Question about Cars & Trucks

1 Answer

98 chevy suburban wont start, replaced fuel filter n now #8 fuse under dash keeps blowing

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 21,873 Answers

Do you know what circuit the fuse protects ? It should be in your owners manual.

Posted on Jul 13, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ignition fuel starter fuse keeps blowing and it won't start

The earlier "fix" suggests a possible wiring problem -
more specifically, a historic issue with Chrysler products is the ground connections, which are typically insufficient.
Check both the battery to engine and then the engine to frame (firewall). If either are worn or frayed replace them. Even if it looks fine I would still replace the motor to frame cable with a heavy duty grounding strap available at most parts stores. ( doesn't have to be a specific cable - can even be homemade, just make sure it is heavier than the original and is connected to a good, bare area.)

Posted on Oct 28, 2008

  • 341 Answers

SOURCE: 98 chevy camaro wont start

check fuel pressure regulator

Posted on Dec 06, 2008

  • 1118 Answers

SOURCE: 98 chevy suburban engine turns over but wont start.

did you do a fuel pressure test? or did you just push in on the valve on the fuel rail and gas came out? if thats all you did, that will not tell you anything.you GOT to do a pressure test. just 3 to 5 pounds under and it will not run. fuel injection is fussey. you can rent a pressure gage at most major parts stores. they can even tell you what the pressure shoud be. just because you can hear the pump run, dosent mean its pumping, or at least the right pressure. did you also chk.for spark? need to do that to. still need air, fuel, and fire to make them run. good luck.

Posted on Jan 14, 2009

  • 14036 Answers

SOURCE: the ECM fuse keeps blowing out

check the wiring to fuel tank something shorting. replace wires to fuel tank.

Posted on Apr 09, 2009

  • 85 Answers

SOURCE: truck wont start keeps blowing the ecm batt fuse

You have a short (bear wire) somewhere. Trace the wire and find it.
Have a great evening

Posted on May 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

K2500 Suburban with. 6.5 Diesel and the instrument fuse keeps blowing when I turn the key to the on position. When I disconnected the glow plug relay the fuse did not blow. Also while running with th


did u replace the relay just a curious question, sometimes they have rust and water in the inside of the relay but my guess would be that you have a bare wire rubbing somewhere, causing the fuse to blow, anything significant has happened before that issue?

Nov 25, 2013 | 1997 Chevrolet Suburban

1 Answer

The 20 amp stop/haz fuse keeps blowing. I put a new one in but after using the brakes 18 to 24 times the fuse is blown. I noticed that the fus/circuit breaker box under the hood does not have a brake lamp...


Not easy to diagnose. Most probable cause is an intermittent short in the power wiring between the hazard module under the dash and the brake and center stop lights, or a problem with either that module or brake light switch on the pedal. I would start by inspecting the socket wiring and interior of the sockets on the rear light modules.

Jul 13, 2017 | 1997 Chevrolet Suburban

1 Answer

98 chevy sub. k2500 to accelerate poorly


Likely a clogged fuel filter or defective fuel pump. Confirm correct fuel pressure with a gauge. If the pressure is low, remove the fuel filter and check for obstruction. If it's hard to blow through it, replace it with a new filter. Then retest the fuel pressure. If pressure is still low, then it's likely that you have a defective fuel pump.

Sep 02, 2012 | 1998 Chevrolet Suburban

1 Answer

No power to fuel relay 1994 chevy pickup k1500


just put in new fuel pump, filter and now who fuel relays. I keep blowing fuses under my dash/ took the meter to it and im getting power in the left side of the fuse prong but on the right side its grounding its self out. any ideas on what it could be?

May 01, 2012 | 1994 Chevrolet K1500

1 Answer

Keep blowing a fuse under hood in 98 jeep wrangler that will stop me from getting fuel and replaced the fuel pump after i got the problem, and it still keeps doin it. would run for a min or two then fuse...


Measure resistance between the fuse box and the fuel pump. You most likely have high resistance in the wire. Also check between the fuse box and body ground for resistance

Jul 02, 2010 | 1998 Jeep Wrangler

1 Answer

1997 chevy s10 blazerdash wont light up when key


the dash sound's like a fuse, check the fuse box under the hood and in the door jamb on the side of the dash, also check your fuel filter and fuel pump, im betting on the pump because i have a 2001 chevy blazer that has had two replaced and it has 233000km on it!

Jun 04, 2010 | 1997 Chevrolet Blazer

2 Answers

Where are the fuse boxes on 98 chevy z71. it is a vortec i know of 2 boxes one on the driver side under the hood and the driver side of dash i was just wondering if there was any more


The fuse panel cover is located at the drivers side of the instrument panel. Remove the panel to access the fuses-1996-98 models shown



b319ef9.gif

Apr 23, 2010 | 1998 Chevrolet K1500

1 Answer

98 Chevy Suburban. Turns over great, runs for a second then dies. If i....keep....trying it does the same and then eventually stays running. I hear the fuel pump and the fuel filter has been replaced. Any...


If you can, check the fuel pump pressure. The Votec engines are real sensitive to the right amount fuel pressure. If the pump is getting weak, it will cause the symptoms you are describing.

Feb 17, 2010 | 1998 GMC Suburban

1 Answer

1994 Chevy S-10 Blazer 4-door fuel pump replaced but not working


you should have 2 ecm fuses under the dash in the fuse box check these one of them is probably blown I have had 2 s10 that blow this fuse occasionally

Jan 30, 2009 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...