Question about 2010 Mitsubishi Outlander

Open Question

Mitsubishi outlander check engine light is on and fault code is p 1773 and u 0121.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 8 Answers

SOURCE: mitsubishi 2003 outlander check engine light

anyone can go to auto zone and have the obd2 tool put on it for free and have them tell you what to do

Posted on Mar 21, 2009

Ad
mcgyver468
  • 710 Answers

SOURCE: 2004 mitsubishi outlander cooling fans not operating

TAKE A PEEK UNDER THE HOOD IN THE FUSE PANEL FOR THE FUSE AND RELAY FOR THE COOLING FAN. IF THE FUSE IS BLOWN THEN REPLACE IT. IF YOU SUSPECT THE RELAY TO BE BAD THEN TEST IT BY SWAPPING THE FAN RELAY WITH ANOTHER ONE WITH THE SAME PINS ON THE BOTTOM. MAKE SURE IT IS THE SAME SIZE AS WELL. HOPE THIS HELPS.. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

Posted on May 16, 2009

  • 333 Answers

SOURCE: mitsubishi outlander cooling fans not operating

There is a Recall to replace your cooling fan module because of this concern.

Open your hood and look at the black box bolted to your radiator fan by the battery. If it does not have a green dot on it, you have not had the replacement fan module installed.

Contact your local dealer with your VIN handy to verify the recall has not been done and to schedule an appointment.

If the recall has been done, verify if you have power coming out of the module to the fans, as the fans do burn out eventually.... but rarely both at once.

Posted on Sep 10, 2009

  • 333 Answers

SOURCE: how do you reset change oil light on mitsubishi outlander

Turn the key off.

Press the "Info" button on the left of the dash cluster until your maintenance miles/months screen is displayed.

Press and hold the "info" button until the maintenance screen begins flashing.

Release the "info" button and then push and hold it it for one second.

Your Maintenance intervals should reset to +6 months and +7500 miles since the last interval amount.

Note that if you have not reset it for more than one interval, you may need to do it more than once. If you have not done it for many intervals, you may need to have it reset with the scantool at a dealer, as I have run into a handful of vehicles that the oil change reminder locked up after 3-4 "intervals" were skipped/not reset.


Posted on Sep 11, 2009

  • 10865 Answers

SOURCE: how do I turn out the check engine soon light on Mitsubishi outla

Hello. The check engine light comes on when the vehicle's computer has detected a problem with one of the components in one of the systems. To find out what exactly that check engine light means you have to hook the vehicle up to a computer scanner. Many auto parts stores now offer this scan for free, as do the AAMCO repair shops. After the scan is finished, the scanner will turn out the check engine light. Some vehicles check engine light also turns off if the battery is disconnected for two full minutes. Regards, Joe

PS kindly rate my answer. Thank you. Joe

Posted on Jan 23, 2010

Testimonial: "Thank you Joe thats what I was looking for."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 Mitsubishi Outlander XLS V6, with light on of SERVICING ENGINE SOON CODE P0305.


code p 0305 is misfire on no 5 cylinder ===causes , injector , fuel pressure , injector wire--ecm---mechanical fault

Sep 15, 2017 | Mitsubishi Cars & Trucks

1 Answer

I have a 2005 mitsubishi outlander with 68000 miles and the neutral light blinks while in drive not all the time just happend today i stoped turned off the car and restarted it and it stoped now just


Whenever this warning or any other stays on in the dash it is indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Sep 20, 2012 | 2005 Mitsubishi Outlander

1 Answer

P0488 fault code on a 2008 outlander


just had this on my 2007 2.0 did outlander, replaced the egr throttle body which cleared fault code p0487 which i also had, but p0488 was a little more tricky to find out what it was, after searching the internet i checked the fuses, sure enough a 15a fuse had blown, about 6th from the right as you look at the fuse box with an engine symbol identifyng it. changed the fuse cleared the fault code job done, it seems a broken egr throttle body will blow this fuse according to my research. hope this helps someone.

Jul 10, 2012 | Mitsubishi Cars & Trucks

1 Answer

Oxygen sensor problem on mitsubishi outlander 2004


If the car has a check engine light on you may want to have the code checked, as this may point you in a direction as to what is causing this issue.

It could also be a bad EGR valve if the vehicle surges.

Hope this helps you out,
1aauto.com

Jul 10, 2012 | 2004 Mitsubishi Outlander

3 Answers

How do i reset my check engine light in my2006 mitsubishi outlander.


When the check engine light comes on, on about any vehicle it is a trouble code you can take it to autozone, napa or some similar autosupply house and they can read the code and tall you what the problem is or you can take it to a mechanic of your choice and they can do it there, if they reset and there is a problem that isn't repaired the light will go off for a short period then come back on again. I had this problem with one of my vehicles and the check engine light would not go off until I had the problem repaired which was the cooling system failure telling the vehicle that it was running hot when it wasn't causing it to shut down.

I hope this help you.
Please don't forget to rate/vote on my advice or place a testimonial..
Wicked Angel

Dec 06, 2010 | 2005 Mitsubishi Outlander

2 Answers

What does the yellow light that looks like an engine block represent when it comes on?


hi this is the engine management system light, this is telling you that you have a fault and has been recorded in the ECU, you will either have to take it to a garage, or main dealer, to get the codes read to tell you what the fault is, or you can purchase a cheap diagnostic code reader from the net, but to be honest if you do not know what the code faults are, i would suggest you take it to a garage so they can tell you what the fault is..hope this helps

Aug 08, 2010 | 2005 Mitsubishi Outlander

2 Answers

How do I turn out the check engine soon light on Mitsubishi outla


Hello. The check engine light comes on when the vehicle's computer has detected a problem with one of the components in one of the systems. To find out what exactly that check engine light means you have to hook the vehicle up to a computer scanner. Many auto parts stores now offer this scan for free, as do the AAMCO repair shops. After the scan is finished, the scanner will turn out the check engine light. Some vehicles check engine light also turns off if the battery is disconnected for two full minutes. Regards, Joe

PS kindly rate my answer. Thank you. Joe

Jan 23, 2010 | 2003 Mitsubishi Outlander

1 Answer

Codes for 1995 Mitsubishi eclipse


Engine-light-help.com

P1100 Induction Control Motor Position Sensor Fault

P1101 Traction Control Vacuum Solenoid Circuit Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1102 Traction Control Ventilation Solenoid Circuit Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1103 Turbocharger Wastegate Actuator

P1104 Turbocharger Wastegate Solenoid

P1105 Fuel Pressure Solenoid

P1294 Target Idle Speed Not Reached

P1295 No 5 Volt Supply To TP Sensor

P1296 No 5 Volt Supply To MAP Sensor

P1297 No Charge In MAP From Start To Run

P1300 Ignition Timing Adjustment Circuit - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1390 Timing Belt Skipped One Tooth Or More

P1391 Intermittent Loss Of CMP Or CKP Sensor Signals - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1400 Manifold Differential Pressure Sensor Circuit - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1443 EVAP Purge Control Solenoid '2' Circuit Fault

P1486 EVAP Leak Monitor Pinched Hose Detected

P1487 High Speed Radiator Fan Control Relay Circuit Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1489 High Speed Condenser Fan Control Relay Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1490 Low Speed Fan Control Relay Fault

P1492 Battery Temperature Sensor High Voltage

P1494 EVAP Ventilation Switch Or Mechanical Fault

P1495 EVAP Ventilation Solenoid Circuit Fault

P1496 5 Volt Supply Output Too Low

P1500 Alternator FR Terminal Circuit - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1600 Serial Communication Link

P1696 PCM Failure EEPROM Write Denied

P1698 No CCD Messages From TCM

P1715 Pulse Generator Assembly

P1750 Solenoid Assembly

P1791 PCM ECT Level Signal To TCM Circuit Fault

P1899 P/N Position/Transaxle Range Switch Circuit Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1751 A/T Control Relay

P1791 Engine Coolant Temperature Level Input Circuit - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1795 Throttle Position Input Circuit To TCM - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

Mar 21, 2009 | 1995 Mitsubishi Eclipse

Not finding what you are looking for?
2010 Mitsubishi Outlander Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...