Question about 2010 Volkswagen Fox 1.2

Open Question

Power steering pump reservoir location? - 2010 Volkswagen Fox 1.2

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Anybody know how to locate the power steering reservoir on a 2015 S350d. Searched the whole engine compartment without any luck


If the car actually has a power steering reservoir the location will be found in the vehicle handbook.

The conventional PAS with a reservoir mounted on or near the engine driven pump is in decline and is being replaced by electro-hydraulic systems with the electrically driven pump and integrated reservoir mounted on or near the steering rack and pure electrical systems are also increasing in popularity due to the ease of electronic monitoring and control.
These latter systems tend to be integrated into the steering column.

If there is an engine driven pump there will be a reservoir and you find it by following the pipes/hoses if the usual method fails.

Jun 18, 2017 | Cars & Trucks

1 Answer

Where is the power steering located at in a 2000 chevrolet malibu


If you mean the power steering pump, just look for the pump fluid reservoir. The power steering pump and reservoir are together as an assembly.

Jun 02, 2014 | 2004 Chevrolet Malibu

1 Answer

Wheres power steering pump located on 1997 ford contour,the power steering stoped working


POWER STEERING PUMP IS BELT DRIVEN PUMP LOCATED NEAR TOP ENGINE.LOOK FOR PUMP THAT HAS A RESERVOIR AND A CAP THAT READS POWER STEERING FLUID ONLY ALSO POWER STEERING PUMP HAS TWO POWER STEERING HOSE CONNECT TO RACK AND PINION.

Mar 12, 2011 | Ford Contour Cars & Trucks

2 Answers

Where is the power steering dipstick


Most power steering pumps are driven by the serpentine belt and should be in plain view when the hood is open.The following shows how to remove and replace the power steering pump and might give you a clue if not in plain sight. My dad's 1998 Ford Taurus has it nearly on top, but they could have changed things in the mean time: Power Steering Pump Removal & Installation Power Steering Pump (2V) To Remove:
  1. Before servicing the vehicle refer to the precautions at the beginning of this section.
  2. Disconnect the battery ground cable.
  3. Remove the accessory drive belt.
  4. Remove the alternator.
  5. Drain and remove the radiator coolant recovery reservoir.
  6. Position a drain pan under the power steering pump underneath the vehicle. Disconnect the hydraulic pressure and return lines and allow to drain.
  7. Remove the idler pulley from the power steering pump support.
  8. Remove the belt tensioner.
  9. Remove the bracket mounting bolt located under the belt tensioner mounting.
  10. Remove two retaining nuts from the bracket mounting studs. Remove both mounting studs, and pull off the power steering pump support with the pump attached.
  11. Clamp the pump support bracket in a suitable vise.
  12. Remove the power steering pump pulley from the pump shaft using Pump Pulley Remover T69L-10300-B, or equivalent. Remove the three bolts retaining the power steering pump to the power steering pump support and remove the power steering pump.
To Install:
NOTE: The pulley must be installed within 0.010 in (0.25 mm) flush with the power steering pump shaft.
Power steering pump special tools ford-08-00-401.gif

  1. Install the power steering pump to the power steering pump support. Tighten the mounting bolts to 18 ft-lb. (25 Nm).
  2. Install the power steering pump pulley using Steering Pump Pulley Replacer T65P-3A733-C, or equivalent; the pulley face must be flush within 0.010 inch (0.25mm) of the pump shaft.
  3. Install the power steering pump/pump support and torque nuts/bolt to 24 ft. lbs. (33 Nm).
  4. Install the bracket mounting bolt located under the belt tensioner mounting.
  5. Install the belt tensioner.
  6. Install the idler pulley to the power steering pump support.
  7. Connect the hydraulic pressure and return lines.
  8. Install the radiator coolant recovery reservoir.
  9. Install the alternator.
  10. Install the accessory drive belt.
  11. Fill the power steering reservoir with power steering fluid.
  12. Connect the battery ground cable.
  13. Run the engine and check for leaks and proper operation. Bleed the power steering system if needed.
Power Steering Pump (4V) and SHO To Remove:
  1. Before servicing the vehicle refer to the precautions at the beginning of this section.
  2. Disconnect the battery ground cable.
  3. Remove the accessory drive belt.
  4. Drain and remove the radiator coolant recovery reservoir.
  5. Position a drain pan under the power steering pump. Disconnect the power steering pump reservoir hose and allow it to drain.
  6. Using Pulley Remover T69L-10300-B, or equivalent, remove the pulley from the power steering pump shaft.
  7. Disconnect the pressure hose from the power steering pump and allow it to drain.
  8. Remove the power steering pump retaining bolts and the pump.
To Install:
  1. Install the power steering pump and tighten the bolts 15–22 ft. lbs. (20–30 Nm).
  2. Connect the pressure hose and secure the clamp.
  3. Using a Steering Pump Pulley Replacer T65P-3A733-C, or equivalent, install the power steering pump pulley: the pulley face must be flush with the pump shaft or within 0.010 inch (0.25mm).
  4. Connect the power steering pump reservoir hose.
  5. Install the radiator coolant recovery reservoir.
  6. Install the accessory drive belt.
  7. Fill the power steering reservoir with power steering fluid.
  8. Connect the battery ground cable.
  9. Start the engine and check for leaks and proper operation. Bleed the power steering system if needed.
prev.gif next.gif

Jul 22, 2010 | 1996 Ford Taurus

1 Answer

Location of Power Steering Reservoir


As far as I remember, the reservoir is part of the pump But...If it's not there it is easy to find...there are two hoses on the pump...one leads to the steering box mounted to the frame, the other goes to the reservoir, then to the steering box.

Aug 20, 2009 | 1989 Jeep Wrangler

3 Answers

Power steering pump or fluid?


From the top. The reservoir is located on the power steering pump which is ran off of a belt so it will be located in the front of the motor. Look for the cooling fan and then you will be close and should find it from there.

Jul 10, 2009 | 2003 Chevrolet Impala

2 Answers

I need to put some power steering fluid in my car but i cant find the reservoir


The reservoir is in with the power steering pump. You can find the power steering pump along the serpentine belt and remember to check the level while the engine is running. On the power steering cap there is a built in dip stick with makings, just make sure you don't over fill. Good luck and hope this helps. I think on the 3.1 and 3.4 the power steering pump is at the top just to the right od the alternator

Jul 02, 2009 | 1998 Buick Regal

1 Answer

Changing power steering pump


Power steering pump special tools

519a4ae.gif
Power Steering Pump Removal & Installation Power Steering Pump (2V) To Remove:
  1. Before servicing the vehicle refer to the precautions at the beginning of this section.
  2. Disconnect the battery ground cable.
  3. Remove the accessory drive belt.
  4. Remove the alternator.
  5. Drain and remove the radiator coolant recovery reservoir.
  6. Position a drain pan under the power steering pump underneath the vehicle. Disconnect the hydraulic pressure and return lines and allow to drain.
  7. Remove the idler pulley from the power steering pump support.
  8. Remove the belt tensioner.
  9. Remove the bracket mounting bolt located under the belt tensioner mounting.
  10. Remove two retaining nuts from the bracket mounting studs. Remove both mounting studs, and pull off the power steering pump support with the pump attached.
  11. Clamp the pump support bracket in a suitable vise.
  12. Remove the power steering pump pulley from the pump shaft using Pump Pulley Remover T69L-10300-B, or equivalent. Remove the three bolts retaining the power steering pump to the power steering pump support and remove the power steering pump.

To Install:
NOTE: The pulley must be installed within 0.010 in (0.25 mm) flush with the power steering pump shaft.

  1. Install the power steering pump to the power steering pump support. Tighten the mounting bolts to 18 ft-lb. (25 Nm).
  2. Install the power steering pump pulley using Steering Pump Pulley Replacer T65P-3A733-C, or equivalent; the pulley face must be flush within 0.010 inch (0.25mm) of the pump shaft.
  3. Install the power steering pump/pump support and torque nuts/bolt to 24 ft. lbs. (33 Nm).
  4. Install the bracket mounting bolt located under the belt tensioner mounting.
  5. Install the belt tensioner.
  6. Install the idler pulley to the power steering pump support.
  7. Connect the hydraulic pressure and return lines.
  8. Install the radiator coolant recovery reservoir.
  9. Install the alternator.
  10. Install the accessory drive belt.
  11. Fill the power steering reservoir with power steering fluid.
  12. Connect the battery ground cable.
  13. Run the engine and check for leaks and proper operation. Bleed the power steering system if needed.

Jun 28, 2009 | 1999 Ford Taurus

1 Answer

Location of power steering pump


Usually they are located near or part of the power steering reservoir. Look for the cap to fill the power steering with fluid the pump should be underneath.

May 06, 2009 | 1998 Isuzu Rodeo

1 Answer

Need to locate power steering pump for 1996 buick


The power steering reservoir will be on the left side (near the passenger front wheel) behind the coolant reservoir. It's a black tank with orange lettering on the cap. If you follow the hoses off of it, they'll lead you directly to the pump.

Apr 13, 2009 | 1996 Buick Roadmaster

Not finding what you are looking for?
2010 Volkswagen Fox 1.2 Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...