Question about Cars & Trucks

Open Question

1997 Infiniti j30 brake light switch replacement

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: exchanging infiniti j30 parts

I've only had experience with struts, running lights, trunk gaskets and various under-hood brackets; so far everything has been interchangeable. It may not look EXACTLY the same, but it fits. Hope it helps!

Posted on Oct 23, 2008

  • 289 Answers

SOURCE: Rear lights on my Infiniti J30 do not work.

hi..this problem is due to switch.once there is
no problem in your fuse and when the light turns
on while applying brakes then there is problem only
in your switch.Replace the switch,it will solve the issue.
check this out..
thank u..
rate me..

Posted on Feb 26, 2009

pingman37
  • 58 Answers

SOURCE: Need to add power steering fluid for 1997 Infiniti J30

There is no reserve. You will need to add it at the dipstick. 

Posted on May 05, 2009

pingman37
  • 58 Answers

SOURCE: abs light stays on.

Typically on this model along with Q45's there is a built in sensor system. The factory pads come with a sensor, so when the pads are installed there is a wired plug that must be connected to the sensor mounted on the behind the rotor. This was designed to give you a visual warning that the brake pads needed replaced. However since most aftermarket pads for this vehicle do not come with sensors, the connector is left unplugged and the circuit is open causing the light to stay on. Another thing is to check the brake fluid level. Often times as the pads wear the fluid level goes down a little. Once it reaches a certian point it will cause the light to come on as well. 

Posted on May 28, 2009

  • 2 Answers

SOURCE: I have a 1996 Infiniti j30 locked out

I've had the same problem.. The system locks the front door and you can get in through the passenger side with the key!!!

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My rear defrost want work, infiniti j30 1997


do a pin test on fuses one of them is blown! look in your service manual for loction

Nov 16, 2012 | 1997 Infiniti.5 J30

1 Answer

Will it hurt to unhook the battery


No it will be fine, but have you checked the brake switch that is right below the brake pedal?

Sep 08, 2012 | 1997 Infiniti.5 J30

1 Answer

Where is the thermostat located on a 1997 infiniti J30?


  1. Remove the fan blade.
  2. Remove the air induction pump.
  3. Loosen up the alternator.
  4. Remove that belt.
  5. Lower coolant.
  6. Remover water pump neck housing.
  7. Now you can access the thermostat.


ironfist109_440.jpg


  • Hope this helps.

Oct 28, 2011 | 1997 Infiniti.5 J30

1 Answer

Head lights won't work on 95 infinity j30


you need to replace the column switch. it has bad contacts where the headlights come on at.

Jul 26, 2010 | 1997 Infiniti.5 J30

1 Answer

My 97 infiniti j30 brake lights will not go out?


replace the brake light switch, it is located above the brake pedal, u will need to remove the trim panel under the dash to see it.

Mar 19, 2010 | 1997 Infiniti.5 J30

1 Answer

Check light is on constant on the dash. 1997 Infiniti J30


Take it in and get the "code read". It is on for a reason, and will not go off til the problem is fixed and the code cleared out.

Mar 15, 2010 | 1997 Infiniti.5 J30

1 Answer

Abs light stays on.


Typically on this model along with Q45's there is a built in sensor system. The factory pads come with a sensor, so when the pads are installed there is a wired plug that must be connected to the sensor mounted on the behind the rotor. This was designed to give you a visual warning that the brake pads needed replaced. However since most aftermarket pads for this vehicle do not come with sensors, the connector is left unplugged and the circuit is open causing the light to stay on. Another thing is to check the brake fluid level. Often times as the pads wear the fluid level goes down a little. Once it reaches a certian point it will cause the light to come on as well. 

May 11, 2009 | 1997 Infiniti.5 J30

2 Answers

Need to add power steering fluid for 1997 Infiniti J30


There is no reserve. You will need to add it at the dipstick. 

Apr 25, 2009 | 1997 Infiniti.5 J30

1 Answer

Rear lights on my Infiniti J30 do not work.


hi..this problem is due to switch.once there is
no problem in your fuse and when the light turns
on while applying brakes then there is problem only
in your switch.Replace the switch,it will solve the issue.
check this out..
thank u..
rate me..

Feb 26, 2009 | 1997 Infiniti.5 J30

1 Answer

Exchanging infiniti j30 parts


I've only had experience with struts, running lights, trunk gaskets and various under-hood brackets; so far everything has been interchangeable. It may not look EXACTLY the same, but it fits. Hope it helps!

Sep 11, 2008 | 1997 Infiniti.5 J30

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...