Question about 1998 Chevrolet Malibu

1 Answer

Car sounds like zzzz, wont start

It did start twice,but i dont want toget stuck.I want to get it fixed.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 21,873 Answers

Are you saying it sounds like the starter is spinning but not making contact with the flywheel ?

Posted on Jul 12, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 chevy blazer has a rough idle


probly a vacuum leak-will set lite cause car runnin lean--listen for noises or chec hoses and gasket quality--problem wiil go away w increase speed--some leaks are hidden like egr valve condition-but it isnt stalling--------may want to try a scan w factory specific equip since car is old--cheap littl code readers wont cut it--dont go to a dealer-softwear dont go back that far

Jan 21, 2014 | 1997 Chevrolet Blazer

1 Answer

Car wont start


sounds like a broken contact in the ignition switch

Mar 17, 2013 | Subaru Legacy Cars & Trucks

1 Answer

Car battery put in backwards, car wont start


It sounds like you have fried your alternator ;(

Jun 19, 2012 | 2003 Volkswagen GTI

1 Answer

When i lock al my doors on my 2004 Chrysler pacifica from my keychain all doors lock except for the driver door. The alarm is still activated but if someone tries to open the driver door it will open and...


This can happen If you have used the IGN. key to unlock the drivers door after you locked them from the fob. This can also be caused by a stuck button on the drovers door. Check the drivers door all buttons to see if any are stuck. If you do not have any stuck buttons. Try this, from inside the car, with out the car running, use the button on the drivers door to "lock all doors". Then use the fob to unlock them, then get out and press the lock button on the fob twice real quick. This should cause the drivers door to lock as the others. Hope this helps Fix Ya Up.

Jul 03, 2011 | 2004 Chrysler Pacifica

1 Answer

2006 KIA RIO PO171 AND PO0446 CODES SHOWING UP AND WHEN YOU FILL UP WITH GAS IT DONT WANT TO START AND MISSES


P0171 System too Lean - Bank 1.
P0446 Evaporative Vent Control Circuit Malfunction.

Sounds like your Evaporative Vent Control is stuck closed and it's causing a vaccuum in the tank, starving the engine of fuel because the pump can't **** it out.

The more fuel in the car, the worse it will be because the vaccuum will be more pronounced if there is little air in the tank. Just TRY running the car with the fuel cap off or very loose. This will probably work and will give you an indication that this is the fault. Use the opportunity toget it to a garage to get the problem fixed (Don't drive around with no fuel cap, it's against the law!).

You can find a full list of fault codes for your car at:
http://www.kia-forums.com/do-yourself/33370-all-kia-trouble-codes.html

Jun 21, 2011 | 2006 Kia Rio5

1 Answer

Working on a 97 nissan pathfinder would start but very rough idle and would not rev up. changed plugs cap and rotor now wont start at all? any help would be great


most likely coil insulation has failed.most commonly occurs in tower area.remove cap,crank engine and watch where spark arcs to .if it comes out anywhere but the outlet portion of the tower or you dont see any at all...the coil has a failure.bad news is you have toget the whole distributor assy.coil not serviced separately.

Feb 11, 2011 | 1997 Nissan Pathfinder

1 Answer

My car wont start. what can it be?


if the sparkplugs dont spark, you will never get the car started. it needs the spark to initialize combustion. replace all sparkplugs and try again. press the petrol pedal twice while cranking, and hold it down the third time, or else you will flood the carbutattor, and will not start either. if the car does not have electronic ignition, check the ''points''. good luck

Apr 03, 2009 | 1995 BMW 3 Series

1 Answer

Key stuck in igntion 2005 five 4 cylinder


The key being stuck in the ignition is because the cars gears wont go into park all the way.. The shifter is the problem with this. You need to take it to a mechanic so they can take your actual shifter apart and fix the little button you press on the actual shifter. Sounds dumb, but thats what they did for me, and the key comes right out. Also, if you dont get it fixed soon, you will have some horrible times ahead of you .. See : Battery dying and Power steering Issues

Dec 22, 2008 | 2005 Chevrolet Cobalt

Not finding what you are looking for?
1998 Chevrolet Malibu Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...