Question about Toyota Cars & Trucks

Open Question

Power door lock clicking noise

Clicking noise when i lock , but no clicking noise when i unlock

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
MrScary66613
  • 1990 Answers

SOURCE: Power windows, locks, and seat not working

That Clicking should be a Bad Relay Switch. See if you can Locate it and Replace it. It should fix this Problem for ya! Please Rate My Response! Thanks!

Posted on Jan 31, 2009

Ad
reichweinj
  • 71 Answers

SOURCE: Power door lock won't unlock 99 Jeep Grand Cherokee

Sounds like the actuator went out. There normally run 40-60 for the part and does not take long to replace normally 30 minutes.

Posted on Mar 17, 2009

  • 186 Answers

SOURCE: Power door locks going crazy

One of your door lock inside switches are bad.Find the one that doesn't feel right when you push it in either lock or unlock.The internal spring is broke causing the lock relay to keep try to lock or unlock until it gets hot & protects.

Posted on May 10, 2009

  • 3 Answers

SOURCE: 2006 BMW 323i Passnger Door lock will not lock / unlock w/ remote

Replace fuse 57 (15 amp) then disconnect battery and wait 30 to 45 minutes before reconnecting the battery.

My 2006 BMW 325I had the same problem with the door locks not responding. I checked all related fuses and found #57 (15 amp) was the only related fuse blown. I put in a new fuse and it still would not work. I then disconnected the battery for a while then once I reconnected the battery everything worked fine.

I believe I blew the fuse while repeatedly pushing the unlock button rapidly while walking across the parking lock to the car. I suggest only pushing the unlock button only once or twice.

Posted on Dec 11, 2009

  • 1 Answer

SOURCE: the power door locks will unlock only, not lock.

I am looking for the same problem. The power door lock work only on to unlock. When I try to lock the doors I hear only a cliking three time but the doors doesn't unlock

Posted on Feb 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is causing clinking sounds when unlocking the doors with the remote? I also hear clicks when shutting the car off when the locks auto.


Next time notice the manual lock. If it is moving with the click noise, the lock actuator is going out.

Oct 09, 2016 | 2008 Kia Sorento 3.3

1 Answer

Driver side door will not lock/unlock with the remote, but the other doors will.


no you needs a new lock actuator on that door its about $90 installed,
all the locks are on same circuit . sorry about the bad news :(

May 01, 2016 | 2003 Hyundai Sonata

1 Answer

I can hear it click but it wont open with the key either.


Auto Repair : Power Door Lock Troubleshooting - YouTube

? 1:52
https://www.youtube.com/watch?v=wsqbE_ztTYw
May 12, 2009 - Uploaded by ehowauto
Hi i have a locked driver side door that will not open.when i lift the locking ... I press the power lock, and hear a sound but all four doors remain locked or unlocked ... Hey sorry for the botherbut I need help.my key button don't unlock or lock.the button inside the car doesn't work either to unlock or lock.so I'm ...

Fixing A Car That Does Nothing When You Turn The Key ...

? 3:37
https://www.youtube.com/watch?v=TSE0fOrujW0
Aug 16, 2012 - Uploaded by Scotty Kilmer
2005 Mustang wont start or crank from the key.. wont say nothing good battery ..... all I hear is clicking noise my radio and lights and everything comes on but it will not do nothing what couldthis be have I blown something?

Jan 06, 2016 | Cars & Trucks

1 Answer

When I use my remote starter & door lock/unlock and the lock/unlock button in the car, it does not lock or unlock both back doors. It does start the car, opens the trunk, and lock & unlock both...


The rear doors probably dont come w accuators in them. Meaning that the rear doors alot of times don't have power options. If you are certain that your rear doors have factory power locks then I would say it's a wire somewhere...did you try a double click of the unlock button. My two door chevy truck unlocks the driver door with one click and the pass door requires a double click. Hope this helps !

Mar 09, 2011 | 2009 Chevrolet Impala

1 Answer

The drivers door will not lock automatically when the engine is engaged or when I use the keyless lock/unlock on my keychain


if actuator is making noise/clicking possible locking rod clip disconnected or damaged if no noise check power and in between door by hinge for possible damaged wires if good --need to remove door panel and repair or replace lock rod connections or test and repair/replace actuator

Oct 23, 2009 | 2002 Oldsmobile Alero

1 Answer

Power locks don't lock or unlock hear noise under dash near glove box i was wondering if relay switch is no good.hear clicking noise in relay, when trying to unlock or lock doors


if the relay is clicking,its most likely working,sounds like signal from relay is not getting back to doors to unlock doors,I would check for damaged wiring at pivot point of door(hinge) area,all the wiring goes through a large rubber accordion looking tube,pull back one side of rubber and inspect wiring for damage

Oct 15, 2009 | Pontiac Bonneville Cars & Trucks

1 Answer

Power door lock, driver side only, does not work in my '95 Sable


if you here a noise that should mean the little motor (door lock actuator) thar works the door lock is getting power to it and it should be ok. sounds like when you changed the inside latch you must have disturbrd/disconnected the linkage or the clip that connects the lock actuator to the latch assembly(the female V-SHAPED mechanism that engages the POST/STRIKER (male part) its a little hard to name these parts so i am describing them to you. look insidethe door and see if you see any threaded RODS OR LINKAGES that are not connected at both ends.the noise youre hearing is most likely the door lock actuator "spinning"up and down but its unable to lock or unlock the door latch mechanism.

Sep 01, 2009 | 1994 Mercury Sable

1 Answer

Power door locks going crazy


One of your door lock inside switches are bad.Find the one that doesn't feel right when you push it in either lock or unlock.The internal spring is broke causing the lock relay to keep try to lock or unlock until it gets hot & protects.

May 07, 2009 | 2001 Saturn SC

1 Answer

Power door lock won't unlock 99 Jeep Grand Cherokee


Sounds like the actuator went out. There normally run 40-60 for the part and does not take long to replace normally 30 minutes.

Mar 16, 2009 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...