2005 Nissan Altima service engine light came on, Had a reading = P0420, #1 aa1 Large vacumm leak, #2 aa2 Fuel system fault, #3 aa3 Ignition system fault and #4 aa4 Failed Bank 1 catalytic converter. Any...


one thing you can bet the house on ....if a nissan sets a cat converter code...it needs a cat converter...trust me on this.in the last 10 yrs. as nissan master tech i have seen no other cause!

Mar 18, 2011 | 2005 Nissan Altima

1 Answer

Can you tell me what the below codes mean. I just when to Auto Zone and had a diagnostic scanning done. AA- bank 1 AA1 aa2 aa3 aa4 Thank you.


I also work for autozone, 5+ years, and these are not trouble codes. I would find another Autozone and have them re-read it. Trouble codes would look like this: P0300, or P1756. The codes you have are not correct. Also, they should take you inside, look up the code, and explain what they mean. Also. ask them to print them out.

Dec 29, 2010 | 2003 Toyota Corolla

Not finding what you are looking for?
2004 Mazda RX-8 Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...