Question about Cars & Trucks

Open Question

2005 dodge ram 1500 3.7 charcoal canister location

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1596 Answers

SOURCE: 2005 Dodge 1500 code p0404 EGR valve.

The electronic EGR valve and solenoid assembly is attached to the rear of the left cylinder head ,

  1. Remove electrical connector (5) at top of EGR valve solenoid.
  2. Remove tube mounting bolt (1) at intake manifold.
  1. Remove two bolts (4) connecting EGR tube (1) to valve assembly.
  2. Remove gasket located between EGR tube flange and EGR valve assembly.
  3. Remove two EGR valve mounting bolts (5).
  4. Separate valve assembly (3) from engine.
  5. Remove and discard metal gasket located between cylinder head and valve assembly.
INSTALLATION
  1. Clean area at rear of left cylinder head where it joins base of EGR valve.
  2. Clean EGR tube where it joins EGR valve.
  3. Position new gasket between EGR valve and cylinder head.
  4. Position EGR valve to cylinder head. Install and tighten two bolts (5). Refer to Torque Specifications.
  5. Position new gasket between EGR tube flange and EGR valve assembly.
  6. Position EGR tube (1) to side of EGR valve and into intake manifold.
    1. Install EGR tube flange bolt (1) at intake manifold. Tighten bolt. Refer to Torque Specifications.
    2. Connect electrical connector (5) to top of EGR valve solenoid (2).Do a final tightening of two EGR tube bolts (4). Refer to Torque Specifications

Posted on Feb 05, 2009

michigan man
  • 3533 Answers

SOURCE: Where is the oil sending unit on a 2002 dodge ram 1500 4.7 L?

it normally is located near the oil filter it looks like a little plug with a wire on it

Posted on Apr 04, 2009

  • 718 Answers

SOURCE: Where is the reverse light switch on a 1999 Dodge Ram 1500 with automatic transmission located?

Look on the gearshift lever. You will have remove the cover to get to it.

Posted on May 08, 2009

  • 1 Answer

SOURCE: where is the oil sending unit located on dodge ram 1500 v8 gas

Check the back of the top of the block, back behind the intake manifold, in the center.

Posted on May 31, 2009

suterman
  • 158 Answers

SOURCE: I need the location of MAF sensor in a 1998 Dodge

Your vehicle dose not have a maf sensor. They used a map sensor it is on the engine located under the front of the breater where it attaches to the engine.

Posted on Jul 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is a smoke test?


A test for the leak. A machine blows smoke into the evap system (the charcoal canister trap for gas vapors and the tubing associated with the evap system-including a line from the gas tank to the canister) . A small leak is hard to find, so a smoke test will help.

Nov 20, 2016 | Dodge Cars & Trucks

1 Answer

Is there a 2nd fuel filter located underneath the truck outside of the fuel filter on a 2005 dodge ram 1500 4.7 v8


The only fuel filter on the truck is located on the driver side, under-neath the door on the frame rail.

Oct 28, 2016 | 2005 Dodge Ram 1500

1 Answer

Dodge ram 2500.when pumping gas it keeps shutting off


I suspect the check engine light has been on since this started? You likely have a problem with the evap vent. It is either not working or plugged with debris. You didn't post a year or an engine so i went with a 2005. You should be able to find the LDP (leak detection pump) located on the charcoal canister mounted in front of the fuel tank on a gasoline engine. Disconnect all the hoses off from it. Try filling with gas. If you can now fill it up without the pump constantly shutting off replace the LDP.

Apr 17, 2016 | Dodge Cars & Trucks

1 Answer

Gas tank 2004 ram gas tank problems


charcoal canister aka evap canister bad , line is plugged so the vent hose from the fuel spout cant breathe so it will purge fuel back out

Jan 04, 2014 | 2005 Dodge Durango

1 Answer

Where is the fuel filter on 1999 dodge ram 1500


Open the hood of the Dodge Ram and locate the fuel canister located against the firewall of the vehicle. There is a yellow handle next to the canister that has a hose attached to it. Place the bucket underneath the hose and open the handle. Allow all the fuel in the canister to drain into the bucket. Remove the lid of the canister. Remove the fuel filter and place it to the side.
Install the new fuel filter o-rings onto the new filter. Use a small bit of automotive grease to help hold the o-rings in place. Slide the fuel filter into the canister.
Reinstall the lid to the fuel canister and tighten it down. Prime the fuel system before starting the motor. Turn the key to "acc" and allow the fuel pump to send fuel to the filter. Allow it to prime for 10 seconds and then try to start the Dodge Ram. Repeat step 6 if necessary. good-day !

Mar 19, 2012 | 1999 Dodge Ram

1 Answer

Po440 code comes on after 2 starting changed gas cap still come on


check for crack vacuum lines in to charcoal canister

Jun 27, 2010 | 2004 Dodge Ram 1500

1 Answer

Is the EGR valve located near the ESIM Canister on a 2008 Dodge Ram 1500? My check engine light came on and the problem was that the ESIM canister was missing/no there. Is this something that could be...


well knowing Dodge as well as i .....dooo.Yes! it probably did fall off! i seen some really sorry work come out of their plants over the years and yes you need to replace it also EGR valve should be on the back side of the intake manifold

Jan 15, 2010 | 2008 Dodge Ram 1500 2WD

2 Answers

What does chacoal canister do 1996 dodge ram step accelerator to floor andengine misfires


the charcoal canister is an emissions device that helps to trap high emissions

Sep 02, 2009 | 2006 Dodge Ram 1500

1 Answer

2005 Dodge Ram 1500, 4.7 A/C worked fine


The condenser fan motor is bad. Does it work when you drive? If so your fan is not pulling in air....60 bucks on Ebay

Jun 14, 2009 | 2005 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...