Question about 2005 Chrysler Pacifica

Open Question

Blend door actuator

AC not blowing from dash vents, only rear vents.

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 161 Answers

SOURCE: Front AC blower doesn't work.

Your blower motor may be going or the fan.

Posted on Sep 26, 2009

jturcotte
  • 8215 Answers

SOURCE: location of blend door or

The temperature door actuator is located at the bottom of the heater housing at the center terminal. It looks like this:

6b48b5c.gif
To remove the actuator

  1. Remove the left and right underpanel silencer ducts.
  2. Remove the two retaining screws from the actuator which are accessible from the right side of the center stack.
  3. Remove the screw from the actuator on the left side.
  4. Pull the actuator straight down from the shaft and disconnect the electrical wire. Upon removal, matchmark the shaft position of the actuator, because the shaft on this motor is keyed.

Posted on Oct 03, 2010

chargerhp
  • 813 Answers

SOURCE: what blend door actuator controls what area

The driver and passenger area separately and must be recalibrate after installing and both are reversible same motor12_20_2011_6_26_43_pm.gif

Posted on Dec 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blend door location


I am trying to locate the ac blend door actuator on my 2000 cadillac seville sts: AC blows air on the floor only instead of the dash board ac vents. Appreciate any help

Jan 04, 2014 | 2005 Dodge Dakota

1 Answer

Air blend door actuator


Possible bad blend door actuator .some gm cars can be relearned to the new climate control head

Jul 28, 2013 | 2001 Oldsmobile Aurora

2 Answers

Ac is blowing out of defrosterandnot panels in the dash. Air is cool cold air will blow out of rear seat panel/vent 1998 ford explored


The most common cause is a bad blend door actuator which controls air flow throughout the cabin. When air flow only flows from 1 section (either floor, vent, or defrost) it's an indication that the blend door actuator is either stuck or broken.

Jun 02, 2011 | 1998 Ford Explorer

1 Answer

2004 Yukon, air whether it's AC, heat or just vent doesn't go where the mode says it should. Mostly comes out the defrost ports on the dash. This is for both the driver, passenger and rear seat controls.


This is probably due to a faulty blend door or blend door actuator. The blend door is a device inside the dash that directs the air flow to the desired vent. Sometimes they will fail, but usually is an actuator. Unfortunately, you will have to remove the dash to see if this is the problem. If you have never removed the dash on a Yukon, you are in for a very big job. Here is also some good information

Oct 15, 2010 | 2004 GMC Yukon

1 Answer

Air doesn't blow out of dash vents


If it has automatic climate controls.Look to either a blend door actuator or the ac programmer. A vacuum leak at the ac programmer or actuator can also cause this if they use vacuum.

Jul 17, 2010 | 1997 Buick LeSabre

1 Answer

AC NOT BLOWING THROUGH DASH VENTS


PROBLEM COULD BE BLEND DOOR ACTUATOR OR FAULTY AC CONTROL MODULE.

Jul 06, 2010 | 2002 Ford Explorer

1 Answer

My Air Condition is only blowing hot air in the front, but cold in the rear. Could anyone give me a start in correcting this problem? Thanks


possible blend door actuator faulty, or a faulty blend door. This door switches from hot to cold vents. On expeditions equipped with rear AC front and rear AC have seperate actuators. Hopefully this helps!!

Mar 31, 2010 | 2001 Ford Expedition

1 Answer

Ac blowing hot air


the blend door actuator located on the air box (right hand side under dash) is prob. inop. worst case senerio the blend door its self is broken. I have replaced the actuator more than anything.

Sep 16, 2009 | 2005 Chevrolet Silverado

2 Answers

I only get warm air blowing out of the front vents


sounds like the air handler for the front is inoperative the wheel that operates it may be broken. its in the dash.

Jul 05, 2009 | 2004 Lincoln Aviator

3 Answers

2004 Ford Expedition XLT, front blend door actuator


Hope I was avle to help, glad you up and going.

May 26, 2009 | 2004 Ford Expedition

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...