Question about 1999 Lexus ES 300

Open Question

My lexus es300 won't start, no click click noise. i lefted at the parking lot and came back 2 hours later and it start."

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 8 Answers

SOURCE: '98 Lexus ES300 Won't Start--But Has New Battery!

If your is exhibiting the same signs as a dead battery it really sounds like your alternator is bad. If you are handy, you can remove the alternator and take it to an autoparts store like autozone and they will test it for you. This is not a hard job to do, usually 2 electrical connections, 3-5 mounting bolts and you have to pop the belt off. Just reverse it to install a new one. Good luck! - Nick

Posted on Nov 03, 2008

  • 1 Answer

SOURCE: how to change lexus es300 2002 cabin air filter

I just changed the cabin filter of my ES300. I found the instructions on the manual, under airconditioning and audio. It's pretty easy to do. I bought the filter from Kragen's for $21.95.

Posted on Mar 27, 2009

  • 18 Answers

SOURCE: 2000 Lexus ES300 - 45K

Are you sure this is a rattle or is it more of a creaking noise? I have a 2000 ES300 and had an issue when I would go over speed bumps and the noise would drive me nuts! However replacing the bushing in the top of the strut mount is expensive due to the labor involved.. Replacement of the strut or the bushing isn't necessary. Just open the hood, locate the strut housing and you ll be able to see the black rubber bushing in the middle. Obtain a can of Heavy Duty silicone aerosol spray and attach a straw to the spray tip. Using a flathead screwdriver wedge the screwdriver between the top of the bushing and the metal pushing the screwdriver all the way to the edge of the metal underneath the roof of the metal housing. Then pry the edge of the bushing away from the metal housing so that the top of the edge of the bushing exposed and stick the straw end of the silicone into the spot and spray generously. Only slight bushing movement will be obtained as the bushing is pretty stiff but it will be enough. Work your way around using this technique until you get the spray fully around the bushing 360 degrees getting it into the area between the edge of the bushing and the metal. Then spray the silicone onto the top of the bushing filling it all the way up until it spills over the metal. After it drains down, repeat again making sure you fill it above the rim of the bushing so it seeps into the area between the bushing and he metal housing (or frame) because this is where the rubbing is taking place that is creating that awful noise. Repeat on the other side and your done. The main goal is to get the silicone into the area between the metal and the bushing along the edge. This happens to be the way I was able to do it. This totally solved my problem and now the car is so quiet there aren't any knocking, creaking or rattling noises. This was a hard solution to explain without visuals, hope you can follow. This will work for sure. The Heavy Duty Silicone spray I used was manufactured by CRC and I bought it from Walmart.

Posted on Jul 22, 2009

  • 6 Answers

SOURCE: amplifier location 1993 lexus es300

My Son has a 95 es300, the amp for it is located under the front passenger seat. The easiest way to access it is to remove the 4 bolts holding the seat down, and remove the seat. Takes about 5 minutes

Posted on Jul 24, 2009

GARYca
  • 672 Answers

SOURCE: LEXUS es300 oil light stays on oil level full

Check oil level sensor, replace if necessary. also, does your engine knock or make a tapping sound?

Posted on Mar 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My lexus gx470 failed to start last week after driving fine to location. There was no response to turning key. All dash and controls worked and activated but no cranking of motor, no clicking, just...


First place I would check are the battery terminals. Remove them and clean the posts, re-attach and tighten them. You can buy a tool for cleaning the posts at your local auto store.

Sep 03, 2013 | Lexus GX 470 Cars & Trucks

1 Answer

2003 lexus es300 won't start... radio lights and windows work. Tried a jump start, still doesnt work...


Are you saying the engine cranks but won't start, or the engine won't crank ?
If the engine does not crank, you would check for voltage at the starter, the neutral safety switch, and the key switch as well as the ground connections.

Sep 18, 2012 | 2003 Lexus ES 300

1 Answer

Problem with drivers door power window. 1992 lexus es 300 motors runs when button is pushed, window does nothing how do i get the window back on its track?


1999 Lexus ES300. The front power windows are opening on their own. I park, turn off engine, lock the doors and within a half hour the front windows have opened completely. Any thoughts on this problem?

Nov 23, 2010 | 1992 Lexus Es 300

1 Answer

Good morning, my 1994 Lexus ES300 driver's side wheel don't turn when putting in drive or reverse, but the passenger side dose. when replacing one of the crank sensor on back of tranny it started to work...


THERE IS NOTHING WRONG WITH YOUR CAR THATS THE WAY THAT IT WORKS THE RIGHT WHEEL IS THE DRIVE WHEEL IS YOU GOT STUCK IN THE MUD OR ICE WITH WITH THE DRIVE WHEEL THEN THE LEFT WHEEL WOULD DRIVE THE WHEEL THAT IS COULD AND OPEN DIFFERENTAL IF YOU HAD A POSI DIFFERENTAL THEN BOTH WHEELS WOULD TURN AT THE SAME TIME (MOVIE MY COUSIN VINNIE)

Oct 20, 2010 | 1995 Lexus ES 300

1 Answer

Hi. I have a 1996 Lexus ES300. Last night I had it in park with the hazards on. When I got back in the car and tried to start it, there was what seemed like an electric short and the car wouldn't start....


Check the connections at the battery. Sounds like there will be corrosion. Take off the terminals and clean them with baking soda and water and put them back on tightly.

Sep 04, 2009 | 1996 Lexus ES 300

Not finding what you are looking for?
1999 Lexus ES 300 Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

881 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...