Question about Cars & Trucks

Open Question

Location of orifice tube in 1994 Mazda Protege

I am trying to locate the orifice tube inside a 1994 Mazda Protege DX. I am trying to install a new accummulator.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 23 Answers

SOURCE: location of orifice tube in 2004 ford taurus

orfice should be located on the accumulator, where the large line connects.

Posted on Oct 03, 2008

  • 82 Answers

SOURCE: orifice tube location on a 1998 gmc jimmy

Follow the smaller diameter high side line till you see a spot where there are dimples pushed in. These are the stops for the orifice so it doesn't get pushed too far in. They are usually at the front where the line goes to the radiator/condenser area.

Posted on Jun 28, 2009

harley9701ha
  • 424 Answers

SOURCE: ac orifice tube location on 2006 f150 4wd 5.4l

Check the lines coming out of the condenser . One of them has a crimped spot,that is where the orifice is located. Good luck.

Posted on Aug 10, 2009

emissionwiz
  • 75030 Answers

SOURCE: orifice tube location on a 1995 gmc jimmy

it is located in the high pressure AC line at the AC evaporator core inlet. The high pressure line is the smaller of the two AC lines that come from the AC compressor on the engine..

Posted on Mar 27, 2010

roniecon
  • 6826 Answers

SOURCE: Need the location of the orifice tube for the a/c

Look under the dryer,there is a small liquid line going into the firewall,it is in there,right at the connection,there is a swelled portion of the line,use needle nose pliers to remove the orifice tube,and to install it,if this was at all helpful,please rate,thank you.

Posted on Jul 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wiring scymatic for stero


1994 Mazda Protege Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Blue/Red
Car Radio Switched 12v+ Wire: Blue/White
Car Radio Ground Wire: Chassis
Car Radio Illumination Wire: Red/Black
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Blue
Left Front Speaker Negative Wire (-): Blue/White
Right Front Speaker Positive Wire (+): Blue/Red
Right Front Speaker Negative Wire (-): Blue/Yellow
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Blue/Red
Left Rear Speaker Negative Wire (-): Blue/Green
Right Rear Speaker Positive Wire (+): Blue/White
Right Rear Speaker Negative Wire (-): Blue/Green

Sep 07, 2012 | 1994 Mazda Protege

1 Answer

Where is the starter fuse located in a 1993 Mazda protege dx


where is the starter located on 1993 mazda protege

Mar 03, 2011 | 1993 Mazda Protege

1 Answer

We are trying to either get a diagram for an 2002 chevy impalas ac system,or the location of the orifice tube.please help.


It is located inside the condensor tube running to the evaporator.

Here are the removal/installation instructions as per alldata:

TOOLS REQUIRED

J 39400-A Halogen Leak Detector
J 26549-E Orifice Tube Remover

REMOVAL PROCEDURE
-Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
-Remove the air cleaner assembly.
-Remove the vacuum brake booster.
-Remove the condenser tube.
-Use J 26549-E in order to remove the expansion orifice tube. IMPORTANT: DO NOT use any solvents or chemicals to clean the porous plastic inlet filter of the expansion orifice tube.
-Inspect the expansion orifice tube for the following conditions and clean or replace with a new tube as indicated:
-Broken plastic frame (1); replace the tube.
Inlet filter (3) damaged or plugged with fine gritty material; replace the tube.
Inlet filter (3) coated with metal chips, flakes, or slivers; remove the coating with low pressure shop air ONLY and reuse if the filter is cleaned satisfactorily. Do NOT reuse the O-ring seals (2).

INSTALLATION PROCEDURE

IMPORTANT: Lubricate the new O-ring seals (2) with mineral base 525 viscosity refrigerant oil.
If you reuse the orifice tube, install new O-ring seals (2).
Carefully grasp the edge of the expansion orifice tube (1) without touching the inlet filter (3) and insert the expansion tube into the condenser tube until fully seated.
-Install the condenser tube.
-Install the vacuum brake booster.
-Install the air cleaner assembly.
-Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
-Leak test the fittings of the component using J 39400-A.

Aug 20, 2010 | 2002 Chevrolet Impala

1 Answer

I need to replace the wheel covers for my protege which is a 2002 DX- actually I need 2; I lost 1 and the other I want to replace is cracked - all in all, it does not look good. They do not seem to be...


There made of plastic. you can new ones( exact match) for about $50.00 apiece. or find some you like better at a parts store for $50.00 a set of four

Jun 17, 2010 | 2002 Mazda Protege

2 Answers

Where is the fuel filter located on a 2001 Mazda Protege 2.0 LX?


A 2001 Mazda Protege (actually, all models from 1999-2003 including the DX, LX, ES, Mazdaspeed, and Protege 5) does not have an inline fuel filter. The only fuel filter it has is a "strainer" or a "screen", which looks like a nylon mesh "sock". This strainer is connected to the fuel pump, located in the gas tank. Although this fuel strainer does not require periodic replacement, it is recommended that it be changed if you are replacing the fuel pump.

Jun 15, 2010 | 2001 Mazda Protege

2 Answers

Where is the orifice tube in a 1994 mustang


The A/C evaporator core orifice is located in the condenser to evaporator tube

Oct 07, 2009 | 1994 Ford Mustang

1 Answer

Expansion valve location


raven 1g: Your car doesn't use an expansion valve. It uses a fixed orifice tube which is located in the smaller of the two A/C lines, just before they enter the cabin area of the car.
Just disconnect the line and pull the orifice tube out of the line. Be careful not to break off anything and leave it in the line.

May 10, 2009 | 1999 Mazda 626

2 Answers

Where do you install transmission fluid on a 1994 mazda protege


For a manual transmission, you have to remove the speedometer cable from the top of the transmission, including the single bolt that holds the speedometer cable housing. From there, you use a long tube and a funnel to pour the transmission fluid into the speedometer cable hole. Yes, quite inconvenient.

Apr 15, 2009 | 1994 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...