Question about Cars & Trucks

Open Question

Search Fixya...bleed fuel line on 431 massey ferguson

Get air out of fuel system

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: massey ferguson 3655

sounds like the seals are gone on the 4wd shaft, it takes oil pressure to keep the 4wd off, but if the seals are worn the all passes through and the 4wd will not dissingage, you will need a experianced michanic

Posted on Apr 07, 2009

  • 880 Answers

SOURCE: 3090 massey ferguson,I have to bleed up the hyd

Clean it very well and watch to see where the leak is. It is obviously leaking and thus sucking air into the system. Find the leak and repair it.

Posted on Nov 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the oil filler on a Massey ferguson168. I need to top up the oil


images, video and text

https://www.google.ca/search?q=massey+ferguson+168+manual&tbm=isch&source=lnms&sa=X&ved=0ahUKEwi1md-636zTAhVD5mMKHUWLB_8Q_AUICCgB&biw=1366&bih=659&dpr=1

this is your service manual. I haven't checked it..

http://vieux.tracteurs.free.fr/pdf/MF_135_148_SERVICE_MANUAL_p001_100.pdf

you can get an owners manual here

Massey Ferguson 168 188 178 TRACTOR MANUAL INSTRUCTION Trekker Handleiding...

Apr 18, 2017 | Cars & Trucks

1 Answer

How do you bleed a diesel pump jeep Cherokee turbo diesel 3.1 5 cylinder 2001


we dont have this engine here, USA.
but i have the WG jeep book,
starting page 12 , chapter 14


FUEL INJECTION PUMP BLEEDING
(1) If the fuel injection pump has been replaced,
air should be bled at the overflow valve before
attempting to start engine.
(a) Loosen the overflow valve (Fig. 18) at the
rear of the injection pump.
(b) Place a towel below the valve.
WARNING: WHEN CRANKING THE ENGINE TO
BLEED AIR FROM THE INJECTION PUMP, THE
ENGINE MAY START. PLACE THE TRANSMISSION
IN NEUTRAL OR PARK AND SET PARKING BRAKE
BEFORE ENGAGING THE STARTER MOTOR.
CAUTION: Do not engage the starter motor for
more than 30 seconds at a time. Allow 2 minutes
between cranking intervals.
(2) Crank the engine for 30 seconds at a time to
allow air trapped in the injection pump to vent out
the fuel injector drain tubes. Continue this procedure
until the engine starts. Observe the previous WARNING
and CAUTION.
(3) Tighten overflow valve.
HIGH-PRESSURE FUEL LINE BLEEDING
WARNING: THE INJECTION PUMP SUPPLIES HIGH-
-PRESSURE FUEL OF APPROXIMATELY 45,000 KPA
(6,526 PSI) TO EACH INDIVIDUAL INJECTOR
THROUGH THE HIGH-PRESSURE LINES. FUEL
UNDER THIS AMOUNT OF PRESSURE CAN PENETRATE
THE SKIN AND CAUSE PERSONAL INJURY.
WEAR SAFETY GOGGLES AND ADEQUATE PROTECTIVE
CLOTHING AND AVOID CONTACT WITH
FUEL SPRAY WHEN BLEEDING HIGH-PRESSURE
FUEL LINES.
WARNING: DO NOT BLEED AIR FROM THE FUEL
SYSTEM OF A HOT ENGINE. DO NOT ALLOW FUEL
TO SPRAY ONTO THE EXHAUST MANIFOLD WHEN
BLEEDING AIR FROM THE FUEL SYSTEM.
Bleed air from one injector at time.
(1) Loosen the high-pressure fuel line fitting at
the injector (Fig. 19).
(2) Crank the engine until all air has been bled
from the line. Do not operate the starter motor
for longer than 30 seconds. Wait 2 minutes
between cranking intervals.
(3) Start the engine and bleed one injector at a
time until the engine runs smoothly.

end quote.
pump timing is on next page
or tank filter line priming before. above.

Mar 22, 2016 | Jeep Cars & Trucks

1 Answer

Fuel gauge wiring diagram


how to wire fuel guage on massey ferguson 165

Jan 11, 2014 | 1998 Dodge Neon

1 Answer

My Pontiac Sunbird 96 ran out of fuel. I need to know how to bleed the system of air. Where is the bleeding line??


you shouldn't need to bleed the air out-if you filled back up with fuel and its not starting you probably have a bad fuel pump-sorry- to bleed the fuel line look where the fuel line connects to the fuel injector rail-on the rail there should be a thing that looks like a tire inflator valve-turn the key on and push in the center of the valve and fuel should come out of it -if not then for sure pump isn't working- cheers Denny

Nov 27, 2013 | Cars & Trucks

1 Answer

3090 massey ferguson,I have to bleed up the hyd clutch line,often, what can I look for to fix it?


Clean it very well and watch to see where the leak is. It is obviously leaking and thus sucking air into the system. Find the leak and repair it.

Nov 27, 2010 | 1992 Ford F150 SuperCab

1 Answer

2000 EXCURSION has been sitting for two years out fuel and it wont start


more than likely there's condensation and air built up in the system , youll need to crack the fuel lines open and bleed the system, just as if you were bleeding brakes, air in the fuel lines is a very common problem on diesels

Apr 06, 2010 | 2000 Ford Excursion

2 Answers

What years is my tractor?


google Massey ferguson the model number will be on the motor

Aug 30, 2009 | 2004 Jeep Liberty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...