Question about BMW 325

Open Question

Diagram e90 Radiator hose

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi my bmw e90 320i 2010 model is consuming coolant too much and there are no leaks, what could be the problem


leaks at the EGR unit , inside at the heater unit , welsh plugs , cracked radiator tank, hoses , corroded cover behind water pump , water pump seal
check oil and if grey , timing cover corroded
have the system pressure tested to find the leak

May 04, 2017 | BMW Cars & Trucks

1 Answer

Installing radiator


1 - Upper seal board
2 - Radiator reservoir hose
3 - Radiator reservoir
4 - Fan motor connector
5 - Cooling fan assembly
6 - Condenser fan assembly
7 - Oil cooler hose
8 - Radiator hose
9 - Radiator bracket
10 - Radiator

23901254-cld1w30nam4pvdfzfn10ykwq-4-0.jpg Car Parts Diagram

Mar 24, 2014 | 1998 Mazda Millenia

1 Answer

Diagram of which hose to disconnect to flush radiator


both top and bottom hoses of the radiator are disconnected to flush out the radiator. I would suggest that you have this done professionally by a radiator shop as doing it yourself is not really effective as the flow rate has to be checked to monitor flow improvement to check for blocked cores. Blocked cores will not flush clean.

Nov 16, 2013 | 2000 Oldsmobile Bravada

2 Answers

Engine Diagrams


Hello. Here a non-photo diagram. Hope this helps!!!

The thermostat is located on the side of the water pump, the water pump is located just above the a/c compressor, the thermostat is fed coolant from the radiators lower radiator hose.
Thermostat :
1. drain coolant and tighten drain plug ( easier method : remove radiator cap, get big drain pan, place drain pan under lower radiator hose to radiator connection, remove clamp, slowly remove hose, allow coolant to drain into pan, now is a good time to remove radiator hose and clamp from thermostat housing )
2. remove thermostat cover / cap ( easiest to get at this when front of car is supported by jack stands and right hand side lower cover is removed ).
3. thermostat cap is held on by 3 bolts / remove thermostat.

You will notice that the thermostat's air bleed hole is pointing up and lines up with notch in water pump housing,,

ATTENTION :failure to install new thermostat in the correct location will cause engine to overheat.

1. install new thermostat to water pump, make sure air bleed hole lines up with notch, install and tighten bolts, install a new lower radiator hose, fill cooling system.

thermostat # 17670-77E00
lower radiator hose #17854-65G20
hose clamp #09401-36403
upper radiator hose # 17852-65G20

Suzuki factory manual

Oct 21, 2013 | Cars & Trucks

1 Answer

Where cN I FIND A DIAGRAM FOR THE COOLANT SYSTEM ON A 1987 FORD 460


Many auto parts stores carry maintenance and service manuals for the 1987 Ford vehicles. Don't recall seeing a "diagram" of a "cooling system" though. There isn't much to it...a radiator, outlet hose to engine block, inlet hose from engine block to radiator with a thermostat installed. Problems...thermostat can stick, radiator can corrode up, leak in radiator can occur, engine water jacket can rust up. Routine maintenance and antifreeze solution can help keep the radiator working fine.

Jun 03, 2009 | 1987 Ford Econoline

1 Answer

Need diagram of engine for 2002 cavalier z24


Its the upper radiator hose should be located topside beside the engine oil dipstick,any smaller hoses you have running into the radiator are heater hoses, the lower radiator hose is where coolant enters from radiator into engine and is pumped up with water pump thru water jackets in engine and eventually returns thru the upper radiator hose which is most prone to damage due to splitting and cracking, I hope this helped.

Apr 22, 2009 | 2002 Chevrolet Cavalier Coupe

1 Answer

Wiring diagram for e90 window lifter switch


Follow the link. http://www.bmw-planet.com/diagrams/release/en/e90/index.htm

Sub-headings, Complete Vehicle, Body, Wipe/Wash System. From there you can find the specific schematic you are looking for.

You may be prompted to install Adobe's SMG viewer to see the pictures. Install it!!!

Apr 01, 2009 | 1988 GMC Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...