Question about Cars & Trucks

Open Question

1984 ford f150 4x4 short bed, replaced gas tank. and can't put gas in it

Filler neck and vent hose

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

frcs68
  • 1605 Answers

SOURCE: fill gas tank

have toyota or any machanic check the filer in the gas filler tube.

Posted on Nov 03, 2008

jim9813
  • 124 Answers

SOURCE: Replacing fuel filler neck on 2000 Crown Vic

Good news, no the tank doesn't have to come down. However, there needs to be less than 3/4 tank. Jack it up and set on a jack stand, remove the wheel, four screws housing to pipe, filler pipe sensing hose from filler pipe, screw retaining the cap, four retaining screws from filler pipe, screw from filler pipe retainer, slide into the tank until it can be rotated and pulled out through the fender. lube the tank grommet with clean oil and reverse the removal for install.

Posted on Aug 21, 2009

  • 1779 Answers

SOURCE: Can not fill 2002 Ford Explorer with gasoline.

Did you check the vent tube alongside the filler neck? If it is pinched or blocked with something, just what you describe will happen. The air in the tank needs some way to escape to make room for the gas, and it should be through the vent tube. If it's bent, pinched, blocked, you will have a hard time pumping gas in.

Posted on Dec 08, 2009

  • 2 Answers

SOURCE: need replacement for fuel filler hose 95 ford escort

The actual hose is fitted--it is 2-inch i.d. on one end and 1-7/8-inch on the other. My Ford dealer said he could order me one but the current cost is about $187 !! I am looking for a replacement, as well... -larry

Posted on Feb 17, 2010

  • 236 Answers

SOURCE: I need to siphon the

as you are pushing the hose in the tank twist the hose so it rolls over and it should go in, the hose will probably need to be three feet long, you may have to go to lowes or home depot and get a longer hose that will also fit the siphon pump

Posted on Jan 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace fuel tank filler tube?


Brother John, you've removed as much as you can for access to the filler. Remove the hose clamps/bands that secure the fill tube and vent tube and then remove the screws around the gas cap that secure the fill tube to the body. With the gas cap off, go below and pull the hose and filler neck down and work the hoses lose with a pair of channel lock pliers and sticking a screwdriver between the metal tube and hose to break the seal. Put on the new filler neck and stick it back up in the body and put the screws back in. THEN put the hose clamps back up and tighten them, put the gas cap back on and your done.

Nov 30, 2014 | 2000 GMC Jimmy

1 Answer

Gas tank vent


filler neck vent hose to tank/vent line from tank to carbon canister under hood that then hoses to fuel throttle body.

Mar 18, 2014 | 2010 Ford F-250 Super Duty

2 Answers

Gas back flow


Check again for a plugged vent hose, even check the canister close valve in between the box and cab behind the drivers side

Nov 10, 2013 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

2006 mercury mountaineer,when putting fuel in it the gas pump keeps shutting off like it full,but its not


There is a vent hose that comes from the tank back to the filler neck, it could also be the filler neck hose. Might be kinked or seperated.

Jan 23, 2013 | 2006 Mercury Mountaineer

2 Answers

WHEN I POUR GAS IN TANK IT WILL NOT GO IN TANK IT IN UP ON GROUND HOW DO I FIX THAT GAS LINE GOES TO TANK


most fords i have had have this problem the small vent hose gets a hole in it and gas won't go down, need new filler tube. u will have to lower gas tank and remove screws from filler neck around cap to change out , easier if tank is empty.

Mar 15, 2011 | 1993 Ford Econoline

1 Answer

Can't get fuel into the gas tank. Collapsed filler hose? What are the dimensions of the filler hose? Are they hard to replace? Where can I get some lenght of hose? thx, ColdinWisconsin


take a tape measure and measure th gas tank neck its better 2' hose and cut the excess after you hook it up to the tank and all that holds the hose are hose clamps

Feb 15, 2010 | 1984 Ford Ranger

1 Answer

Can not fill 2002 Ford Explorer with gasoline.


Did you check the vent tube alongside the filler neck? If it is pinched or blocked with something, just what you describe will happen. The air in the tank needs some way to escape to make room for the gas, and it should be through the vent tube. If it's bent, pinched, blocked, you will have a hard time pumping gas in.

Dec 08, 2009 | 2002 Ford Explorer

1 Answer

What is the best way to replace the fuel intake hose to the fuel tank on a 1989 ford ranger truck?im told by the state of calif. smog station that it releases fumes and will not pass the smog test.


If you are talking about the fuel filler neck or fuel filler hose, the easiest way is to remove the bed by removing the six bolts that attach it to the chassis. also disconnect the light harnesses and lift up your bed. don't forget to first release the fuel filler neck by removing three small screws at the gas filler port. then remove the hose from the tank. it is attached to the tank by a clamp. I just did two of them and it is fairly simple. It should take you about three hours if you have all the tools.

Oct 16, 2009 | 1989 Ford Ranger

1 Answer

HOW DO I REPLACE THE FILLER NECK HOSE ON A 1994 FORD RANGER XL?


open gas door - remove bolts holding gas cap filler neck plastic to bed - behind the bedside bend down this filler neck take loose hose clamp on top side of hose

Sep 30, 2009 | 1994 Ford Ranger Supercab

1 Answer

CANT FILL GAS TANK FUEL BACKING UP


You will need to replace the filler neck, the vent hose inside the filler neck gets kinked and causes this problem. The air can not vent back out of the fuel tank as you fill it.

Sep 27, 2008 | Ford E-250 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...