Question about Cars & Trucks

Open Question

2000 Nissan frontier fuel pressure check valve and how much pressure should it have in it

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
SUL827
  • 93 Answers

SOURCE: Nissan 2007 Frontier tire pressure monitoring system

You need to set all the pressures to 35 psi. first then drive for approx.1/4 mile. If this doesn't work to reset the light (keep in mind the code itself will still be stored even though the light goes off) you will need to take it to your Nissan Dealer to have it scanned as there may be a malfunction with the sensor. If faulty and you are under 36k miles then it should be covered under your factory warranty. Hope this helps.

Posted on Oct 17, 2008

Ad
66 chrgr
  • 1011 Answers

SOURCE: 2000 gmc jimmy wont start fuel pump comes on and cuts off...

the fuel pressure if leaking could cause this the regulator is located under the intake plenum but you should smell gas .if you dont then most likely the pump is bad ,the pump will come on for 2 seconds when the key is on then go off it will not stay on with just the key on only when you crank it will it .so have your fuel pressure checked with a gauge.

Posted on Mar 22, 2009

  • 5 Answers

SOURCE: Nissan 2007 Frontier tire pressure monitoring system

check all the tire pressures first.... then drive it for the next 10-15 miles to reset it.... it worked in my frontier ... I had the same problem as well


Hope that helped

Nissan tech +6 years

Posted on May 06, 2009

  • 2 Answers

SOURCE: change brake light bulb on a 2000 Nissan Frontier

The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.

Posted on May 04, 2010

  • 14585 Answers

SOURCE: 2000 nissan frontier knock sensor code & distributor

no but the knock sensor does send a signal the ecm and it will ****** or advance the distributor timing

Posted on Jun 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How and where do I check the fuel pressure?


Many parts stores have loan-a-tool programs that will include fuel pressure test kits. Many cars are equipped with a schrader valve type port on the fuel rail to make testing easy.

May 01, 2015 | 1999 Nissan Frontier

1 Answer

Why is my 2000 frontier V-6 3.3 using too much gas lately? The truck is 230k miles and the motor sounds very quiet.


coil packs, air filter, injectors, but check your fuel pressure regulator first, autohauz az has em for abot 20$ cant hurt to have a new one, your fuel pressure is going to bee off because of milage and the injectors get worn out and loose(they dont atomize like they used to) and the plugs get cooler and dont burn as good with weak power from old coil packs, should pep it right up after all that

Dec 12, 2014 | 2000 Nissan Frontier

1 Answer

Why is my 2000 frontier using too much gas lately? The truck has 230k miles and the motor sounds very quiet.


Engine temeprature sensor may not be working properly, tricking the engine computer to believe the engine is always "cold." Ome engine comuters may not detect a failed engine temp sensor. Another possibility, and more likely, is a defective fuel pressure regulator. It may force the fuel pressure to be high, which results in more fuel being injected than the engine expects or needs. Check the fuel pressure int he fuel rail.

Dec 12, 2014 | 2000 Nissan Frontier

1 Answer

Ok I have a 2000 Nissan frontier 6cyl. I can start it but it will run for a few sec. Then as it's about to shut off its a rough shut down. I replaced the fuel filter. Still the same. I hear the fuel pump...


Have you checked the mass air flow sensor for contamination? Sounds as if the fuel pressure is adequate,but you have another sensor going out, Nissan's air flow sensors out more common problem.

Oct 29, 2014 | 2000 Nissan Frontier

3 Answers

Truck just dies when going down the highway like it is out of gas. Replaced fuel filter and fuel pump...still having the same issue. Please help!!!


i have a 2000 nissan frontier that dies going down road,it has knock sensor,camshaft sensor&primary ignition circuit failure.had a new distributor.thanks for any help

Oct 29, 2010 | 2000 Nissan Frontier

1 Answer

I need to remove fuel pump from 2000 nissan frontier


the fuel pump is located in the gas tank.

May 19, 2010 | 2000 Nissan Frontier

1 Answer

1999 Frontier: nissan frontier 2000 automatique tansmision revers...


Either transmission oil pump is on its way out or reverse circuit is clogged , reverse shift solenoid is defective TCM may be defective , transmission range sensor begining to fail or manual shift valve and pressure regulator are defective.

Suggest taking the vehicle to a transmission repair shop they will diagnosis it and repair it.

May 18, 2010 | 1999 Nissan Frontier

1 Answer

I need the location of the 2000 nissan frontier fuel filter


there is cover plate on cross member for back wheels. it is behide it.

Oct 01, 2017 | 2000 Nissan Frontier

1 Answer

2000 Nissan Frontier quit running


You have not run a engine control module fault code test, this is key to finding the possible causes. Borrow or buy a OBD2 code reader and check the codes

Sep 11, 2017 | 2000 Nissan Frontier

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...