Question about Cars & Trucks

1 Answer

Gould's pump j5sh keeps having a

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

There are three buttons on drivers side does anyone know what they are for....... jay

Posted on Jul 13, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My Gould pump has been working fine for 2 months now has stopped pumping. Now when you turn it on it hums for 30 seconds and then kicks off. It has water in it so don't know what the problem is.


pump impeller jammed ,motor bearings seized,motor seized ,short in pump windings if 208 possible lost a line feed --need to check power and pump to see if turns

May 30, 2017 | Cars & Trucks

1 Answer

Why would gould water pump red trouble light indicator come on when power switch turned back on after having been off for a few hours? Had to turn off power to pump earlier in day due to volatile elec


check and prime the pump as the light may indicate no water and so the pump will not run
foot valves leak back the water so it may need priming again

Jul 21, 2017 | Cars & Trucks

2 Answers

1999 Cougar V6 2.5L High Pressure Oil Line Leak?


It would be great if you could post a picture.

Jul 13, 2013 | 1999 Mercury Cougar

1 Answer

Gould water pump


I service all sorts of Goulds water pumps for a living but will need some more info to troubleshoot your problem. For starters would need to know what voltage feeds it, single or three phase, horsepower, type of controller (pressure switch, Variable Frequency Drive, Three phase across the line start etc.), what you are doing with it, pump model number, motor frame number, etc. etc.

May 12, 2013 | Cars & Trucks

1 Answer

Where is the fuel pump relay on a 1999 sienna


If you look under the hood look to the driver side you will see a square black box it Gould the fuse box . Open it and see look for EFI relay . That controls the fuel pump and fuel injection system . Hope this will help you

Jan 13, 2013 | Cars & Trucks

4 Answers

2002 ford explorer while filling the gas tank the pump trips every couple of tens of gallons


This is caused by a defective fuel vapor recovery system in the fill pipe, you need the dealer to repair this.

Jan 03, 2013 | 2002 Ford Explorer

1 Answer

My 2002 santa fe dosen't take fuel correctly,gas pump keeps kicking off,making it take for ever to fill


sound like problem with the EVAP SYSTEM.HAVE CHECK OUT. trick to pumping gas dont stick fuel spout all the way in hold it back a little then pump gas the gas vapors stored in fuel tank stopping you from pumping gas.hold spout back pump gas.

Dec 29, 2012 | 2002 Hyundai Santa Fe

1 Answer

'96 Jeep Cherokee Classic: front windshield washer does'nt work. Replaced both front & rear pumps.


If you have replaced the pumps and the switch, the only thing left is the wiring. First of all , check the fuse, and then , with a test light, see if you have power at the pump when you hit the switch. I'm assuming you don't, and you will need to keep probing the wire back from the pump to the switch until you find power. Keep in mind power will only be present when the switch is pushed. You will also have to be sure the ground wire s good. Good luck.

Feb 06, 2012 | Jeep Cherokee Cars & Trucks

1 Answer

Leak on the front of the Engine


Before replacing the timing cover gasket, crawl underneath the truck and spray everything with brake parts cleaner, then wipe with rags until dry & clean. Start the truck, then crawl under the front of the truck, using a flashlight to spot leaks. Chances are the leak is the seal between the vacuum pump and power steering pump. If this is the case, contact Pete Gould at fixinrams.com. He can sell you an uprated seal kit, or provide you with a totally remanned vacuum pump reasonably. The vacuum pump runs about $375, replacing front cover gasket is about $1100. Hope this helps

Feb 08, 2009 | 2001 Dodge Ram 3500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...