Question about Cars & Trucks

Open Question

Hyundai terracan 4wd high and low permanent on and wont go past 3er gear

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Will not shift into 4wd low but will shift into 4wd high

Thanks for your response johnnyc85.... I did some searching on the internet and found it. When you need to go into 4wd low, just turn your knob to the 4wd low position and when it starts to blink just put the truck into drive or reverse and move about 1mph it will lock right it. It takes about 5 seconds to engage.

Posted on Jul 02, 2008

  • 2 Answers

SOURCE: 1995 gmc jimmy will not shift out of 4wd high

sounds like the vacuum lines are either pinched or the vacuum pump is shot. try getting a mechanic look at the lines on and around your transfer case... also try checking the fuses for the 4wd selector. let me know how it goes

Posted on Dec 26, 2008

jmassengill
  • 345 Answers

SOURCE: 2002 hyundai accent codes p1529 and p0734

P1529 means nothing more than the TCM (transmission control module) has requested that the ECM (engine control module) turn on the check engine lamp.
P0734 basically indicates that your transmission is slipping.
You need to take this car to an authorized repair center for hyundai cars. Replacing the filter and fluid on the transmission might save this transmission but I would be willing to bet that a total transmission rebuild is in order.

Good Luck

Posted on Jan 02, 2009

  • 1 Answer

SOURCE: 93 chevy s-10 blazer 4wd High wont work

Transfer case module causes this, first disconnect battery then wait 1 min reconnect and try 4 high should work till you can get a trained tech to fix.

Posted on Jan 02, 2009

  • 1 Answer

SOURCE: 4wd high range does not lite or engage

1998 blazer 4x4 high inop. but 4x4 low works

Posted on Feb 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the next step in diagnosing our Terracans electrical problem


code p1123 refers to long term fuel trim--additive--mixture too rich===causes-- HO2S--fuel pressure --fuel system---mechanical fault---ECM
check all wires and connections. With the mechanical fault I would be revisiting all the items you removed to get to the rocker cover to ensure that all the hoses and wires were correctly replaced and that the gasket has not been mis -fitted or squashed out from under the cover at some point

May 20, 2014 | Hyundai Terracan Cars & Trucks

1 Answer

My hyundal 2004 terracan 2.9 engine management light flashing up hills


Comon problem - first - check injectors - they can overleak -second - pressure on pomp too low- damage inside from bad fuel - this is extremal but hapend .
I thing more about first posibility - try start at this

Sep 07, 2013 | 2005 Hyundai Terracan 2.9

1 Answer

Hyundai terracan blower motor speed control resistor


I am also trying to find out where the blower resistor is on a Hyundai terracan 2006. On here someone says its on the passenger firewall is it beneath the battery I cant find it

Jan 29, 2013 | 2006 Hyundai Terracan 2.9

1 Answer

2004 kia sorento wont shift past 25 mph why?


I believe your transmision gone bad and needs replacment or rebuild, Unless this a 4wd modelSsorento, if so, you have your 4wd turn on and on the low 4wd side in Lx models if this is a 4wd sorento ex, equipped with the auto/low 4wd knob. You might have the knob, or accidently shift the knob to the (low 4x4) position, and if you do, then the car is set only to run on the first gear for max tranction and to prevent your differential from overheating. This knob is located on your left side of the steering wheel, and if turned to the 4wd postion, it needs to be in the auto or 2wd poistion.

Jan 06, 2011 | 2004 Kia Sorento

1 Answer

How do you shift to 4wd 99 wrangler


You can shift on the fly...as you are moving....into 4WD at speeds up to 40 MPH but simply grabing the 4WD selector and moving into the 4WD high gear. Low gear selection should be done at a stand still, with transmission in neutral position before proceeding in fwd. The low position is a "granny gear" that is for extreme situations where high 4WD will not suffice or get you out of a stuck situation.

Dec 31, 2009 | 1999 Jeep Wrangler

2 Answers

2005 hyundai terracan loss of power on faster journeys


check transmission sensor, I hope is not time for a new transmission

Jul 25, 2009 | 2005 Hyundai Santa Fe

1 Answer

Please explain hyundai terracan 2002 fault codes p1730 front speed sensor low input, p1732,p1734 low input,how to find problem, low range there is no opperation at all, cheers ,clive.ps in the model...


P1730 Front Speed Sensor - Low Input
P1732 Rear Speed Sensor - Low Input
P1734 Speed Sensor Reference - Low
These are all references to Electronic Stability Control or ABS systems. If there's no problem with wiring, then you could safely assume the speed sensors are bad.

Apr 30, 2009 | 2002 Hyundai Tucson

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...