Question about Cars & Trucks

1 Answer

I need to know where to mount a fuel pump on a 1978 390 ford motor

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 21,873 Answers

On the driver side of the timing cover

Posted on Jul 13, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Can not find motor mounts for 1986 Ford mustang convertible model .

there are motor mounts and i just bought them for my car the mint go to this wed page www.mustangsunlimited.com they have just about every thing

good luck

Posted on Oct 10, 2008

  • 75 Answers

SOURCE: fuel pump advice

If it is an old electronic fuel pump then it should work fine.

Posted on Dec 04, 2008

  • 84 Answers

SOURCE: 1993 Ford Probe needs motor mounts

is the model with the V6 mazda motor, if so it can be a bit difficult if you have little mechanical experience, but it is doable without removing the motor or transmission. we would allow 3 hours to complete the whole job.

Posted on Dec 23, 2008

DIESELMUDDER
  • 2760 Answers

SOURCE: need to know if ford has an in-line filter between

No' not another filter/seperator (there's only one of them) but the injector pump has a brass screen on the inlet it's been known to collect the little fuzzy's off those non ford filters some folks use (simptom is truck idles ok but stalls or stumbles on acceleration)
use carb cleaner with red straw to blast screen out and get rid of those fuzzy's and dump the AAHHEmmm (Inexpensive) filters

ohh yes and I allmost forgot the fuel tank pickup has a intake screen on the end of it if your tank is rusty thats where it's gonna collect
you gotta take the bed off to get to that ..

Posted on Nov 06, 2009

  • 56 Answers

SOURCE: Fuel pump location

It is located in the fuel tank.

Posted on Jun 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacing a fuel pump on a 1988 Ford 460how much psi do I need which Electric fuel pump do I need


Fuel pressure is 40 psi, if yours has the two pump system get rid of it and mount a single in tank pump.

Apr 27, 2015 | Ford Cars & Trucks

1 Answer

I have explorer 2006 fuel pump doesn't work although it is new i want adiagram for its electric sircut


Did you test or just replace it ? There is a fuel pump driver module that controls the pump , an the PCM tells how much fuel to pump by a sensor on the fuel rail ! the fuel rail pressure sensor ! Your vehicle has Ford Electronic Returnless Fuel System ! watch this guy on testing Ford Electronic Returnless Fuel System Diagnosis Part 1 Ford Electronic Returnless Fuel System Diagnosis Part 2

did you check Inertia Fuel Shutoff (IFS) Switch The IFS switch is used in conjunction with the electric fuel pump. The purpose of the IFS switch is to shutoff the fuel pump if a collision occurs. It consists of a steel ball held in place by a magnet. When a sharp impact occurs, the ball breaks loose from the magnet, rolls up a conical ramp and strikes a target plate which opens the electrical contacts of the switch and shuts off the electric fuel pump. Once the switch is open, it must be manually reset before restarting the vehicle. Refer to the Owner's Literature for the location of the IFS.
Fuel Pump Driver Module (FPDM) Note: For the LS, the FPDM functions are incorporated in the rear electronic module (REM). The fuel pump operation is the same as for applications using the stand-alone FPDM. However, the REM communicates diagnostic information through the communication link instead of using a fuel pump monitor (FPM) circuit.
Note: The Ford GT uses 2 FPDMs to control fuel for the dual-injection fuel delivery system. The PCM outputs only one fuel pump duty cycle which is used by both pumps. The PCM individually monitors the FPDMs through their fuel pump monitor circuits. Both FPDMs are mounted on the same bracket. The FPDM mounted in the upper position on the bracket is referred to as FPDM and the FPDM mounted in the lower position, is referred to as FPDM2.
The FPDM receives a duty cycle signal from the PCM and controls the fuel pump operation in relation to this duty cycle. This results in variable speed fuel pump operation. The FPDM sends diagnostic information to the PCM on the fuel pump monitor circuit. For additional information on Fuel Pump Control and the Fuel Pump Monitor, refer to Fuel Systems in this section. You need to do some research on line. depending on the location these FPDM corrode an short out ! This vehicle in the video is inside but on some trucks they are underneath the vehicle ! This guy here scanner danner is a automotive teacher an knows he's stuff !

Feb 17, 2015 | 2006 Ford Explorer

3 Answers

94 ford ranger will not start unless I squirt gas into intake what can be the problem


ck your impact switch, reset if needed, it its good, fuse or relay, if power is getting to pump the pump may need replaced

Sep 01, 2013 | 1994 Ford Ranger Supercab

2 Answers

I have 1986 Ford tempo and I have to replace the fuel pump do I have drop gas tank to get to fuel pump


I your Tempo is fuel injected,then you have to drop the fuel tank,here's a link on how,if your Tempo is carburated,then it's under hood and here's how to replace,need more help,let me know.

Feb 13, 2013 | Cars & Trucks

1 Answer

I have a 1993 Ford F600 gas powered truck that will not run. With the fuel selector set on either tank neither of the tank mounted electric fuel pumps run. If we squirt fuel directly into the carb while...


some factory fuel pumps are ground controled off of negaitive battery cable. check connections and if cable full of acid. replacement of cable recomended.

Dec 16, 2012 | Cars & Trucks

1 Answer

How to replace tranfer pump on ford f350 7.3


IF YOU GOT A MECHANICAL TRANSFER PUMP YOU NEED A FLARE NUT WRENCH TO LOOSEN THE THREADED FUEL LINES.LOOSEN THE MECHANICAL TRANSFER PUMP BOLTS ONE OR TWO TURNS.MOVE THE PUMP BY HAND TO BREAK THE GASKET SEAL.USING A REMOTE STARTER SWITCH OPERATE STARTER TO ROTATE THE CRANKSHAFT IN SHORT BURSTS UNTIL THE FUEL PUMP CAM IS AT IT LOWEST POSITION.WARNING STAY CLEAR OF THE FAN AND DRIVEBELTS.DISCONNECT THE FUEL LINES FROM THE FUEL PUMP.REMOVE THE FUEL PUMP MOUNTING BOLTS AND REMOVE THE PUMP.THE ELECTRIC TRANSFER PUMP.TURN OFF RADIO FIRST THEN DISCONNECT THE NEGATIVE BATTERY CABLES. DETACH WIRES FROM THE PUMP.DISCONNECT THE FUEL INLET AND OUTLET LINES FROM THE PUMP AND PLUG THE LINES TO PREVENT CONTAMINATION AND LEAKAGE.LOOSEN PUMP MOUNTING BRACKET AND REMOVE THE PUMP.THE ELECTRIC TRANSFER PUMP LOCATED ON THE ENGINE MOUNT NEXT TO STARTER.THE MECHANICAL TRANSFER PUMP LOCATION IS ON THE RIGHT PASSENGERS SIDE OF THE ENGINE LOW AND NEAR THE FRONT.

Jun 11, 2010 | 1997 Ford F350 Crew Cab

2 Answers

1999 ford ranger fuel pump needs replaced.


Hello!

REMOVAL

WARNING:
  • DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR ANY FUEL-RELATED COMPONENT. HIGHLY FLAMMABLE MIXTURES ARE ALWAYS PRESENT AND MAY BE IGNITED, RESULTING IN POSSIBLE PERSONAL INJURY.
  • FUEL IN THE FUEL SYSTEM REMAINS UNDER HIGH PRESSURE EVEN WHEN THE ENGINE IS NOT RUNNING. BEFORE REPAIRING OR DISCONNECTING ANY OF THE FUEL LINES OR FUEL SYSTEM COMPONENTS, THE FUEL SYSTEM PRESSURE MUST BE RELIEVED TO PREVENT ACCIDENTAL SPRAYING OF FUEL, CAUSING PERSONAL INJURY OR A FIRE HAZARD.
  1. Disconnect the battery.
  2. Relieve the system pressure.
  3. Raise the vehicle.
  4. Drain the fuel tank.

cc999cb.gif
  1. Disconnect the fill pipe hoses.
    • Loosen fill pipe hose clamps.
    • Disconnect fill pipe hoses from the fuel tank.

f3fcce3.gif
  1. Remove the 4 bolts (2 each side) and remove the skid plate if equipped.
  2. Support the fuel tank.

918ba9a.gif
  1. Remove the bolts and pivot the fuel tank support straps away from the fuel tank.

e19f38e.gif
  1. Disconnect the fuel pump connector.
    • Lower the fuel tank slightly. Disconnect the fuel pump connector.


958d5a3.gif
Disconnect the fuel supply line push-connect fitting and the vapor tube fitting at the fuel pump


80378e1.gif
  1. Disconnect the vapor line fitting at the rear of the fuel tank.
  2. Lower the fuel tank.

62ccbfd.gif
To install, reverse the removal procedure


df22959.gif Special Tool(s)

REMOVAL

  1. Clean the area around the fuel pump mounting flange.



b28c7f0.gif
  1. Using the special tool, remove the fuel tank pump assembly locking retainer ring.
  2. Remove the fuel pump assembly. CAUTION: The fuel pump assembly must be removed and handled carefully to avoid damage to the float arm and filter.
  3. Remove and discard the fuel pump mounting gasket.
INSTALLATION
  1. Clean the fuel pump mounting flange and the fuel tank mounting surface.
  2. Apply a light coat of Premium Long Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B to the gasket to hold it in position during assembly. Install the fuel pump mounting gasket.

4976d12.gif
  1. Using the special tool, tighten the fuel pump assembly locking retainer ring.

Mar 02, 2010 | 1999 Ford Ranger SuperCab

2 Answers

Need to know if ford has an in-line filter between fuel pump and filter mounted ontop of motor on f350 7.3 turbo diesel


yes, on engine.base part #9155, Item #40, big round thing in picture

SECTION 303-04C: Fuel Charging and Controls — 7.3L Diesel 2000 F-Super Duty/Excursion/Motorhome Chassis Workshop Manual
DESCRIPTION AND OPERATION Fuel Charging And Controls Fuel System
The fuel system used on the 7.3L direct injection (DI) turbo diesel engine is controlled by the powertrain control module (PCM) (12A650).
The fuel system components consist of:
  • electric inline fuel pump (9350).
  • high-pressure oil pump.
  • fuel filter (9155).
  • oil pressure regulator.
  • oil pressure sensor.
  • fuel pressure regulator (9C968).
  • high-pressure oil pump reservoir.
  • water in fuel switch/fuel heater thermostat.
Fuel System Components

5398a63.gif

Nov 03, 2009 | 2000 Ford F350 Super Duty Super Cab

2 Answers

I need a manual for a 83-84 ford f150 pick up, as i need to posibbly replace the fuel pump , where can i d/l a free manual ?


Ford Pick-Ups/Bronco 1976-1986 Repair Guide
Electric Fuel Pump - Removal & Installation

Two electric pumps are used on fuel injected models; a low pressure boost pump mounted in the fuel tank and a high pressure pump mounted on the vehicle frame. Some models equipped with the 8-460 (7.5L) carbureted engines use a single low pressure pump mounted in the fuel tank.On injected models the low pressure pump is used to provide pressurized fuel to the inlet of the high pressure pump and helps prevent noise and heating problems. The externally mounted high pressure pump is capable of supplying 15.9 gallons of fuel an hour. System pressure is controlled by a pressure regulator mounted on the engine.
With internal fuel tank mounted pumps tank removal is required when servicing the pump. Frame mounted models can be accessed from under the vehicle. Prior to servicing release system pressure (see Fuel Supply Manifold details). Disconnect the negative battery cable prior to pump removal.

More details can find in autozone.com (free register); select the year, make, model and engine.

I hope help you with this (remember rated this help) Good luck.

Oct 16, 2009 | 1983 Ford F150

1 Answer

Fuel pump advice


If it is an old electronic fuel pump then it should work fine.

Nov 21, 2008 | 1997 Ford Club Super

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...