Question about 1993 Jeep Wrangler

1 Answer

Jeep won't start

Turns over but will not start. Changed distributor cap and fuel filter. Gets gas and gets fire

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Corporal:

    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Contributor
  • 15 Answers

If you are wright it sounds like the timing chain . Some times it will sound like it is under pressure when it cranks but not always when it has jumped time . Check the wires first you might have gotten them mixed up when you changed the cap .

Posted on Jun 24, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1118 Answers

SOURCE: 199 Jeep cherokee stalls without warning

Does it start right back up after it stalls? make sure all conections are tight at fuel pump, sounds like it could be loosing ground at pump, or hot lead is loosing its connection at pump.Also fuel pump relay could be getting hot and quits working.

Posted on Feb 09, 2009

  • 1 Answer

SOURCE: 1993 jeep grand cherokee will not start

Check to see it maybe a head gasket .mine was

Posted on Feb 28, 2009

  • 218 Answers

SOURCE: 1995 JEEP GRAND CHEROKEE RAN AND DIED WILL NOT START

IS IT THE 4.0L?IF SO U MAY HAVE A BAD CRANKSHAFT POSITION SENSOR.

Posted on Apr 28, 2009

  • 323 Answers

SOURCE: 1992 jeep wrangler with faulty acceleration. It

It is possibly the O2 sensor. I had some issues with early 90's 4.0 liters where the O2 sensor would stick rich under heavy acceleration and would cause it to lean out and bog down. It felt like a rochester four barrel flat spot on an old chevy. I hope this helps.

Posted on May 01, 2009

roniecon
  • 6826 Answers

SOURCE: 2000 jeep wrangler just shut off changed fuel pump

check foe fuel pump presure at fuel rail,,,if u have fuel pump presure check all fuses with a test light not buy sight,,could be deceviving ,look at and check to see if fuel pump relay is working if no fuel presure i,if u have presure in fuel rail ,replace the cranck shaft sensor

Posted on Jul 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990chevy suburban 2500 350 died while driving and won't restart I can hear the fuel pump turn on I have changed the fuel filter and still nothing what's next


check for spark, no spark, no fire engine wont run, possible bad ignition coil, wire from coil to distributor cap, no power to ignition coil from ignition switch (rare) wire broken to ignition coil (even rarer)

Jul 09, 2012 | Cars & Trucks

1 Answer

1997 mazda 626 won't start.


Are the plugs wet with fuel?
Check for spark. No spark? it may be the ignition module.

Plugs dry and spark present? No fuel?Spray a little starting fluid and see if it will run on that.
Then check pump fuses and for fuel pump noise.

Jun 01, 2017 | 1997 Mazda 626

1 Answer

1993 jeep cherokee won't start


MAKE SURE DISTRIBUTOR CAP ,ROTOR, SPARKPLUGS AND WIRES, OKAY IF ALL HAS BEEN REPLACED.IF NOT GETTING SPARK PROBLEM COULD BE IGNITION COIL FAULTY, ASD RELAY FAULTY,DISTRIBUTOR WITH CAMSHAFT SENSOR FAULTY OR YOU HAVE FAULTY PCM. CODE SCAN VECHICLE FOR FAULT CODE, IF YOU ARE GETTING SPARK PROBLEM IN THE FUEL SYSTEM, CHECK FUEL PUMP RELAY AND FUSE MAKE SURE FUEL FILTER BEEN CHANGED AND FUEL PRESSURE IS 39 - 41 PSI. CHECK FOR FUEL SPARK SEE WHAT GOING ON, VECHICLE NEEDS FUEL OR SPARK TO RUN IF ONE NOT WORKING ENGINE WILL NOT START.

Oct 31, 2011 | 1993 Jeep Grand Cherokee

2 Answers

My 1998 jeep cheorkee engine turns but won't crank, could it be the computer or what?


it's highly unlikely, there are only two things that can make this happen, not getting fuel (fuel pump failure, fuel pump regulator) or not getting ignition (bad coils, ignition module failure, bad distributor, distributor cap, rotor)

Jun 24, 2011 | 1998 Jeep Cherokee

2 Answers

My toyota has to crank/fire several times before it starts.


what about the ignition igniter module?? has it been replpaced, id u check for spark? do u smell gas? fuel pump may be sticking.

Jul 08, 2009 | 1987 Toyota Camry

1 Answer

1977 f250 just quit running. It turns over but won''t fire. It sounds like it is not getting gas or fire. What could be the cause?


Module in the distributors are known to go bad. If you are getting fuel, this is the cause. If you are not getting fuel, check for plugged fuel filter or fuel pump inop.

Jun 26, 2009 | 1997 Ford F250 SuperCab

1 Answer

1993 Jeep Grand Cherokee won't start.


The crank and cam sensor's are very common problems on these jeeps. Check them or have someone check them with a scanner. one or both are most likley the problem.

Feb 08, 2009 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Wrangler Logo

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...