Question about 2001 Chevrolet Impala

Open Question

How do you remove front fender on 2000 impala

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace right front fender on a2007 replace fender 2007 chevy impala


There are four bolts and the hood hinge to remove on top. Remove the tire, remove the inner fender cover( seven or eight screws). There are two bolts to remove the fender from the front bumper cover. And one bolt to remove from inside the door( open the door, remove the cloth, the bolt is close to the top). Replace in reverse.

Oct 09, 2014 | 2007 Chevrolet Impala

1 Answer

How change front fender f150 2000


Fender -Front Removal
  1. Remove the radiator grille opening panel reinforcement (8A284).
  1. If equipped, remove the front wheel opening moulding.
    1. Remove the pin-type retainer.
    1. Remove the screws.
    1. Remove the wheel opening moulding.
    sy1~us~en~file=n12124a.gif~gen~ref.gif
  1. Remove the front fender splash shield (16103).
    1. Remove the screws.
    1. Remove the pin-type retainers.
    1. Remove the front fender splash shield.
    sy1~us~en~file=gn2615a.gif~gen~ref.gif
  1. Remove the cowl grille.
  1. On RH front fender, remove the antenna mast.
    sy1~us~en~file=k21762b.gif~gen~ref.gif
  1. On RH front fender, remove the antenna base.
    1. Remove the radio antenna base cap (18A927) by gently inserting a thin straight-edged screwdriver underneath the cap and carefully following inside the perimeter until both snaps are free.
    1. Remove the screws.
    1. Lift the antenna base.
    1. Disconnect the radio antenna lead-in cable (18812) and remove the antenna base.
    sy1~us~en~file=k22299b.gif~gen~ref.gif
  1. Remove the fender stuffer.
  1. Remove the stone guard.
    1. Remove the pin-type retainers.
    1. Remove the stone guard.
    sy1~us~en~file=gn2618a.gif~gen~ref.gif
  1. Remove the front fender.
    • Remove the bolts.

Sep 17, 2014 | 2000 Ford F150 Flareside SuperCab

2 Answers

How to remove front fender


They should just be bolted on, probably be a bolt or clip to the front bumper probably 4 or 5 bolts along the top of the fender, probably 1 in the door jamb and one at the bottom of fender...you will have to remove wheel and the splash shield

Jul 22, 2014 | 2000 Pontiac Sunfire

1 Answer

Fender removal


it's not always real easy to remove a fender, screws/bolts under wheel house cover, at back of fender accessed from open door, possibly from behind headlight, you just have to keep looking for all the bolts til you can pull it off

Apr 01, 2014 | 2008 Chevrolet Impala

1 Answer

In my 2000 chevy Impala has a water leaks under dashboard onto passenger floor, only when it rains?


I had the same problem with a 1994 Taurus. Within the front fender was 10 years of pine needles and leaves blocking the drain backing the water up in and over the fire wall and into the front passenger seat floor.
I took a LONG pair of needle nose pliers threw the passenger side door, and was able to remove enough debree. After pulling out out about 5 fist full's of yuck, 1 gallon a water that was stuck some where poured out flushing out the drain. I did the same on the drivers side. After that I had no problems with floods. I hope this helps. If not check your back door weather stripping if you have one. I have heard water leaking behind the passengers seatbelt and onto the floor from under the seat. Got to love Florida's rain season(s)

Oct 21, 2011 | 2000 Chevrolet Impala

1 Answer

Where is the air pump on a 2000 chevy impALA


Underneath your driver's side front fender (in front of the tire), you will find a black removable panel on the bottom. This panel can be removed or adjusted by removing the three screws attached at the bottom (front) of the fender and two screws inside the wheel well towards the bottom front. With the car jacked up and safetly standing on jack stands, remove the front driver's side tire. You can now fold this black panel back (it has a hinge point for this purpose) and gain access to the secondary air pump.

Oct 06, 2009 | 2000 Chevrolet Impala

1 Answer

Front fenders need to be removed


take the inner fender well out, unbolt the fender from the bumper, take the 2 bolts out under the car at the fender, lastly take all the bolts along the fender out, and gently pry it loose

Aug 07, 2009 | 2000 Toyota Celica

1 Answer

Need to replace passenger side front fender. I have new front fender, it is painted and ready to be installed. Are there any special problems or tools needed?


just used standard sockets with extenson, screw driver and phillips, remove head light and fender and fender guard cover. helper would really come in handy, so you dont scratch or drop fender.

Jul 07, 2009 | 2000 Ford Taurus

2 Answers

Do I need to remove the front fender


Yes if your replacing the ant. base you will have to remove or partially remove fender to gain access to the lead through the spaceframe.

Apr 26, 2009 | 2000 Saturn SL

Not finding what you are looking for?
2001 Chevrolet Impala Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...