Question about Cars & Trucks

1 Answer

Booster brake failure nissan pathfinder - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 1 Answer

Yes

Posted on Jul 14, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 41 Answers

SOURCE: hand brake nissan pathfinder

If you lift the hand brake you should find an adjustment nut (I think it is 10MM). Tighten that and you should be good to go. Be careful, it doesn't take much to adjust - turn gradually/slowly.

i hope i was able to help you with your problem! tc!

Posted on Oct 12, 2008

  • 165 Answers

SOURCE: Adjust rear brakes 1995 Nissan Pathfinder 4WD

if they are disk brakes, they are not adjustable. if they are drums they should auto adjust. if they are not, then there is a problem that you have to pull the tire, then the drum, to diagnose it. you may have to disassemble the brake shoes and springs, and clean and lube the self adjusters

Posted on Dec 30, 2009

SOURCE: brakes dont work, changed master cylinder,

check for air in the lines ..bleed the air out in this tire order LR, RF, RR, LF, i hope u bleed the master cylinder ..che if the bacuum to the booster is good

Posted on Apr 24, 2010

  • 143 Answers

SOURCE: head gasket failure on Nissan Pathfinder

the head needs to be checked by a reconditioner if all is good a complete cooling system check needs to be carried out. Coolant type, mix and flow all need to be considered. all leaks need to be fixed, i would renew all cooling system componets. Thermostat, all the way up to the heater core(inside the vehicle used for the internal heating of the vehicle) at the extreme. This repair job may be costly, ONCE more info pls

Posted on Jun 13, 2010

  • 341 Answers

SOURCE: nissan d22 navara 06 no vacum to brake booster??

if you are sure you have no vacum at your brake booster it could possibly mean either you have a leaking vacum pipe or if you have a pump fitted then the fault is that. If you are not sure if you have vacum at the booster end than it could also be a booster fault. Check the pipe first at the booster end (engine running)

Posted on May 26, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Return question on brake problem-if master cyclinder has leak at booster would that cause vacumn leak,idle problem when applying brakes


Very likely yes. There is a seal at front of booster which may fail if brake fluid soaks it. Only leaks when you apply brakes, and this will affect idle.

Jun 04, 2015 | 1991 Nissan Pathfinder

2 Answers

Apply brakes goes to floor engine idle chokes down let off goes back to normal,is thia avacumn leak problem,where to start to find?


Easy peasy ........ air will be fed to master brake cylinder from either carburetor/throttle assembly via a flexible pipe.

Find pipe and take it in turns to spray either end or length with WD40.

When engine rate increases, you've found the leak!!

Jun 04, 2015 | 1991 Nissan Pathfinder

1 Answer

Braking is hard


Sounds like a lack of vac from the engine.
Did you check the hose to the intake to see if it is blocked ?

Sep 08, 2012 | 1995 Nissan Pathfinder

1 Answer

91 Nissan Pathfinder losing brake fluid & has no


If the fluid level is going down then you do have a leak.

Jun 27, 2012 | Cars & Trucks

1 Answer

Pedal brakes is too hard to stop


Loss of power assist ? Leaking vac hose or booster ?

Jun 26, 2012 | 1994 Nissan Pathfinder

1 Answer

I need instrustion to install a brake switch


It is a generic Nissan brake light switch replacement procedure... the brake light switch on a Nissan Altima i.e. controls the illumination of the brake lights. Without the switch, the lights would not go on. The switch has no service life, so when it goes, it usually happens suddenly. New brake light switches can be obtained from Nissan or from a Nissan dealership.

1. Remove the cotter pin from the pin bolt that holds the brake pedal to the brake booster with a pair of pliers. There is a small cotter pin running through the brake pedal to brake booster connection. You need to pull this cotter pin out to remove the larger pin that holds the brake pedal to the brake booster.
2. Slide the pin out of the brake booster mounting bracket.
3. Pull up on the brake pedal to slide it out of the brake booster mounting bracket.
4. Remove the bolts holding the brake switch to the firewall using a socket wrench.
5. Remove the electrical connector on the brake switch by pulling it straight off the switch.
6. Slide the switch off the firewall.
7. Install the new switch. Installation is the reverse of removal. Make sure that you replace the cotter pin in the brake booster to brake pedal connection. The cotter pin prevents the retaining pin in the brake booster mounting bracket from coming off.

Hope helps (remember to rate this answer).

Mar 31, 2011 | Nissan Altima Cars & Trucks

1 Answer

My car 93 pathfinder starts well and runs smooth but every time I step on the brakes the Idling goes down and the engine stops


check vacuum booster for a leak, disconnect it from the intake plug the hose and try it again

Apr 29, 2010 | 1993 Nissan Pathfinder

1 Answer

Fading brake pedal when engine running , have replace front pads, master cylinder and bleed entire system, pedal is firm with engine off but once started pedal fades to floor


Hold pedal down firmly with vehicle not running. Now start it up still holding pedal down firmly. Does it go to the floor when engine is started? If so I would look at the brake booster. It may be defective.

Nov 21, 2009 | 1991 Nissan Pathfinder

2 Answers

Car dies when I push the break


brake disk alignment is not proper which is getting tight each and every time when u push so put some lubricant to free the brakes and the alignments

Jul 28, 2008 | 1995 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...