Question about Cars & Trucks
The packings are leaking on the left hand side lift cylinder. The forklift is a Toyota model 42-6FGCU25 Serial #70338. Our service manager left us and we are sort of stuck. Thank-you in advance for your prompt reply.
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I've been resetting pajero's compasses but try to get to an area where you can do 360 degrees turns (empty car parks, ) press the reset button and make 2 complete 360 turns slowly and normally this should set the compass bearing.
Let us know how you get on. Cheers.
Posted on Oct 29, 2008
This site will tell you what you need to know. good luck with this.
http://autorepair.about.com/od/otherodddiyjobs/l/aa092504a.htm. In addition to the advice at the above site, I found another trick to removing the trim around the inside door handle. The above article refers to putting a screwdriver UNDER the door handle and pushing down ... to release a "secret latch". That's the first step. The second step (which is not in the article) is to insert the scredriver ABOVE the door handle ... vertically above the spot shown in the article. Then gently press the screwdriver handle down. With the screwdriver acting as a lever, the tip of the screwdriver will push UP on the top part of the trim. That will lift the trim up off a small pin on the handle mechanism. With both the bottom and top of the trim piece now "unlatched", slide the trim toward the back of the car, while you open the inside door handle (as mentioned in the article). The trim will come right off. Be sure to slide the trim toward the back of the car, as you move the trim away from the door panel. (There is a "hooked" piece of plastic on the back of that trim that prevents you from just pulling it out perpendicular to the door panel.) 'Hope these fine points help.
Posted on Feb 13, 2009
SOURCE: '00 Toyota Sienna-stuck door
the lock actuator is binding/hanging up, replace it and lube the linkages this should cure that problem....hope this helps...let me know...GL
Posted on Jul 06, 2009
It could be water condensing from the A/C and dripping onto the passenger rug. Check under the passenger side dashboard, above the footwell, for the drain pipe from the A/C. If it's loose the water may leak into the footwell when the A/C is running. Should be reasonably easy to fix.
Posted on Jul 24, 2009
Tips for a great answer:
Jan 25, 2016 | Toyota Cars & Trucks
Nov 07, 2015 | Toyota Cars & Trucks
Jun 27, 2013 | Cars & Trucks
Mar 22, 2012 | Hoisting
Sep 08, 2009 | 2005 Toyota MR2 Spyder
May 11, 2009 | 2000 Alfa Romeo 156
Mar 22, 2009 | 1994 Toyota Previa
Nov 20, 2017 | Cars & Trucks
32 people viewed this question
Usually answered in minutes!