Question about Cars & Trucks

Open Question

2006 SILVERADO 1500, ABS/& Red brake light ON

ABS/& Red brake light staying on full time on Instrument Cluster (along with annoying buzzer). Plugged Tech II scanner in and "No Comm" comes up. I can get data from other modules, had code U1041 and others.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Brian032472
  • 150 Answers

SOURCE: Abs/Brake Light ON, although new brakes, ABS still works

I would suspect a speed sensor.

Posted on Jan 30, 2009

  • 31 Answers

SOURCE: traction conrtol , abs brake lights lincoln ls 2000

it might be a loose abs cable behind one of the brakes?

Posted on Aug 08, 2009

  • 1 Answer

SOURCE: 1995 GMC Sierra Z71 ABS light stays on

yo man, idk if this is exactly what your problem is but my 1991 gmc sierra was doing the same fuckin thing and ****, and i took it to the gm dealer and had them look at it and my connectors and my ignition switchs were fried, also my truck was having a problem shitfing once those went but i also had that problem, perhaps yours is somehwta liek that as well... hope i could help

Posted on Aug 08, 2009

  • 400 Answers

SOURCE: abs codes co281 & co265

the first of the two codes is for the brake light switch, the one that is under the dash attached to the brake rod and brake peddle. Not much to diag on that one, if its bad it's bad, and when it sets the code that means it's bad.
The second one is for the abs modual, it's under the truck on the drivers side. It is bolted to the top of the thing that has all of the brake lines going to it. MOST all of the time that code is set the modual is bad. It can be a little hard to get the bolts out they are torqs 20 or 25(i'm getting old). There are four of them holding down the modual. There are also a couple of connectors going to it. And some of the time it will blow the fuse for the abs under the hood(its in the underhood fues block). Make sure to clean off the modual before you pull it out. You don't want dirt getting in the solinoids for the BPMV(that's the thing it's bolted to).

Posted on Oct 20, 2009

Michael2010
  • 14 Answers

SOURCE: I have a chevy 1500 silverado and the instrument cluster stopped

Hello Ron Sadora, Your cluster is totally digital.. Mike www.kincerservice.com

Posted on Jan 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abslight stays on. How to fix? This is a2007trailblazer?


First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit

Dec 30, 2016 | 2007 Chevrolet Trailblazer

1 Answer

Odometer displays error


Hi, this is a pretty common problem on these Silverado instrument clusters. We can definitly repair that for you. Click here to learn more about these Silverado instrument cluster problems: Dr Speedometer Instrument Cluster Repair Speedometer Repair Guage...

Jan 18, 2014 | 2005 Chevrolet Silverado 1500 2WD

1 Answer

1999 Chevy Silerado ABS & Brake warning lights come on and stay on Restart Engine and lights disapear sometimes during a drive the will both reapear (alway all 3 indication lights) the ABS and...


The only real way to find out what is going is to have a diagnostic scan. You can go to auto zone and have it scanned for free but im pretty sure their scanners are for motor only, not abs. You need an abs scanner. Any garage should be able to scan. It could range in cost from$35 to$100 for a scan. Abs light could be a as simple as wheel sensor. The brake warning concerns me though. I would check your brake fluid. When was the last time you had new brake pads put on. You may have worn the pads so low, you have run down the brake fluid.i wouldnt drive until i found out what is going on with the brakes. any other help needed, just ask.

May 20, 2011 | 1999 Chevrolet Silverado 1500

1 Answer

What brake ststem do 2001 silverados have? rear brakes


Hi. Your 2001 Chevy Silverado is equipped with Antilock Brake System (ABS). You will identify also if your car is equipped with ABS by looking at the instrument panel for a yellow ABS indicator light after you turn on the ignition.

All the best!

Nov 10, 2010 | 2001 Chevrolet Silverado 1500

1 Answer

What does the instrument light that looks like a little trailer mean on a 2006 silverado


push the button on the end of the turn signal switch and it will go out,it just supplies power full time to the trailer connection for electric trailer brakes

Jul 24, 2010 | 2006 Chevrolet Silverado 1500 2WD

1 Answer

I need a fuse box diagram for my 95 dodge dakota


Fuse 1: 30A, Green; A/C Heater Motor Fuse 2: 30A Silver (Circuit Breaker); Power Windows Fuse 3: 15A Light Blue; Overhead Consule, Day/Night Mirror, Reverse Lamps Fuse 4: 5A Tan; ABS (There is not on in the picture) Fuse 5: 20A Yellow; Power Door Locks Fuse 6: 20A Yellow; Horn Relay, Instrument Cluster, Radio Choke Relay (on Premium audio system) Fuse 7: 10A Red; Buzzer Module, Stop Lamps Fuse 8: 20A Yellow; Headlamp Switch Fuse 9: 15A Light Blue; Cigar Lighter Fuse 10: 20A Yellow; Windshield Wiper Fuse 11: 20A Yellow; Turn Signal Fuse 12: 10A Red; Radio Fuse 13: 4A Pink; Recives power from Fuse 8 to power instrument lights (such as the cigar ligher lighting, ash tray light, dash lights, radio lights, etc.) Fuse 14: 15A Light Blue; Instrument Cluster Fuse 15: EMPTY Fuse 16: 5A Tan; Buzzer Module, 4WD Indicator Lamp, Tranny O/D Switch, Tranny Oil Temperature Sensor Fuse 17: EMPTY Fuse 18: EMPTY Fuse 19: EMPTY Fuse 20: 25A Natural; Park Lamp Relay, Off Road Lamp Switch (There is not one in the picture, I believe this is only on vehicles with fog lamps)
NOTE 1: Fuse 3 and Fuse 14 provide power for the Airbag Control Module Cavities 2, and 1, respectivly. NOTE 2: Fuse 4, Fuse 7 and Fuse 11 provide power for the Controller ABS Brake Cavities 7 and 12, 9, and 3, respectivly.
Under Fuse 4, 8, and 12 is the Buzzer Module (Black rectangle in the picture) Under Fuse 16 is the Hazard Flasher (Silver circle in the picture) Under Fuse 20 is the Horn Relay (White plastic looking in the picture) To the side of Fuse 17 and 18 is the ABS Warning Lamp Relay (Open cavity in the picture) To the side of Fuse 19 and 20 is the Turn Signal Flasher (Blue circle in the picture) Between the Turn Signal Flasher and the Horn Relay is the Time Delay Relaly (the other Silver Circle in the corner, in the picture

Dec 16, 2009 | 1995 Dodge Dakota

1 Answer

06 chevrolet truck, no gauges work, power windows don't work and the ABS light is on. Alternator is charging, new batter. any suggestion I will try.


Sounds like a fuse. I would check each fuse in the fuse box one-by-one. If there is no fuse, then I would suspect the instrument cluster, which would have to be serviced by a dealer.

Dec 09, 2009 | 2006 Chevrolet Silverado 1500 2WD

1 Answer

ABS Brake lights stay on all the time


U need someone with an OBDII ABS computer too reset the light. Usually a dealer shop will do it fairly cheap...

Aug 23, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

Chevrolet hd 2500 4wd with 4l80E transmission will shift hard and sometimes on cold start it will not move . Also one time on start up the brake light and abs light stayed on and after shutting off the key...


has the fluid and trans filter been changed? this is due every 60,000 miles or sooner if used for towing, many times worn out friction modifiers in the fluid can cause this harsh shift problem.

Aug 05, 2009 | 2003 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...