Question about Cars & Trucks

1 Answer

Gear problem with 2.8 maxus have to hold it in third gear it is a 2006 model

Will not stay in third gear unlessyou hold it there

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Synchronizer going out in tranny

Posted on Jul 11, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ldv maxus jumps out of 5th sometimes it stays in for a bit then jumps out ...but you can hold it in drives fine ...any idears or change gearbox


There is a plastic bushing in the top part of the transmission that wears out. It causes the problem. You can replace it threw the floor board. The bushing wraps around a ball built on the shifter. Before you pull it out. Make sure the transmission is in neutral.

Sep 18, 2016 | Cars & Trucks

1 Answer

Replacing a 3rd gear shift solenoid on a 2006 ford freestar 3.9


3rd gear shift solenoid???? mmhhh i never heard part call like that before

Nov 13, 2013 | Cars & Trucks

1 Answer

How to fix 5th gear on my ldv maxus


Its likely you have a problem with the clutchnot completly disengageing or problems with disk or pressure plate

Jun 13, 2013 | 1997 Chevrolet Cargo Van

1 Answer

I have a mazda 6 sports wagon 2005 that has started slipping out of gear while driving. It stayed in third gear until I stopped and shut it off for a few minutes. The engine light came on. When I star


Check Mazda Service Bulletin 05-016/06.

2005-2006 Mazda6 3.0L vehicles produced before Feb 24, 2006 equipped with a 6-speed AW6A-EL automatic transaxle.

Slippage or shock when pressing accelerator fully from 4/5/6.

My car is experiencing this now... the"solution" according to Mazda is to replace a transmission that they knew bad.

Aug 13, 2012 | 2006 Mazda 6

1 Answer

Have ab 96 cadillac seville we replaced the selonoids and it still wont shift. i wasb told tooo have my computer flashed


Is it struck in third gear or does it stay in low?If it is stuck in third that means that it is limp mode and has a hard diagnostic code stored in the computer .Probaly a bad sensor .If starts out in low gear and never makes the 1-2 shift it could be that the 2nd clutches are not holding or that the computer is not getting a vehicle speed sensor signal and does not know the vehicle is moving.It waould pay to have a diagnostic run and not just throw parts at it.I am sure there is some sort of code stored and if I knew what it is I could most likely tell you what is wrong.There is no way to guess.Let me know if i can help.

Mar 15, 2011 | 1996 Cadillac Seville CA Value

1 Answer

Very poor acceleration through all gears


diesel pump might not be working right. Try and check fuel pressure. I dont know if its turbo but if the turbo is failing then you will loose power

Feb 05, 2010 | 2006 BMW 5 Series

1 Answer

Automatic transmission wont go to first gear


You have checked the fluid. It's full?

Aug 16, 2009 | 2006 Nissan Sentra

1 Answer

2002 - Starts off in third gear and stays there.


Transmission speed sensor located on trans. is malfunctioning, replace.

Jul 03, 2009 | 2001 Volkswagen Beetle

1 Answer

03 tiburon stays in third gear


could be a few things... adjusting of the kickdown cable, over drive switch is not coming one, or od gear is blown.... bring it to a repected transmission shop or the dealer....

hope this helped

Jul 02, 2009 | 2003 Hyundai Tiburon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...