Question about Cars & Trucks

Open Question

Toyota avensis central locking problem only one door wont lock back passenger door driver side. All wiring seems fine I changed locks no good. Is there anything else I can do.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: audi a4 1995 central locking problem

Hi there.
I had exactly the same problem and there are 2 ways of solving it. The first is to pay your Audi Service Centre £350-£550 to replace it for you and the second way is to do it yourself which will cost well under £100 (depending on ebay). Firstly check the Central Locking Pump to make sure the hoses haven't come off. This is located in the very back right hand corner of the boot so you will need to remove the carpet and internal trim and you will see a block of sponge. Carefully lift the top off this and you will see the pump sat inside it.
Actually there is a great set of photos online to help you and I will add the link for you at the end. If the hoses are still connected and not leaking it is very likely that the internal compressor wheel has shattered (quite a common fault). I believe it is possible to open the pump and replace this wheel (in fact there is one for sale on a very popular auction site at the moment) but my own preference was to simply buy a whole new pump and replace that (£16.00 + £8 p+p off the same auction site).
The most important thing for you to remember is that when you look to buy a replacement pump you need to find one with the EXACT same serial number. The one in the diagram shown is
8LO 862 257 N but I have a sneaky feeling yours might end in an A.
Anyway, I hope this is of some help and dont worry about the connections as both air connectors and all 3 electrical ones are different sizes and will only fit in one place each.
Good luck.
Rik

http://www.audiworld.com/tech/elec131.shtml

Posted on Aug 19, 2008

Ad
  • 1861 Answers

SOURCE: 2002 toyota celica power door lock problem

Are you hearing any noises from the pass door when you activate the lock switch? If not, the power door lock solenoid has failed, and prob needs to be replaced. Pull the door panel & check to see if it is getting power to the solenoid in lock & unlock. If it has power, the solenoid is def bad.

Posted on Sep 19, 2008

  • 2 Answers

SOURCE: Passenger door on clio wont open??

http://www.renaultforums.co.uk/showthread.php?t=786&highlight=clio+rear+door&page=2

get a bit of wire and turn lock from inside panel - lubrication washes away and has to be renewed- Annoying problem Renault!! My MOT is due soon and it will fail cos of this if I don't fix it.

Posted on Jan 21, 2009

  • 1 Answer

SOURCE: i have a mini cooper 2004 my central locking will

Did you find a solution to this A's I have exactly the same problem

Posted on Feb 23, 2011

  • 1 Answer

SOURCE: Central locking on 1998 passat 1.9 tdi not fully working

the flasher dont working whene i give right or lift flash but if i open 4 flash togather its working can u helpe me ples to find the problem .

Posted on Jun 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My right side passenger door does not lock automatically anymore. Is there a fuse that operates this.


no all is related to one fuse you can remove the door internal controls and decore and remove center lock motor plug and test two connectors with multimeter with set on 12v and then lock un lock door and check the reading of the multimeter if it read signal then all plugs and wires from central lock control unit to the door central lock unit is okay it this cae you have to replace the door central lock unit with the same if no signal is readed while you lock unlock the door then you have to check central control unit and all wire plus out of it to the door plug

2- you can remove central control unit from driver door and test it in passenger door (usually the same unit ) if it works with lock unlock its then the replaced unit is faulty and needs to be replaced if it not work then check plugs wires from central lock unit (usually found inside driver door ) to the central lock unit in passenger door

3- check signal for said door fro the output of central door unit if no signal then it mean that faulty central lock control unit

Feb 23, 2015 | 2005 Honda Accord

1 Answer

Driver side door window & door lock control doesn't work


hummm strange
does the master switch have a other door lock button

so central locking and windows dont work as they should

driver side window motor faulty

individual door lock actuator motors not getting power


it is possible the central locking module wont work unless reset to the other cars electronics with the correct scanner

Apr 05, 2017 | 2002 Mitsubishi Lancer

1 Answer

Central locking problem


Change/repair the central locking motor inside the door.

Apr 01, 2014 | 2006 Hyundai Atos 1.1

1 Answer

2004 saab arc driver side central lock not working


Check for a bad switch in the door.
Water leaking from the rag top-door seal joint often drains into the switch, causing a short or bad contact eventually.

Mar 28, 2017 | 2004 Saab 9-3

1 Answer

1997 toyota corolla drivers door lock not working...


http://www.manualowl.com Hope this helps! Jimmy

Apr 10, 2012 | 1997 Toyota Corolla

1 Answer

Central locking not locking all locks from drivers door, will unlock, but not lock. working fine on passenger door with key, locks all. switch to activate central locking on drivers door unlocks but doesnt...


You will need to replace the driver door switch. You can try to pick a switch up from the dealer or a local car wrecker (i.e. Pick-n-Pull). It will involve learning to take apart the door trim panel.

Sep 05, 2011 | 1993 Toyota Corolla

2 Answers

Central locking problems


Aot of cars have problems with the actuators binding up. The sympton is you see or hear the switch trying to but wont.

The only fix is to replace the units.

Feb 22, 2010 | Fiat Strada Cars & Trucks

1 Answer

Camry 1996 automatic power lock doen't work, but windows work.


if you can here relays when unlocking/locking check for power at door lock actuators inside doors, if you have power on lock/unlock and good earth from connector actuators are faulty.
if no power on test light when operating check output from central door lock module while operating, none coming out of module then it might need replacing.
check 30Amp power fuse for main relay under bonnet (which goes to pin 8 white/blue on module)and 10Amp gauge fuse in cab(pin 1 blue/red on module),pin 15 is also power when relay is on(red/blue) with test light, and module/ actuators.
check outputs from module pin 3 & 4
blue/red
blue/black
that go to door locks

Jul 20, 2009 | 1996 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...