Question about 1995 Ford Taurus

1 Answer

How do I disable the window lock? Seems to be stuck...

I tried pressing the window lock switch to disable it, but I still can't control the windows in any of the other doors. I can do without the window lock, so is there something I can just disconnect - in the door panel, maybe?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 112 Answers

Should have a connector under door panel that the button connects too. most likely it is a computer lock so removing the connector wont solve your locked windows problem.

Posted on Jul 14, 2013

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: 92 F150 power window and locks

try taking apart and cleanig all contacts first. make sure you are getting power to switch. Sounds more switches are going bad. They usually last about 5 to 7 years before they start going out.

Posted on Jun 11, 2008

sicaudio
  • 96 Answers

SOURCE: Driver's side door power locks are stuck; door stuck shut.

sounds like the rods are disconnected the clips hold the rods in place the latching mechanism holds the handle in place as well did you replace the speakers or did a shop? if a shop did then they caused this if you did then you may have caused this either way untill you reattach the rods none of it will work. you will have to manually open the door at the latch from inside teh door behind the panel.

Posted on Jul 19, 2008

  • 1 Answer

SOURCE: Front passenger window does not work

sounds like bad regulator, pull your door panel apart and it is the part that goes onto the motor. long bow shaped thing with cable attached. pop out rivets, (I think 3 rivets) and on the upper side there are 2 nuts that have to be removed. then wiggle it around till you can get it out of the biggest hole in door. Good Luck.

Posted on Oct 25, 2008

  • 58 Answers

SOURCE: Drivers electric window stuck in down position

actually you have thought of all but the prob. The track has jumped, making the motor not move the window. Sometimes you can gently slide the window up by hand and then the motor will catch the track and finish rolling the window up

Posted on Jul 05, 2009

cobra777
  • 80 Answers

SOURCE: how to remove drivers door panel on 1999 ford escort

Remove the front door pull cup screw 1152a96.gif

Remove the screw cap and the screw from the inside door handle and slide the handle rearward to disengage the hook from the inner sheet metal.

  • Disconnect the inside door handle from the front door latch remote control link
37470b2.gif

Remove the two-piece pushpins from the front door trim panel (23942).
2a1605a.gif

NOTE: Use a commonly available spring loaded trim pad removing tool with a long thin nose to prevent damage to the door trim panel.
Release the seven front door trim panel bullet nose fasteners and push inboard, then upward to release the front door trim panel.
  • If equipped, disconnect the master window regulator control switch electrical connector
cc0d2af.gif

Remove the retainer from the master window regulator control switch panel.
  1. Pull outward on the cup retainer tabs and remove.
  1. Remove the master window regulator control switch electrical connector from the retainer
ab8ff6c.gif

Posted on Jun 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Window master switch seems like the window lock is stuck


Seems verry likly that the lock switch has stuck in the lock position and will most likly need to be replaced. Unless you are able to remove and spray with a contact cleaner

Nov 26, 2012 | 2004 Buick LeSabre

1 Answer

None of my electric windows work, they are all stuck open and will not go up


Are you sure the window lock switch is in the "operating" position.The drivers window problem is usually a broken wire or a worn out window motor but the other windows can be made non-operational if the window lock switch is in the wrong position...if it is set correctly it may be the Body control module (in the dash behind the radio).

Sep 21, 2012 | 1995 Ford Explorer

2 Answers

Hyundai ix35 2012 window lock stuck. passenger window half down and cant get it to move up or down


Before you replace anything, inspect the connector pins in both the driver's door switch and the passenger door switch. If you don't find any problem with these connector pins, replace the driver's door control switch.

Sep 12, 2012 | 2011 Hyundai ix35 2.0

1 Answer

2001 Mercury Villager keyless remote is malfunctioning


Keyless Entry
The keyless entry system consists of the following:
  • smart entry control(SEC)/timer module
  • keyless entry remote transmitters
  • power door lock actuators
  • body side door power door lock actuator
  • liftgate actuator
  • power door lock switches
  • door ajar switches
  • Principles of Operation
    All doors can be locked at once by turning the door key lock switch to the locked position. An individual door can be unlocked by moving the door key lock switch to the unlocked position and turning it again within five seconds; all the doors (including the liftgate) will unlock.
    The smart lock system is designed to keep the driver from locking his keys in the car. It will lock and then unlock all the doors if the smart entry control(SEC)/timer module detects the following conditions:
    • The ignition key still in the ignition.
    • A front door is open.
    • A door lock switch has been pushed to the lock position.
    The panic feature has a duration of 30 seconds from the last time the PANIC button is pressed. When locking the doors from the remote transmitter, the horn chirp/lamp flash feature can be disabled or enabled by holding the LOCK and UNLOCK buttons for two seconds. The hazards will flash three times to confirm that the feature has be enabled or disabled.
The control module probably see's an input that shouldn't be there . lock Switch , door ajar etc... Don't think it has anything to do with the remote . Some part stores have a tester to see if signal from the remote is working . Or the dealer ! Take it an see if your remote is sending a signal without you pressing any buttons .
If it is you need a new one .

May 19, 2017 | Cars & Trucks

1 Answer

Why won't 2003 pontiac grand prix. shifter come out of park?


Shift - interlock system problem .
Automatic Transmission Shift Lock Control System
The automatic transmission shift lock control system is a safety device that prevents an inadvertent shift out of PARK when the engine is running. The driver must press the brake pedal before moving the shift lever out of PARK position. The system consists of the following components:
• The automatic transmission shift lock control solenoid
• The automatic transmission park lock solenoid
• The automatic transmission shift lock control switch
• The transmission range switch
With the ignition in the ON position, battery voltage is supplied to the automatic transmission shift lock control switch. The circuit continues through the normally-closed switch to the automatic transmission shift lock control solenoid. The transmission range switch provides a path to ground for the automatic transmission shift lock control solenoid in the PARK position. With the automatic transmission shift lock control solenoid energized the shift lever is mechanically locked in the PARK position. When the driver presses the brake pedal, the contacts in the automatic transmission shift lock control switch open, de-energizing the automatic transmission shift lock control solenoid. This allows the shift lever to move from the PARK position. When the shift lever is out of the PARK position the controlled ground contacts in the transmission range switch open. This prevents the automatic transmission shift lock solenoid from energizing when the vehicle is out of the PARK position.

Jul 04, 2017 | Pontiac Grand Prix Cars & Trucks

5 Answers

Have a 2011 Hyundai Sonata that is getting stuck in Park and I have to press the shift lock release to put in D everytime


No, that's wrong. The setup on the Sonata doesn't normally require messing with the shift lock release at all. I had the same problem tonight for the first time after owning the car for a year and a half, that's why I looked up this issue.

Jun 19, 2011 | Hyundai Sonata Cars & Trucks

2 Answers

All controls through the drivers side front control dont work. How can I get the window closed ?


If NONE of the windows work, you will have to scan your Body Control Module (BCM) for fault codes to determine what is causing the problem because your windows are controlled by the BCM.

If the driver's window works, but the others don't, check your window "lockout" switch on the drivers master switch to make sure you don't have the other windows locked out. Simply push the switch and try your windows again. If this does not work to get them working, then you will have to scan your BCM as above.

Jun 14, 2011 | 2008 Dodge Grand Caravan

1 Answer

Both passenger windows wont roll down, the power locks work but not the windows. How can this be fixed?


Disable the window lock switch. Unless you can't roll them down from the driver's switch either: in that case you're probably dealing with a faulty master control switch in the driver's door - all the other switches for the windows and locks go through it.

Jun 01, 2011 | 1995 Honda Odyssey

1 Answer

My power windows stopped working


The power window system operates electric motors, mounted in the doors, which lower and raise the windows. The system consist of the conrol switches, the motors, regulators, glas mechanism and associated wirring.
Perform checks
1. Check fuses for proper operations, blown fuse can cause windows to stop operating.
2.Check with voltage meter your power windo switches.
3.Each motor is equiped with an internal circuit breaker, this prevents one stuck window from disabling the whole system.
4.The power windows will only operate when ignition key is ON. In addition, manu models have a window lock out switch at the master control switch which, when activated, disables the switches at the passenger's windows. Always check these items before troubleshooting a window problem
5. These procedures are general in nature, so if you can;t find the problem using them, take vehicle to the dealer service department or other properly equipped repair facility.
6. If windows wont operate always check the fuses and circuit breaker first.

Feb 21, 2010 | 2005 Ford F 250 Super Duty

4 Answers

Problems with door locks and window


page 3-39 in owners manual. automatic door locks. do the steps and change too lock 2. this worked on my 2006 colorado crew cab. good luck

Apr 05, 2009 | 2005 Chevrolet Colorado

Not finding what you are looking for?
1995 Ford Taurus Logo

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...