Question about Cars & Trucks

Open Question

2008 Hyundai Veracruz master window switch

How do you replace the master window switch? The driver's side power window will not go up.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: power windows isuzu rodeo 1999

Cable must of disconnected need to take door cover off and reconnect...

Posted on Jan 10, 2009

  • 840 Answers

SOURCE: Remove door trim to replace power window switch

you dont have to take the trrim off on this car look at the outline of the switch open from rear and pull forward then you can change the window switch/ Please rate my response thank you very much

Posted on Feb 01, 2009

  • 32 Answers

SOURCE: 2001 elantra master power window switch

at the bottom and top of the switch there are retaining tabs. you can try to pop it out at those points with a flathead screw driver, but it is sometimes easier to just remove the door panel to get it out.

Posted on Aug 13, 2009

  • 1 Answer

SOURCE: how do i change the rear tail light lens on my

Open the rear hatch. Using a small straight edge screwdriver, insert the screwdriver into the slot at the top of each of the two screwcovers on the inside lip of the tail light assemby and carefull pry open. Remove the two screws using a philips screwdriver. Drape a small cloth over the head of a larger straight edge screwdriver and insert at the tip of the tail light assembly (on the rear side of the car and carefully turn back and forth while wiggling the entire assembly. This will eventually allow you to work the tail light assembly loose from the grip pin that is holding the assembly on. Once removed, replace the appropriate bulb. With the assembly still not installed, have someone step on the brake to ensure the new bulb is working properly. Reinstall assembly. Hope this was helpful....I just changed mine.

Posted on Jun 12, 2010

  • 4 Answers

SOURCE: DRIVERS SIDE POWER WINDOW 2006 CHEVY EQUINOX

Check inside wiring by the driver's side door hinge. Remove the rubber boot and you will find broken wires. Make a splice and you are fixed!

Posted on Jan 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace driver side inside door handle?


2006-2012 Hyundai Veracruz Inside Door Handle Genuine ...

? 0:45
www.youtube.com/watch?v=GQS89eacrOQ
Feb 10, 2015 - Uploaded by AutoPartsCheaper
Genuine OEM Hyundai front or rear interior door handle that fits the ... 2011 Hyundai Veracruz Limited Start Up, Engine, and In Depth Tour ...

Sep 08, 2015 | 2011 Hyundai Veracruz Limited

1 Answer

Do I require any special tools to replace the driver's side rear reflector on the bumper of a 2008 Hyundai Vera Cruz. It appears to snap in, but I don't want to break it. Thanks.


There's nothing in the manuals about special tools. I have the same problem. I think you'll have to remove the lower bumper in order to get good access to it. It appears that there is a black housing screwed into the bumper from the rear side and the lens would snap into that.

Apr 23, 2015 | 2008 Hyundai Veracruz

1 Answer

Which fuse is for the rear outlets on 2008 veracruz


For Hyundai Veracruz, rear outlet fuse box is in engine compartment. On left side (next to blue water cap). Refer to manual page 7-47 and 7-51. There is two 30Amp fuses.

Feb 15, 2013 | Hyundai Veracruz Cars & Trucks

1 Answer

How to replace the inside front door handle on a 2008 hyundai veracruz


buy a replacement and look it over real good then tackle getting the old broken one off .

Feb 05, 2013 | 2008 Hyundai Veracruz

1 Answer

Hyundai veracruz front bumper


Its fitted by screws and held by assembly.Give proper support to lower side and loosen the screws and bumper should easily come off.
---------------For complete step by step details,go through the help links mentioned below :-----

How to Attach the front bumper cover to the fender on 2010 Ford Explorer?

http://technoanswers.blogspot.com/2012/01/how-to-attach-front-bumper-cover-to.html
-----------

How to replace Bumpers on Acura Car models?
http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-bumpers-on-acura-car.html
-----------

How to Replace Front Bumper on Audi A4 and VW Passat?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-front-bumper-on-audi-a4.html
----------These will help.Thanks.

Nov 28, 2012 | 2008 Hyundai Veracruz

1 Answer

2008 veracruz alternator keeps dying


I would think after the second alternator they would start looking for the real problem.
Unless the extended warranty does not pay for diagnostic time.
You may have to take it to a shop that focuses on electrical systems to find the real issue. Or pay the dealer to troubleshoot it.

Sep 30, 2012 | 2008 Hyundai Veracruz

1 Answer

Drive side power door lock is not working


If the door lock works ok with a key, I would say the lock actuator is failing. Its a small electric solenoid that moves the lock rod.

Jun 26, 2012 | 2008 Hyundai Veracruz

1 Answer

Alternator replacement 2008 Hyundai Veracruz ?


Should still be under warranty? Does the vehicle have more than 60,000 miles on it?

Jun 27, 2009 | 2008 Hyundai Veracruz

1 Answer

PCV Valve location


It should sit in your valve cover. On the passenger side (if I remember correctly). It should be right on your valve cover with a line that attaches to the top of it.

May 05, 2009 | 2008 Hyundai Veracruz

1 Answer

Hyundai Veracruz cabin air filter


the filter is behind the glove box. pull the 2 clips on both sides of glove box. then remove glove box. the filter cover should be right there and just unclip the cover and replace filter.

Jan 19, 2009 | 2008 Hyundai Veracruz

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...