Overload reset button location? - 1994 Chevrolet Lumina APV

this
engine dead.
or good and welder side dead
buy the service manual from Lincoln??

Which circuit are you looking for? the few circuit breakers this vehicle has are auto-reset and the rest are simple fuses that blow if overloaded. None are manual reset type like a household type circuit breaker.

many pumps do not have a reset button but a thermal overload button
mostly not starting is a failure of the start/ run capacitor

Your fuel pump may be overloading from trash or rust in the tank.

the fuse controls current flow and will not blow from incorrect voltage unless the unit being used has burnt out and shorted . with 230 volts on a 115 volt unit I think that the item will be destroyed unless you are lucky enough to have an overload reset button somewhere.

If this is a refrigeration unit or air conditioner then I would read the high side gas pressure as it may have a blockage and overloading the unit.

What might you be referring to--- in detail & why?

There is no reset button for an overload situation on the fuel pump. The only reset is for when the vehicle gets into an accident, which activates on impact. So, I don't think this is what you are looking for. I would suggest looking at the fuse panel, which would be located in the engine compartment and it should be labeled. If this is not your problem, then you probably have a problem with the fuel pump itself or the fuel filter is plugged with water. The fuel filters do not like water, so by purging the gas through the bleeder valve you will be putting all that water into the fuel filter. I would suggest removing the fuel filter and purge the fuel/water at that location. You should replace the filter anyway, so I would remove it and see if the pump still works.

I would also suggest putting a couple of bottles of "Heat" or similar products in the tank, because you will not be able to get everything out.

Good luck....

If there is a reset button for an overload switch, press it down if it is up.

there should be some loose connection or short circut, that is the only thing that can cause it.