Question about Cars & Trucks

Open Question

Changeing glow plugs in diesel mazda bounty - Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

udesh99
  • 97 Answers

SOURCE: Where is the Glow Plug on the 350 Ford diesel

Yes, You Can do it. Normally Glow plugs located near the Injectors. But you have to use Rust off Liquid.(WD 40) Because, When you try to remove glow plug it can broken.If glow plug broken you have to dismental your engine Head.

Posted on Jun 13, 2009

badealer888
  • 414 Answers

SOURCE: can a glow plug wiring harness from a 1982 gmc witha 6.2 diesel be used on a 1998 gmc sierra with a 6.2 diesel

As long as there is not damaged areas, and all connections are the same. Should work.

Posted on Jun 23, 2009

  • 112 Answers

SOURCE: glow plugs

You'll find the glow plugs where spark plugs would be in a gasoline engine (in the cylinder heads).
The glow plugs will be smaller than spark plugs and, like a light bulb, will burn out and loose electrical continuity. You can check them in place with an ohm meter:
Remove the wire attached to the positive end and mesaure resistance to gound (engine block) through the plug. Unscrew failed glow plugs and install replacements. Carefully clean around the plugs prior to removal (to prevent dirt entering the engine) and apply the correct anti-seize compound to the threads of the new plugs where they screw into the heads. Be sure the wires are well connected without any corrosion or oxidation (no resistance).
Take your time and work carefully so as to avoid breaking or cross threading plugs. Do not wash the engine with water or detergent as the injector pump is delicate.

Posted on Jul 02, 2009

  • 7353 Answers

SOURCE: firing order for06 vw jetta diesel

Theres only 4 cylinders?? right?? its the last one.

Posted on Mar 12, 2010

  • 11 Answers

SOURCE: I have a 2006 mazda

check relay. or could be blower switch

Posted on Apr 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have mazda bounty ute runs rough on start up have replaced glow plugs


have the injectors tested as they may not be atomising as they should be. Check for air in the system

Jan 20, 2014 | Cars & Trucks

1 Answer

I have 2002 mazda bounty 2.5 diesel when it starts up it runs really rough and blows out blue smoke but comes right when warms up.I replaced glow plugs, fuel and filter, oil and filter 6mths back and it...


firstly change oil every 6000kms and a oil filter every third oil, change ,blue smoke is a sign of oil consumption whitish gray is a sign of excess fuel from worn injection system .How many miles does this vehicle have on it ? Could the valve guides need new seals and the valve cleaned and re-lapped in .then maybe new piston rings ,.Also use the cheapest oil for a diesel you find from a supermarket using expensive long life oils can cause the engine to build up too much carbon clag inside the the engine so cheap oil, and change it often is my advice ,but without a look under the bonnet myself i couldnt even think of whats wrong

Jan 04, 2014 | Cars & Trucks

1 Answer

Diesel wont start warm


Check the glow plug circuit.

Nov 20, 2013 | Mazda Cars & Trucks

1 Answer

Change glow plug relay mazda bongo


Follow the glow plug wires to a common box where all the glow plug wires congregate. This should be the timer.

Oct 16, 2013 | Cars & Trucks

1 Answer

Mazda E2500 diesel . Hard to start when cold. Have checked fuse. Relay sounds like it is clicking in. Van is a 2004 done 145000 kmc


Hello Hugh, You need to check the voltage at the glow plugs.. Just because you hear the relay clicking does not mean it is working properly.

Mar 29, 2013 | Mazda Cars & Trucks

1 Answer

My car (Mazda 323 2000cc Diesel) will not start.


ck you bat but youll probably find its your glow plugs.these are set in the head and usualy have a wire going to them.check with ohm meter.one termenal to the plug where the wire attaches the other to ground. there sould be no resistance for they are basicly a direct short to create heat that warms the air for initial start up.replace any that dont make contact with ground

Sep 21, 2009 | 1994 Mazda 323

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

357 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...