Question about Cars & Trucks

Open Question

Remove Rear Seat from 2013 acura ilx - Cars & Trucks

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
mas66
  • 104 Answers

SOURCE: removal of the driver seat of my 1988 acura legend

I'm not certain of the layout of the bolts on your particular model, but there should be 4 bolts, one at each end of the seat tracks (the things the seat slides back and forth on), attaching the tracks to the floor. You may need to slide the seat back to access the front bolts, and forward again to get the back ones. Tilt the seat back right forward to allow you to get the seat out the door. If the seat has electric controls there will be some plugs to disconnect under it. If there are any yellow coloured plugs, DO NOT disconnect them without disconnecting the negative terminal off the battery and waiting for 5 minutes. The yellow plug is an airbag system plug, and if the battery is not disconnected the airbags could potentially deploy. Make sure the battery remains disconnected for the entire time that the yellow plug is disconnected, and reconnect the battery AFTER the yellow plug. If there isn't a yellow plug, don't worry.

Hope this helps.

Posted on Oct 26, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Parking lot flooded now car wont start


replace the ECM with a known good unit
run it and read the fault codes for any other sensor problems
check for water in the fuel tank, water in the sump

Nov 22, 2015 | 2013 Acura ILX

1 Answer

Car was flooded now will not start


Hi Phillip:
Flooded as in way too much gas, or under 4 feet of water?Maybe you could provide some details as to the circumstances that led you to conclude that it was flooded.
Thanks
Reply as comment to this post.

Nov 22, 2015 | 2013 Acura ILX

1 Answer

How to remove bolt covers for front seats on 01 ford taurus


Identify and Remove bolt covers - Instructables

https://www.instructables.com/...remove...seats/.../Identify-and-... InstructablesNext slide both seat forward as far as they can go, and lean the back of the seat forward as well. Find the two bolt covers and remove them as well.

How To Remove Front & Rear Passenger Seats 2006-11 ...

? 15:30
www.youtube.com/watch?v=qCLx3Ak2BvY
Jul 31, 2013 - Uploaded by TheTongMan Here is a tutorial on how to remove the front passenger seat and the rear ... what pieces of equipment are you ...

Oct 21, 2015 | Ford Cars & Trucks

1 Answer

How do i fix my car


Which bit? There's LOADS of bits that can go wrong....

Jul 24, 2014 | 2015 Acura ILX

1 Answer

Where is the fuel pump?


FUEL PUMP IS IN GAS TANK THE 1.8 ENGINES YOU CAN ACCESS FUEL PUMP BY REMOVING THE REAR SEAT AND THE ACCESS PANEL.THE 3.5 ENGINE YOU CAN REMOVE REAR SEAT CUSHION AND ACCESS PANEL FROM FLOOR TO REMOVE FUEL PUMP.THE 2.5 AND 3.2 ENGINE REMOVE FUEL PUMP FROM TRUNK FLOOR.AND THE 2.3 AND 3.0 ENGINES FUEL TANK HAS BE LOWER BEFORE YOU CAN REMOVE FUEL PUMP.

May 27, 2010 | 1998 Acura TL

2 Answers

Trying to remove back seat in acura RL


THIS IS REAL SIMPLE I HAVE DONE THE SAME THING TO INSTALL THE IPOD INTERFACE MANY TIMES.. STEP 1 MOVE BOTH FRONT SEATS ALL THE WAY UP TO ALLOW U TO HAVE SPACE STEP 2 LOOK UNDER THE SEATS AT THE BASE AND U WILL SEE 2 BUTTON STYLE CLIPPS 1 ON EACH SIDE OF THE SEAT, PLACE YOUR FINGERS ON THE SIDE OF THE BUTTON AND PULL IT TOWARDS YOU,AND AT THE SAME TIME LIFT THE SEAT.. REPEAT THAT STEP FOR BOTH SIDES AND THE SEAT FLIPS RIGHT OUT

Feb 09, 2010 | 2005 Acura RL

1 Answer

How do i get the rear seat bottom out


you will either have two bolts on the front of the seat going into the floor or have two on the rear of the seat in which you will have to remove the upper portion of the seat to get to. this also has two bolts that hold it in.

Aug 26, 2009 | 1996 Acura TL Series

1 Answer

Driver seat removal


there are four bolts (2 in ft ,2 in rear)that bolt seat to floor. you will need slide seat all the way forward to access rear bolts, they may ,if they are still there, be under plastic beauty caps. do the same for ft bolts. once loose tillt seat assy backwards and unplug any wiring connectors on bottom f seat

Oct 26, 2008 | 1988 Acura Legend

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...