- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Confirm whether the clutch is not completely abnormal sound generated when the presence, otherwise it may be because the relevant parts hanging file control mechanism is abnormal catching other causes, but the problem of maintenance of vehicles for abnormal noise and noise is comprehensive analysis must be carried out on-site trial judge to hear the sound check, and requires a combination of conditions and abnormal noise generated sounds, such as the nature and source characteristics before we can make accurate judgments . Use obd2 for automotive diagnostics , you can improve vehicle safety performance and driving more safer.
none! sign of bad coil pack. power symptom = rough idle, unexplained and abnormal loud engine, and power lose. drop of RPM during accelaration and engine ligth comes on. abnormal stream of exhaust smoke.
Procedure to change the windshield washer tank or pump on an E46.
Tools needed: 10mm spanner (in toolkit), small-medium flat blade screwdriver
Undo the 10mm nut, highlighted in the red circle. This is the only
fastener holding down the washer tank. Lift the tank up about 4",
allowing you to unclip the black plastic heatshield around the washer
pump. This is where you need the screwdriver, to lift the securing tab
from the washer tank (yellow circle). You can actually pull out the
complete washer pump from the tank. Just gently pull up, it is a
Now unclip the washer level sensor plug (green
circle). This clip is a little difficult to figure out. I pulled it
hard and it came off. Taking a closer look at it once it was off, I
couldn't quite see how to unclip it from its securing catch.
At this point you have removed the washer tank. The two tabs at the
bottom of the tank fit into recesses in the body work, in order to
secure the tank. There is a filter screen in the tank, where the washer
pump plugs into the tank (blue circle). Just pry this up with a
screwdriver to remove it. I had bought a new one, just in case. You can
see the fluid level sensor socket on the left side of the tank in this
Now unclip the pump connector from the pump. Pinch the tab at the top of
the connector. This will unclip the connector from the securing tab.
Pull out the water hose from the nozzle on the pump
Replace the pump filter screen into the tank, if necessary. Plug in the
new washer pump into the filter screen. Connect the water hose back onto
Position the washer tank into its approximate location and clip the sensor for the fluid level back into its socket on the tank.
Secure the heatshield back onto the tank.
Now position the washer tank into its secured position and fill with a
little water, in order to test the pump out. Fasten the 10mm screw back
into the plug.
the sign which is shown can you properly define it weather it is a brake sign or some thing or different without proper explanation no body would be able to solve your problem sir you do one thing better confirm what sign it is or simply it is better you refer to your owner manual booklet for further clarification if still are confused than better to visit to nearest authorized workshop or service station. till the next time i solve your queries this siddhanth saying bye for now have happy motoring & safe drive