Question about Cars & Trucks

Open Question

Where is the 2008 Smart Car blower motor located?

I have read how to remove the blower motor clean the connection and burnish motor but I need to know where the actual motor is located.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


SOURCE: How do I remove and replace Corolla 2006 blower motor?

Well the blower motor is underneath the dash on the passenger footwell, you have to remove the glove compartment to gainaccess to the blower, it ahas 3 or 4 bolts holding the motor, remove and replace with new unit, it is a good idea to replace the filter once the motor is removed.

Posted on Jul 16, 2009

  • 13 Answers

SOURCE: replacing all season blower motor

six screws hold the glove box two at bottom four at the inside when u open the box after the screws are out pull on the box to remove and three hold the blower motor.its not hard at all.

Posted on Jun 22, 2008

  • 107 Answers

SOURCE: Lincoln 2000 town car Blower doesn't work at HI-MED-LOW speeds...

it is called blower motor resistor , should be close to blower motor , you will see a plug type connector with two screws , remove the screws and there should be a resistor inside the cover for the motor, swap with new and reassemble

Posted on Feb 19, 2009

  • 784 Answers

SOURCE: location of blower motor fuse

Fuse blower motor is not in the fuse box. It is located outside. lOpen the hood, on the driver side near the fender, about 1 feet from the fuse box toward the direction of the radiator, there is a retangular about 1x2 in with wire coming out from each end. Snap it open, inside is the the wire fuse.

Posted on Aug 05, 2009

  • 116 Answers

SOURCE: 1995 Chevy Pickup- Blower works on high only

the resister is usually located in the air box above the passengers feet ,high indicates the resistor needs to be replaced

Posted on Sep 04, 2009

Testimonial: "Thank you for the help, you've saved me a ton of time and frustration."

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to replace blower motor on smart car

Blower is under dash just above gas peddle disconnect wire harness twist counter clockwise unit will pull out

Jan 13, 2014 | 2008 Smart fortwo

1 Answer

Blower motor resistor location 2006

Under the blower motor inside the car (this is on the passanger side below the dash, when you get under there you will see the part that will need replacing). There is one screw and a connector to remove then pop the new one in and your done.

Dec 27, 2013 | 2008 Ford Fusion

1 Answer


check the fuse in the compartment.

Feb 07, 2013 | 2008 Jeep Wrangler Sahara

1 Answer

2008 azerawater backing up into dash of the car and onto the rug

I suggest you remove the AC blower motor from the air ducting and clean out the drain at the bottom of the blower motor housing, it will be full of leaves or a mouse has nested in there. The blower is under the dash on the passengers side, remove glove box and lower dash under panel to access the blower.

Oct 08, 2012 | Cars & Trucks

1 Answer

Smart car blower quit working How do I change moter

on d5river side next to gas peddle disconnect turn motor counter clockwise you can clen armature connect to drill motor slowly using fine sandpaper clean armature mine lasted 4 years without replacing

Nov 27, 2011 | Smart fortwo Cars & Trucks

1 Answer

Hi, i need to remove and replace the blower motor for the a.c./ heater, and dont know where it is located. can you please help?

Blower Motor Removal & Installation To Remove:
  1. Remove the insulator from under the right side of the dash.
  2. Disconnect the electrical connector from the blower motor.
  3. Remove the blower motor retaining screws.
  4. Remove the blower motor.
To Install:
  1. Install the blower motor.
  2. Install the blower motor mounting screws.
  3. Connect the electrical connector to the blower motor.
  4. Install the under dash insulator.
prev.gif next.gif

Dec 10, 2010 | 1999 Pontiac Grand Prix

1 Answer

Rad fan not coming on when engine is hot checked

this is real tricky as you have two problems and not one and both are not connected as much , at least from the description that you are giving me and with out diagnosing the car properly. You need to know that the Rad fan works on the 4th marker in the gauge which is 100 temp as that is the design of the car and that is when thermostat does its work. I would suggest for the rad problem to try and replace the sensor for the temperature located on the lines top of the engine. As that could lead to faulty gauge reading and thus could act up which means that every thing is not getting the true temp reading for the car. if that does not work let me know

Jun 25, 2009 | 2008 Smart fortwo

3 Answers

Lincoln 2000 town car Blower doesn't work at HI-MED-LOW speeds...

it is called blower motor resistor , should be close to blower motor , you will see a plug type connector with two screws , remove the screws and there should be a resistor inside the cover for the motor, swap with new and reassemble

Feb 19, 2009 | 2000 Lincoln Town Car

2 Answers

I need to know the location of the rear blower motor on a 2000 pont. montana

There is a little door on the left rear panel inside. I took the blower motor out, took it apart and cleaned it good. Lubed it up and cleaned the connections for the plug, and on the motor. Plugged it back in tested it and it worked. Installed it back in the van and my wife is happy again.

Jan 07, 2009 | Pontiac Montana Cars & Trucks

2 Answers

Jeep Patriot heater fan makes noise

the blower motor is located under the dash on the passenger side of the dash.a bracket with 1 screw and 3 other screws hold the motor in the heater box. remove them amd the electrical connector and the motor an be removed

Jan 04, 2009 | 2008 Jeep Patriot

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,035 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79024 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13652 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides