Question about Cars & Trucks
If not working on any speed make sure check all fuses as they don't usually go could also be blower motor resestor
Posted on Jul 11, 2013
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Hello. Begin by checking the fuse that controls the sunroof, just look in your owner manual under fuses and you will find a diagram and location for where to look. If the fuse is bad, replace it with a new one of the exact same amperage. Also, use a can of pressurized air [like a computer duster] and clean the rocker switch that controls your sunroof, try to blow air behind it on both sides. Finally just rock that switch back and forth rapidly several times which may break the motor free so it will work again. Regards, Joe
PS please rate my answer. Thank you.
Posted on Jan 15, 2010
SOURCE: how do I remove the
On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
3. Disengage the wire harness connector locking tab and disconnect the wire harness connector and wire harness retainers from the blower motor.
4. Remove the four screws that secure the blower motor to the HVAC housing.
5. Remove the blower motor from the HVAC housing.
Fig. Blower motor (2), harness connector (1), retaining screws (3) and HVAC housing (4)
Posted on Sep 21, 2010
CODE P2767 - TRANSMISSION INPUT SHAFT SPEED SENSOR TURBINE SHAFT SPEED TSS SENSOR B NO SIGNAL.POSSIBLE CAUSE SHORT IN WIRE CONNECTOR OR FAULTY TSS SENSOR OR TURBINE SPEED SHAFT SENSOR.
Posted on Oct 03, 2010
Tips for a great answer:
Apr 11, 2015 | 2005 Dodge Magnum SXT
Aug 02, 2013 | Cars & Trucks
Dec 14, 2010 | 2005 Dodge Magnum
Sep 04, 2010 | 2006 Dodge Magnum
Aug 24, 2010 | 2006 Dodge Magnum
Jan 15, 2010 | 2005 Dodge Magnum
Dec 12, 2009 | 2005 Dodge Magnum
Jun 29, 2009 | 2005 Dodge Magnum
70 people viewed this question
Usually answered in minutes!