Question about Cars & Trucks
I need code for acura tl 2005 vin number is 19UUA66245A043396
Go to www. automecanico.com translate this website with your browser and fix it.
God bless you
Posted on Jul 10, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2005 Acura tl brake replacement
The Brembos that come on Type S/Manual models wear fast. I've changed them at 20,000 miles. They are expensive also.
Non-Type S/Manual models I have seen go 80,000 miles. The biggest factor on brake wear is how the vehicle is driven.
At 50,000 miles I would have them inspected. Depending on where you go, make sure you get an accurate measurement of both pads (inboard and outboard). 2mm is the service limit and about that time the indicators start making noise, but not always. Most indepent shops are going to sell you brake pads at 4mm. That's another 10,000 miles at least you could have driven on them.
Never replace just the brake pads, resurface or replace the rotors. The uneven surfaces of the rotor will cause your new pads to wear incorrectly and possibly cause brake noise. Most aftermarket pads will cause a squeel.
Posted on Sep 21, 2008
you need a 6 inch extension, short 3/8 ratchet, 5/8 plug socket, 3/8 swivel "u" joint, (sold at sears) 8mm 1/4 drive socket deep well and 1/4 inch ratchet.
find the coil packs (6 total, three in each head.)
remove the two retaining nuts holding each coil pack using 1/4 8mm socket and ratchet.
twist the pack to break the sticking boot below.
pull up (be careful to not rip the boots however it may still happen but rare.)
remove coil packs, the rear is a little more difficult with the intake.
use 6" extension and u joint and ratchet to remove plugs and replace.
reverse order to assemble. Good luck, and hoped this helped.
Posted on Jan 04, 2009
there should be a belt diagram from a label either on underside of hood or on radiator support. That should help if you can do it yourself.
Posted on Jan 24, 2009
Tips for a great answer:
Aug 12, 2010 | 2000 Acura TL
Apr 10, 2010 | 2004 Acura TL
Sep 25, 2009 | 2000 Acura TL
Jun 29, 2009 | 1999 Acura TL
Jun 16, 2009 | 1999 Acura TL
Feb 04, 2009 | 1999 Acura TL
Jan 06, 2009 | 2004 Acura TL
Jul 17, 2008 | 2005 Acura TL
60 people viewed this question
Usually answered in minutes!