Question about Cars & Trucks

Open Question

WIll a P0741 code (torque converter clutch stuck off) cause a vehicle to pass NC inspection? .

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: p0741 Torque Converter Clutch Circuit Preformance or Stuck Off

Toyota is aware of this situation. Production changes have ocurred to correct this condition.

Here is what you do: Take your vehicle to your Toyota dealer. Tell them that you have a P-0741 code, and you want them to apply "Toyota Technical Service bulletin TC008-04" to your vehicle. They will perform several tests, and if you vehicle is lower than 5 years old, and less than 60, 000 miles, they will fix it for free. This TSB is covered by the Powertrain Warranty. Additionally, Thay may replace the ECU with an updated unit, and that particular warranty is in effect for 96 months or 80,000 miles.

This will definatly cure your issue.


Posted on Sep 17, 2008

Ad
  • 191 Answers

SOURCE: These codes comes out P0741

Your torque converter is not locking up.
The solution is to have the torque converter replaced and the transmission serviced.
Hopefully, you are still under warranty and can get it repaired it for free.
If not, it can get pretty expensive.

Posted on May 05, 2009

morse008
  • 1111 Answers

SOURCE: check engine light came on, code was p0741... the

this is most likely true .try disconnecting the battery positive terminal for 1 minute to see if it will reset itself

Posted on Aug 24, 2009

  • 1 Answer

SOURCE: P0741 Torque Converter Clutch Circuit Performance

it's either the tcc solenoid inside the valve body not engaging or the converter itself is on it's way out probably due to bad seal.. change that also if you go the converter route..check also the ground to the solenoid and make sure it's getting enough voltage. make sure the fluid is up to date and flushed before all of the above. and remember after solenoid install car wont drive right for a few miles until computer picks up new solenoid or get new transmission installed

Posted on Sep 05, 2009

TheAsian
  • 93 Answers

SOURCE: check engine lite

Replace the solenoid group on the transmission

Posted on Jul 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Torque converter p0741 performance


code p0741 refers to torque converter clutch (TCC) solenoid--performance or stuck off===causes-- Wiring---TCC solenoid. I would consider replacing the TCC solenoid

Sep 25, 2013 | 2003 Hummer H2

1 Answer

2002 CADILLAC SEVILLE CANT PASS SMOG


P0507 Higher idle speed than expected partially stuck open thermostat engine running colder than normal raises idle speed. Small vacuum leak raises idle speed. sticking throttle cable holding throttle plate open.
P0741 Torque Converter Clutch system stuck off : Code conditions : No engine or transaxle system codes set, engine run time over 5 seconds , Throttle Fluid pressure switch not indicating Park/Neutral,TCC commanded On @ max duty cycle, throttle angle over 8% Trans fluid Temp input 68-248f Degrees not in fuel cut off, trans gear ratio indicates 2nd, 3rd, 4th gear delivered torque 32-150 ft lbs, the PCM detected a TCC slip value that was over the torque limits . most likely cause is bad tcc solenoid or torque converter itself. Trans shop can diagnose and repair

Jan 12, 2013 | 2002 Cadillac Seville

2 Answers

P0741 code


P0741 MITSUBISHI - Torque Converter Clutch System Malfunctionxicon.jpghttp://engine-codes.com/p0741_mitsubishi.htmlForum CodePossible causes- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Transmission internal mechanical problem

Jun 25, 2012 | 2002 Mitsubishi Montero Sport

1 Answer

Obd 2 code p0741. What would cause this code???


HERE IS THE DIFINTION
Automatic transmission torque converter clutch stuck off.
Possible causes - Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Transmission internal mechanical problem

Sep 16, 2011 | Cadillac STS Cars & Trucks

1 Answer

Have a2005 deville with the code po741 cant pass ca. smog need to what dose it takes to fix this problem


Hi,

Code P0741 = Torque Converter Clutch Circuit Performance or Stuck Off. This relates to your transmission only and has nothing to do with Exhaust emmissions.

If failed smog test, there must be an issue within your emmission system, e.g. sensors etc

You will need to have your codes read again, or have your vehicle properly inspected.


Cheers,

Jun 14, 2011 | Cadillac DeVille Cars & Trucks

3 Answers

My Ford Focus 2006 4 cyc has an engine code PO741 on my OB2. What does that mean?


P0741 Torque convertor clutch circuit failure,it is located in the transmission valvle body, it is attatch to the valve body you can remove it seperately as long as your going to own the Ford focus you might as well get use to replacing these all the time,very common transmission issue with todays car. By the way it is sensitive to worn transmission fluid,when you dont service often these are suspectable to failure.

Apr 22, 2011 | Ford Focus Cars & Trucks

2 Answers

Honda Civic 2005 Check Engine Code P0741 Torque Converter or Stuck Off


Possible causes - Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Transmission internal mechanical problem

Mar 01, 2011 | 1999 Honda Civic

2 Answers

What code is? p0741


CODE PO741 - TORQUE CONVERTER CLUTCH SYSTEM STUCK OFF WHEN THIS CODE COMES UP YOUR TRANSMISION FLUID TOO LOW OR FLUID + FILTER NEED CHANGING YOU HAVE A RESTRICTION IN TRANSMISSION LINES TO RADIATOR CHECK TO MAKE SURE LINES NOT BENT IN ANY WAY.TCC FEED VALVE OR TCC REGULATOR VALVE IS STUCK OFF DUE TO SEDIMENT OR BINDING.THE OIL PRESSURE SCREEN IS CLOGGED OR DEBRIS IN THE OIL PAN.TAKE CAR TO A TRANSMISSION SHOP GOING TO COST YOU.YOU NEED TRANSMISSION FLUSH AND YOU NEED A FILTER AND FLUID CHANGE.ITS NOT CHEAP FIX BUT YOU CAN CHANGE FLUID + FILTER YOUR SELF TO SEE IF IT HELPS BUT BEST TO HAVE SHOP TO FLUSH OUT TORQUE CONVERTER. PUT NEW TRANSMISSION FLUID IN THE ENTIRE SYSTEM SOUND LIKE OLD FLUID CONTAMINATED WITH SEDIMENT NEED TO GET IT ALL OUT TRANSMISSION.

Aug 16, 2010 | 2000 Chevrolet Impala

1 Answer

CODE P0741


P0741 "Torque Converter Clutch Solenoid stuck off"
If the PCM detects high torque converter slip when the TCC is commanded ON, then DTC P0741 sets. The Powertrain Control Module (PCM) controls the Torque Converter Clutch Solenoid Valve (TCC Sol. Valve) Pulse Width Modulation (PWM). The solenoid controls the hydraulic fluid for TCC apply and release. When the TCC is applied, the engine is coupled directly to the transmission through the TCC. The TCC slip speed should be near 0.
Thank you for using Fixya and good luck

Aug 05, 2010 | 2004 Kia Sedona

2 Answers

Yellow check engine light came on; code; P0741 refers to possible torque converter problem. car runs fine. what else could it be?


Audi code P0741 Torque Converter Clutch Circuit Performance or Stuck Off, THIS IS IN MOST CASES A STUCK TORQUE CONVERTER LOCK UP CLUTCH, U MAY NOT EVEN NOTICE THIS AS ALL GEARS WILL WORK JUST NO TORQUE CONVERTER LOCK UP, U WILL NEED TO VERIFY THE TORQUE CONVERTER CLUTCH CIRCUIT IS OK AND IF SO REPLACE THE TRANSMISSION TORQUE CONVERTER.

Jun 30, 2009 | 2001 Audi A6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...