Question about Cars & Trucks

Open Question

How to remove engine cowl cover from a 2012 acura TL

How do I remove the engine cowl cover from my 2012 Acura TL

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: acura tl won't start

Ignition switch problem?

Posted on Jul 07, 2008

  • 14 Answers

SOURCE: how to change spark plugs on 2005 acura tl

Hi,

you need a 6 inch extension, short 3/8 ratchet, 5/8 plug socket, 3/8 swivel "u" joint, (sold at sears) 8mm 1/4 drive socket deep well and 1/4 inch ratchet.

find the coil packs (6 total, three in each head.)
remove the two retaining nuts holding each coil pack using 1/4 8mm socket and ratchet.
twist the pack to break the sticking boot below.
pull up (be careful to not rip the boots however it may still happen but rare.)
remove coil packs, the rear is a little more difficult with the intake.
use 6" extension and u joint and ratchet to remove plugs and replace.
reverse order to assemble. Good luck, and hoped this helped.

Posted on Jan 04, 2009

  • 840 Answers

SOURCE: 04 acura tl serpentine belt diagram

there should be a belt diagram from a label either on underside of hood or on radiator support. That should help if you can do it yourself.

Posted on Jan 24, 2009

masterraphie
  • 41 Answers

SOURCE: starter replacement on acura 2000 TL 3.2

This starter can be changed without disassembling the top of the engine on the 2.5 with automatic transmission. You will need a 10mm, 14 mm, 17mm, and a 9mm wrench. First with any electrical repair disconnect the battery at the negative terminal. The starter is on the driver's side close to the firewall below the intake manifold. Remove the transmission dip stick so you don't ruin it, then look and study the starter itself. You will notice the starter drive housing with a top and bottom bolt. The top bolt is a 14mm and the bottom a 17mm, loosen both a half turn. Remove the top 14mm bolt first, then the bottom 17mm, this will allow you to pull the starter out of the bell housing. With some angling and no brackets holding the back of the starter you should be able to pull it out enough to disconnect the positive wire and 9mm nut from the soleniod. Disconnect the starter ignition small wire by pulling it off it's connector. Now just pull it out of the engine and fender void and you've got it, saving about a hundred and fifty dollars of labor. Take it to the parts house and match it up with a well made remanufactured or new starter. Reverse the proceedure, hook up the battery.

Posted on Mar 19, 2009

  • 60 Answers

SOURCE: where is plug in acura 2000 tl for check engine

The OBDII connector is located in the center console just behind the ashtray. There is a plastic cover that must be removed and you will find the connector behind the cover.

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I deactivate my car alarm, it keeps going off everyday


alarm keeps going off - Acura Forum : Acura Forums

www.acuraworld.com > ... > CL > 1st Gen CL

Jun 6, 2011 - 8 posts - ‎4 authors
Now the alarm is suddenly going off when I put the fuse back in. ... I am going to print it and keep it with my stuff in my Acura folder. ... as i connect the battery terminals and wont turn off with the remote. can you help me on this one please? ... Join Date: Sep 2012. Posts: 2. Car 1: 1998 Acura 2.3 Cl. alarm ...

1999 TL Deactivate Alarm/pull the fuse - AcuraZine Community

acurazine.com/.../problems.../1999-tl-deactivate-alarm-pull-fuse-746888/
Oct 4, 2009 - Is there a way that I can deactivate the alarm on my car. ... It is very annoying, especially when it goes off for no reason in the .... My 2001 CL black box has 4 relays, 2 grey, 2 black.removing any and ... Troubleshooting Fail: Stuck Drivers Window, xsilverhawkx, Problems & Fixes, 5, 09-28-2015 07:51 PM. 2005 TL, HFL Malfunction and Parasitic Draw
May 7, 2012
2012 TL Remote Starter
Jul 15, 2011
99 acura tl stuck in park and brake lights won't work
Aug 25, 2010
1999 Acura 3.2TL shuts down on its own
Jul 20, 2009
More results from acurazine.com

Jan 08, 2016 | 1998 Acura CL

1 Answer

Trip Meter not working.


Odometer and Trip Meter Stopped Working - AcuraZine Community

acurazine.com/forums/.../odometer-trip-meter-stopped-working-757772/
Dec 29, 2009 - The tech said he has seen the odometer & trip meter not workingbeing ... I have a 1997 TL and the same exact thing happened to me today. speedometer,trip and odometer not working
Aug 5, 2012
Cannot reset Trip A or Trip B on New 2012 MDX
Aug 1, 2012
Trip meter resets itself
Jul 25, 2012
Trip Computer Reset feature (with refuel) question..
Dec 19, 2009
More results from acurazine.com

Acura TL odometer trip meter not working Questions ... - Fixya

www.fixya.com/tags/odometer_trip_meter_not_working/cars/acura/tl

Dec 15, 2015 | 1997 Acura TL Series

1 Answer

I have an 2004 Acura tl n it hesitates to turn on


acura tl starter problem? - YouTube

? 1:09
www.youtube.com/watch?v=g8pkyOz1EaE
Oct 3, 2012 - Uploaded by MrFung1980
I has that same problem with my Acura and it was the ignitionswitch, at least ... 2004 Acura TL Review - In 3 minutes you'll be an expert on the ...

Sep 10, 2015 | Acura Cars & Trucks

1 Answer

1999 acura tl wipers not working hear motor


if you hear the motor running but they are not moving first check the nuts on the bottom of the arms if they are tight remove them the the cowl panel and look at the linkage under the panel for the rods being off if there ok check the nut on the motor

Apr 27, 2012 | 1999 Acura TL

1 Answer

96' 3.2 Acura TL dies while driving now won't


i have posted this solution before, I will give you the short version. On the steering column, under the left side of the cowling, on the opposite side directly across from where the key goes in the ignition,... there is a wire loom screwed to that end with 2 screws, remove this and clean the inside of both sides CAREFULLY, dont break anything. expensive dealer part! just scrape it lightly and wipe a little, carefully re assemble, dont bend it, dont screw it back in too tight, you cant make it go together any closer than it will. This solution solves a number of odd problems attributed to ACURA quitting , battery not charging, lights flickering turn signals not working, a lot of things, so i think everyone should do this to there ACURA, and its EASY!

Feb 07, 2012 | 1996 Acura TL Series

1 Answer

How to replace ac filter in 1996 acura tl


Your receiver dryer is replaced when the freon is removed. This requires a shop to evacuate the system - risk of death disclaimer in the manual. If your hoses are off or you have replaced the compressor you could replace it now. If you are talking about the cabin filter it should be between the heater core/evaporator and the air intake at the cowl where the wipers are. My wife's mercury sable's cabin filter was accessed from the engine compartment with a few clips and screws. It was explained well in the glove box book.

Aug 19, 2010 | 1996 Acura TL Series

1 Answer

Where is the crank shaft sensor located on a 2006 acura tl and how do i replace it? thanx


Crankshaft position sensor located on Right side of the engine. 1.remove the crankshaft pulley 2. remove the drive belt auto- tension 3. remove the upper cover and front covers from the engine 4. remove the crankshaft position sensor from the oil pump 5. Install tbe sensor in the reverse order of removal. Hope this can help .

Apr 17, 2010 | 2006 Acura TL

2 Answers

Where is plug in acura 2000 tl for check engine


The OBDII connector is located in the center console just behind the ashtray. There is a plastic cover that must be removed and you will find the connector behind the cover.

Jan 31, 2010 | 2000 Acura TL

1 Answer

Location of knock sensor 3.2 1996 acura tl


remove the intake manifold ,remove radiator ,remove radiator intake and outake housing, remove fan ,remove all belts: power steering, alternator and if you have a/c, remove harmonic balancer ,remove timing belt covers, remove timing belt remove intake housinng once you have remove all the above, your freaken engine will look naked, you can see the location of the knock sensor is locate in the engine valley

Jan 21, 2010 | 1996 Acura TL Series

2 Answers

I have 2006 Acura TL V6. How do I change the cabin air filter?


To change cabin air filter on Acura TL firs time you need to open the glove box and then remove the arm that holds the glovebox. Press the 2 sides of the glovebox to take this out like in picture bellow.
acura-tl-2004-2010-cabin-air-filter-location.jpgAcura TL 2004-2010 cabin air filter location
After do this you can see and locate the cabin air filter housing cover.
acura-tl-2004-2010-cabin-air-filter-housing-cover.jpgAcura TL 2004-2010 cabin air filter housing cover
Push the 2 tabs from the filter frame to unhooking from the housing cover. Take the frame out and replace the old cabin air filter with the new one with the air flow indicating arrow pointing down.

acura-tl-2004-2010-reinstal-the-air-cabin-filter.jpgAcura TL 2004-2010 reinstal the air cabin filter

Nov 26, 2008 | 2006 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...