Question about 2005 Ford Maverick 2.7

Open Question

Zexel injector pump

No fuel to engine injectors ford maverick TD27 engine

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 80668 Answers

SOURCE: 1990 ford F150 4 x 4 5L

Then the engine fuse may be blown it will be marked ECM I think, the fuel pump and injector circuits are two seperate systems, the fuel pump most likely has a stuck relay.

Posted on Oct 21, 2008

Ad
  • 2 Answers

SOURCE: Fuel injector cut off switch for 1999 ford contour se

Try looking by your left foot, while sitting in the drivers seat.

Posted on Mar 15, 2009

  • 1779 Answers

SOURCE: 1988 ford truck f-150 xlt lariat cant get current to fuel pump

Have you checked the 'inertia switch' which in the event of an accident shuts off the fuel supply to prevent a fire . It's usually located in the cab on pass. side. Some models have one reset button, some 2 which have to be pressed at the same time. If that's not it, here's how the power to the pump SHOULD work, you will have to follow the path to see where it stops. When you turn the key on it turns on the EEC power relay on, this relay then provides power to the PCM (power control module) and the control side of the fuel pump relay. Power for the fuel pump is supplied through a fuse link or high current fuse attached to the starter solenoid (battery side). From the fuse link or high current fuse current flows thru the fuel pump relay and inertia switch to the fuel pump. The fuel pump relay is controlled by the PCM. When the ignition switch is turned on the fuel pump will operate, if the switch is NOT turned to start position, the PCM will shut off the fuel pump off after 1 second. This is to avoid flooding the engine when it is not running, just key on. So check out to see if you have a fuse link or a high current fuse and if they are blown.

Posted on Apr 15, 2009

  • 105 Answers

SOURCE: 2001 Ford Windstar runs rough.

remove the coil pack and look at bottom of it if it shows any cracks coil is bad very common on these vans if you have a noid light check for injector pulse on #4 if you have pulse and good blue spark most likely the injector is bad you have to remove upper plenum to get injectors out let me know how you make out

Posted on Jun 04, 2009

  • 122 Answers

SOURCE: ford explorer no fuel coming through

disconnect fuel filter on flow side turn key on if it spits fuel you should check the sparkplugs and injectors for propper spray pattern

Posted on Jun 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On a 93 Nissan diesel TD27 is there a second in line fuel filter on /in the injector pump?


No, and there should not be one after it. The only place a filter should be is before the injection pump.
This link shows a full breakdown of the pump and has a parts list. 104780 9910 ZEXEL INJECTION PUMP ASSEMBLY

Oct 08, 2017 | Nissan Cars & Trucks

1 Answer

93 Nissan TD27 diesel, changed fuel filter (dirty!!!!) engine idels fine but will not rev over 1800 rpm. Is there another filter in the inlet line of fuel pump


you may have a fuel tank strainer some sort of filter which filters the fuel coming out of the tank
not fuel filter more of a strainer type
see with your manufacture

Oct 08, 2017 | Nissan Cars & Trucks

1 Answer

HAVE A KABOTA B7500 DIESEL TRACTOR, PUT NEWE FUEL FILTER ON, NEW MECHANICAL FUEL TRANSFER PUMP, GET FUEL TO INJECTOR PUMP BUT NOTHING AT INJECTOR LINES WHEN TRYING TO BLEED SYSTEM, HAS A ZEXEL PUMP


you will need the engine turned on to the run position to deactivate the stop system in the pump
injector lines are bled at the injectors
loosen the nut off and crank the engine over until the diesel drops are seen

Sep 21, 2017 | Cars & Trucks

1 Answer

I asked about NISSAN terrano TD27,the question is how do you connect the diesel pipes from injector pump on to injector nozzles when pump is already on the engine?


if you have 4 or six metal lines , then they will be bent to exactly the right shape for the firing order
offer them up to the nozzle of the pump and they will fit neatly to the injector if correct
keep going until they all fit exactly
do not bend any to fit as that will cause problems with the fuel flow and make the timing wrong

Apr 23, 2017 | Nissan Cars & Trucks

1 Answer

What can the fault be if there comes a black smoke out of the exhaust of your 2008 1.4tdci ford ikon


Hi, depends what colour black smoke, is it bluey black, grey black, whitey black, You may have to take it to a Diesel fuel shop, It may be the timing on the engine or the injector pump, (the pump may need to be timed to the engine, also the Injector pump also may need calibrating.) To calibrate pump you need to take it to a Diesel Fuel Workshop. Due to wear and conditions the injectore nozzles, injector pump, timing and performance of the engine will change over time.

Jan 29, 2015 | Ford Cars & Trucks

2 Answers

1991 Nissan terrano TD27 smokey low power


Black smoke is rich fuel (lean) have the fuel pressure regulator checked the internal rubber diafram will repture and cause the to happen

Oct 24, 2012 | Cars & Trucks

1 Answer

How to remove a td27 fuel injector pump in order to reseal it?


hi.. I have TD 27 engine. first time I start it. there is small miss.so I` ve removed the whole injector pump , cleaned it & fix it. now it doesn`t start first time. but few times I tried. it will starts. but when I increased the engine speed taped noise coming. if there is any timing of the injector pump. please help me to solve it .
thanks. jaya.

Jun 13, 2009 | 1997 Nissan Pathfinder

Not finding what you are looking for?
2005 Ford Maverick 2.7 Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...