Question about Mercedes-Benz R350

Open Question

We're is the front Sam located on a r350 2008

I had my wipers stop working my light don't turn on and my rear door locks don't work or the windows. Imy mechanic did a diagnostic on it and found front Sam bad I need to locate it and replace it. I removed front passengers seat were the battery is but not sure wre the Sam unit is located. Can you help me Thanks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

stormbrewin
  • 426 Answers

SOURCE: Front passenger door lock wont work, seat belt light on

Sounds like the plastic clip that connects the lock has broken however regardless of fault the inner door panel has to be removed to diagnose and repair.It could also be inner door lock assembly.

Posted on Dec 28, 2008

  • 1 Answer

SOURCE: Power Door Lock Problem

The last post by maddog1321 was exactly what I had with my right rear door. The electric locks would not lock and unlock, and you almost couldn't do it manually without my feeling I was about to break something. I took the door panel off, oiled everything and got no relief. Finally, I saw the above post and drilled out the aft-most pop-rivet. THE WINDOW WORKED PERFECTLY! I didn't drill out the forward (closest to the handle) pop-rivet because I wanted to do one at a time so the solenoid would not fall out of place. I then put a new pop-rivet in place of the one I drilled out. I then reinstalled everything and the locks work like new.

Posted on Jan 11, 2009

mechanicm639
  • 253 Answers

SOURCE: windshield wipers quit working on 2003 chevrolet trailblazer. relays and fuses are okay.

There were some issues with ignition switches in those vehicles.It is easy to change and does not cost but about $30. Remove the column covers, unplug the switch, and depress the 2 white tabs holding it in place. Good Luck

Posted on May 23, 2009

  • 1 Answer

SOURCE: 2000 Ford Focus electric locks/acuator failure recurring problem

I would follow their recommendation as I had the same problem with my car. They unhooked the power to that door and it was fine. The problem was a short in the wiring in the door that was causing the problem. So maybe get them to check the wiring in the door as well.

Posted on May 26, 2009

  • 3 Answers

SOURCE: I took my 2006 Mazda 6 in for an oil change

Usually the autodown feature needs to be reprogrammed. there are usually 2 ways of doing this. First, roll the window down and hold the switch down for a about 5 seconds and then roll the window up and hold for about 5 seconds. Repeat if it does work just to make sure. The other way is to hold the switch up for 5 seconds and try holding down the switch for 5 seconds.

Posted on Sep 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan Xterra Brake Light Fuse Location


It's 15A FUSE 39 in the fuse & fusible link box

Mar 25, 2017 | Nissan Xterra Cars & Trucks

1 Answer

Nissan Xterra Brake Light Fuse Location


Hi, you need to test if the power is coming to the plug for rear brake light. If the power is not there that is your first problems. Also may have earth wire problem.

Jul 20, 2013 | Nissan Xterra Cars & Trucks

1 Answer

Power door locks don't work; interior lights don't work; intermittent front wipers don't work but low and high setting do; headlights switch doesn't work; interior dome lights don't...


these trucks have a generic body control module in the left kickpanel. just remove the plastic trim from the drivers floor molding to access the module. inspect the wire for green dust or gel. if there is signs of this then you have a corrosion problem. disconnect you battery and then try cleaning the corrosion all off using contact cleaner and penetrating oil. once the corrosion is gone then reconnect everything and try to see if it works. If not then it is possible that the module is damaged. you will need a new one.

Oct 28, 2011 | 2001 Dodge Durango

2 Answers

I have a 1998 chevy suburban. The dome lights don't work. checked fuse box under hood. All good. Are there other fuses on the truck?


Instrument Panel Fuse Block
The instrument panel fuse block access door is
located on the driver side edge of the instrument panel.

Pull off the cover to access the fuse block.

The vehicle may not use all of the fuses shown.

Fuses Usage
1 Rear Seats
2 Rear Accessory Power Outlet
3 Steering Wheel Controls Back light
4 Driver Door Module
5 Dome Lamps, Driver Side Turn Signal
6 Driver Side Turn Signal, Stop lamp
7 Instrument Panel Back Lighting
8 Passenger Side Turn Signal, Stop lamp
9 Passenger Door Module, Driver Unlock
10 Power Door Lock 2 (Unlock Feature)
11 Power Door Lock 2 (Lock Feature)
12 Stop lamps, Centre High Mounted Stop lamp
13 Rear Climate Controls
14 Power Mirror
15 Body Control Module (BCM)
16 Accessory Power Outlets
17 Interior Lamps
18 Power Door Lock 1 (Unlock Feature)
19 Rear Seat Entertainment
20 Ultrasonic Rear Parking Assist, Power Liftgate
21 Power Door Lock 1 (Lock Feature)
22 Driver Information Centre (DIC)
23 Rear Wiper
24 Cooled Seats
25 Driver Seat Module, Remote Key less Entry System
26 Driver Power Door Lock (Unlock Feature)

Aug 23, 2011 | Chevrolet Suburban 2500 Cars & Trucks

1 Answer

Dash illuminates when key is inserted, but when turned to start position ,the car starts and drives, but you lose indicators,wipers, rear brake lights,electric windows . there is a yellow 20 amp fuse in...


It wold be the faulty SAM according to my knowledge your technician have told you what's wrong in it. must check the front SAM and rear SAM as well,

Jul 15, 2011 | 2002 Mercedes-Benz C-Class

1 Answer

Fuses panel described in English


Hope this helps your out. I know the diagram and locator is a bit blurry but hopefully it gets what you need.
Drivers kick panel:
Front wiper 20A - Front wiper system Cigar 15A- Cigarette lighter Audio 10A- Audio, remote control mirror Air Bag 10A -Air bag diagnostics Stop lights- 15A -Rear brake light, high mounted stop light ECU B+ 10A - Shift lock actuator, transaxle controle module, radio, engine control module Room 10A - Interior light, clock, ignition key reminder, rear cargo area light switch ABS 10A- Anti lock brake system control unit ECU IG1 10A - Transaxle control module, shift lock actuator, ABS control unit, DRL unit Meter 10A - Instrument panel, back-up switch, electronics time control module, inhibit switch Turn signal 10A- Hazard switch ,front and rear turn lights, turn indicator IGN1 20A - Ignition switch ABS 30A- ABS pump motor TNS 30A- Tail light, license plate light COOL/FAN 30A- Cooling fan Cond/Fan 20A- A/C condenser fan Starter 15A- Start signal , Fuel pump Blower 25A- Blower Motor SR/ACC 10A - Ignition switch Hazard 15A - Hazard and turn signal light D/Lock 25A- Door locks ABS 30A - Anti lock brake system control P/W RH 20A- Power window motor right hand P/W LH 20A- Power window motor left hand IGN2 25A- Ignition Switch
Engine compartment :
Head 25A- headlights IG 2 30A- Ignition switch IG coil 15A -Ignition coil, condenser,generator IC regulator, diagnostic connector. O2 down 10A- Rear O2 sensor O2 up 10A- Front O2 sensor Fuel pump 10A -Fuel pump unit Injector 10A -Fuel injector ,camshaft positioning sensor, purge solenoid valve, EVAP, IAC actuator, Mass Airflow sensor, EGR stepper motor. fuel pump relay coil, vehicle speed sensor. A/Con 10A - A/C compressor controls, cooling fan BTN 30A- Brake light , high mounted stop light. Tail light LH 10A- License plate light, tail light , rear combo light, instrument panel illumination Tail light RH 10A-License plate light, tail light , rear combo light, instrument panel illumination Head low 15A- Headlight Head Hi 15A-Headlight Horn 15A- Horn jlmacman.png jlmacman_0.png

Inside kick panel jlmacman_1.png

Mar 07, 2011 | 1995 Kia Sephia

1 Answer

1998 E230. power seats,central locking,power windows, turn signals, wipers, power mirrors all stopped working


hello,check your fuse number 4 ,15 for signal light ,check also the rear fuse box for power window,central lock,power seat ,located at rear seat in front of battery,ty

May 01, 2009 | 1999 Mercedes-Benz E-Class

2 Answers

2001 Ford Expedition: Rear Wiper won't work.


THEN THERE IS BUT ONE EXPLANATION, THE WIPER TRANS IS NOT CONNECTED TO THE MOTOR DRIVE HEAD.

Feb 05, 2009 | 2001 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...