Question about Cars & Trucks

Open Question

Uplander sliding door fell off track. how do I fix this

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Window fell off track (1996 honda accord)

I like to see the timeing belts mark on the oil pump crank valve

Posted on Mar 31, 2009

Ad
  • 82 Answers

SOURCE: 2006 Chevy Uplander. The power sliding doors won't shut

2 possible solutions. First clean the door pin contacts(multiple spring loaded pins on door side and matching plate on body) with a scotch pad until shiny gold color again. Second the rear edge of the door should be 1mm inside the body opening when closed. If those are correct it is going to take a software download from a dealer to the door control module to fix this. Otherwise you will have to pull the psd fuse and breaker from the right side dash fuse box.

Posted on Jun 23, 2009

  • 3600 Answers

SOURCE: Rolling down power window and it fell off track

Ok I can't see the car so I don't know how to tell you to fix it. It would be nice If I knew what you were working on, but if you go to the dealer and go to the parts desk and give them more information than you have me they could print you a picture of the door and glass and frame assembly and most likely won't charge you for it, Since you will have to buy rollers or other parts to fix it.

Posted on Aug 06, 2009

  • 1 Answer

SOURCE: chevy uplander 2005 and there is a constant

That happens to me all the time!! I just pull over, put it in park, open both sliding doors halfway then close them. This always gets rid of the problem. It's happening because one of the doors isn't catching correctly when it closes and once u hit a bump or anything you will here the dinging.

Posted on Aug 25, 2009

  • 163 Answers

SOURCE: window slide fell to bottom of door

Start by taking the door panel apart, the cable window regulators are not too complex and can be purchased aftermarket. More than likely a cable is broken.

Posted on Sep 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Passager side rear autmatic door will not close


your wire has come off door inside the door try unpluging fuse or the noise alarm under dash you need to replace the wires inside the sliding door to get it to close right again they have got tangled some how and tore loose.

Feb 15, 2013 | 2006 Chevrolet Uplander

1 Answer

What do i do if the window falls into the door and off track


pull door panel of and pull the window up ask some one to help u to hold it then raise up and down your track and slide window on ,then tighten up the bolts that holds it on track but make sur before you completly tighten the bolts to c if it properly set where the door can open and shut then tighten bolts on the rail and put the door panel back on : )

Jan 17, 2013 | 1997 Ford Expedition

1 Answer

Passenger side window came off trac and is sitting in door


you have to remove the door panel..unbolt the tracking from inside the door..slide the windows back inside the track rails....push window all the way up..tape the window so that id does not fall back down or have someone hold window up while you rebolt the track to the door.replace door panel....the tracks move over time and that it why the window fell.

Jan 26, 2011 | 2004 Cadillac Deville

1 Answer

Sliding door wont work. comes out of the track.


Did you find any info? My door fell off this am. Looks like one of the rear track "wheels" broke. Trying to figure out what to do.

Mar 19, 2010 | 2001 Oldsmobile Silhouette

1 Answer

The sliding door on 2006 chevy uplander will not close just started happening today the back hook looks off not like the one on the other door


Remove the rubber seal at the bottom of the door. It is ONLY there for aesthetic purposes (I asked the dealership). They said that is common and this is what they do to fix the problem.

Mar 07, 2010 | 2006 Chevrolet Uplander

2 Answers

The door chime on our 2005 Saturn Relay Van continuously goes off when you put it in gear. There are no obstructions but the automatic door switch fails to open the door sometimes and other times the chime...


I have a 2006 SV6 with the power sliding doors. The problem that I found was with the contacts on the door ( They are called plungers) the movable pins were losing connection with the fixed part The plunger is very easy to replace if you can find one. The plungers are covered with a rubber cover and is held in place with 2 plastic pins. My Pontiac dealer could not even find one in his books or even a picture of one, and claimed that he had never had anyone come with a door problem. My Chevy dealer said that it came with a wiring harness that is not needed for $154. The cure that I came up with was to take the plunger block apart (it snaps together)and replace the rusted out springs then solder 3" wires to the end of the plunger pins (they solder easy) to the tabs that go to the plug(pop out the tabs or you will melt the plastic. It took about 45 min. now the doors work like new and will never loose contact again

Oct 06, 2009 | 2005 Saturn Relay

2 Answers

My power sliding door won't close all the way, door alarm keeps r


I recently bought a 2006 Uplander LT with low miles that is very loaded and has the dual power sliding doors. I had the same problem with my drivers side door and I finally found the solution. With the door open I got down on my knees and looked into the track and followed it to where is stoped, which is just under the drivers seat left rail, and I found an expandable foam material that GM sprayed in the corner of the track and I could see where it had a mark in it where the door roller was hitting and causing the door to think that something was in the way. I had an interesting time digging this material out, and I literally had to get ALL of it out before the door would close properly, but once I removed it, I have had NO MORE PROBLEMS. I got this van cheap because it was a "Manufactures Buy Back" and I am sure that the deealer could not find the problem. Someones loss was my gain. I hope this works for you. GOOD LUCK!

Oct 06, 2009 | 2007 Chevrolet Uplander LS Minivan

5 Answers

2006 Chevy Uplander. The power sliding doors won't shut


2 possible solutions. First clean the door pin contacts(multiple spring loaded pins on door side and matching plate on body) with a scotch pad until shiny gold color again. Second the rear edge of the door should be 1mm inside the body opening when closed. If those are correct it is going to take a software download from a dealer to the door control module to fix this. Otherwise you will have to pull the psd fuse and breaker from the right side dash fuse box.

Jun 23, 2009 | 2005 Chevrolet Uplander

1 Answer

Window problems electric powered off track


Unless the motors were replaced at one time, the only bolts holding the window to the regulator are at the slides. any hardware that fell apart should be inside the bottom of the door. Panel removal is pretty simple..only hidden fastener is on the edge...small reflector has one under there.
Haynes makes a good reference for that car for about $20.

May 22, 2009 | 1996 Pontiac Grand Am

1 Answer

Driver side door window slowly fell down into the door of my 1997 dodge dakota. The glass did not break.


Power or crank? Either case the rails that hold the window on probably broke. there are slides inside the door that keep the window in place, if a slide broke, or if one of the brackets broke, the window will come down. I cant really recomend doing this yourself as ive had the same issue on other vehicles and pulling apart the door and messing with the slides and stuff in there is a real pain. Hopefully it only fell off the track and you can put it back in place. If not, if your not very handly i would suggest taking to someone.

Dec 03, 2008 | 1997 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...