Question about 2000 Toyota Land Cruiser

1 Answer

Engine light is on, faulters under power - 2000 Toyota Land Cruiser

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Toyota Master
  • 21,873 Answers

Have you had the computer checked for trouble codes ?

Posted on Jul 13, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Check engine light is on, car faulters under power


Retrieve the error codes and post them here.

Jul 13, 2013 | 2000 Toyota Land Cruiser

1 Answer

Need to know which sensors will take all power away from moter so it would only idle says reduced engine power


The TPS,or the TAC, or one of the APP (Throttle postion sensor ) if this faulter then yes you default to a set RPM, The (Throttle actuator motor) this maintain idle and if this faulter then yes you default to a set RPM or if one of the Accelerator postion pedal, When a power default occurs the whole throttle body usaually replaced either of these 3 component is the culprit

Mar 01, 2012 | Cars & Trucks

1 Answer

99 chevy tahoe, 5.7 starts and idle fine, slowly give it gas it accelerates, step on the gas and it faulters, stalls sounds like it will die and bogs down


I have seen this type of problem before, this sounds like the engine is not getting the correct amount of fuel pressure it needs as you accel.the first thing is to remove the fuel filter and replace it, take the old filter and blow into it, this will tell you if its restricked. the next step will be to check fuel pressure, you will need a gauge for this test, hook up gauge at valve on the injector rail, take caution wear safty glasses as fuel is under pressure and will spary out a little as you connect line for the gauge to fuel injector rail valve, you will run the engine and also step on gas pedal as you watch the pressure, i would rev the engine to around 3000rpms and hold it to see if engine tries to stall or buck when it begins to act up look at the gauge and if the pressure drops as it starts to act up then the fuelpump is bad. its not able to keep up the pressure. start there good day.

Oct 18, 2011 | 1998 Chevrolet Tahoe

1 Answer

I have been experiencing numerous electrical issues. ABS light, AIR BAG, Check Engine light are all lit. Left front turn signal does not work in front, but does on side. Both brake lights are out, but...


Check the voltage at the battery with engine on and engine off. maybe your regulator is allowing too much voltage and burning things up. These are all on different circuits. Have the car scanned to extract trouble codes. Autozone does free scans. Report the codes back to us if you need help troubleshooting. Check the brake light relay right away, as that is a safety issue. This post talks about checking relays: http://www.fixya.com/cars/r6022358-relay_check

Sep 24, 2010 | 1999 Pontiac Montana

1 Answer

Why does my mercedes 320 n reg starts fine but while driving either faulters or cuts out will restart ?


Try checking the upper and lower engine wiring harnesses. From 1993-1995 MB was forced by the US to use biodegradable insulation on thier wiring which gets cooked by engine heat and falls apart. The same wiring is in the throttle actuator.

Feb 13, 2010 | 1995 Mercedes-Benz E-Class

1 Answer

98 ranger 4,0 very hard to crank when it does it runs very rough for a couple of min then levels out but does not have the power it should


I'm not sure what you mean by being hard to crank. If you mean that the starter motor battles to turn over the engine it may be you have a flat battery. Otherwise if the engine itself is stiff to turn it may be much more serious. You can check this by taking out the spark plugs and putting the gearbox in neutral. You should then be able to turn the engine by hand by rotating the fan belt pulley.

If the engine is simply hard to start (requires a lot of cranking) and runs rough you may have an ignition timing problem. Check your ignition timing with a timing light. and take out and clean the spark plugs and set the plug gaps.

If your ignition is OK you may have a fuel supply problem. This will cause a drop in power. Commonly the engine will faulter if you accelerate hard. A common cause for a fuell supply problem is a blocked fuel filter. This is easy and cheap to replace so you may be lucky and this is your problem.

Oct 10, 2008 | Ford Ranger Cars & Trucks

2 Answers

Nissan b14 sunny


I HAVE A NISSAN SUNNY B14. WHEN EVER YOU GO MORE THEN 80KM ENGINE SHUT DOWNS AND WHEN I START AND REV UP IT MAKES THE REV NOISE AND GOES OF

Sep 04, 2008 | 2003 Nissan Sentra

Not finding what you are looking for?
2000 Toyota Land Cruiser Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...