Question about 2006 Dodge Ram 2500
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
fuel filter housing on driver side of motor. need the correct size of socket to remove the lid. unscrew lid and pull straight up to remove filter. remove old filter from lid and install new filter and seal. drain old fuel/water from housing. then reinstall filter into housing. tigthten lid then make sure the petcock is closed from draining it earlier. bump the starter a couple times to fill the filter housing then start engine. clean any spilled fuel and your done
Posted on Jan 22, 2009
I have a 2004 dodge ram 1500 with the same problem, vibrating blow fan when on high, pulled the blower fan out and found a piece of the hinge from the recirculation door and felt the recirculation door sitting up on the vent of its hinge. Crappy engineering once again.
Posted on Jun 07, 2009
If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.
Posted on Sep 26, 2009
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Posted on Nov 04, 2009
Tips for a great answer:
Feb 11, 2016 | 2006 Dodge Ram
Apr 13, 2014 | 2006 Dodge Ram 2500
Aug 28, 2011 | Dodge Ram 2500 Cars & Trucks
Nov 06, 2010 | 2008 Dodge Ram Pickup 2500
Sep 30, 2010 | 2006 Dodge Ram 2500
Sep 19, 2010 | 2006 Dodge Ram 2500
Sep 23, 2009 | 2006 Dodge Ram 3500 Truck
Sep 17, 2015 | 2006 Dodge Ram 2500
34 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: