Question about Cars & Trucks

Open Question

How do you replace the crankshaft sensor on a 2006 Durango

I am trying to see how hard it is to change the sensor on a Dodge Durango 4.7 2006 (crankshaft Sensor)

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 30 Answers

SOURCE: 04 Dodge SRT 4 crankshaft sensor

The Crankshaft Position Sensor is located directly next to the starter.

  1. On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
  2. Remove the Structural Collar
  3. Unlock and disconnect the electrical connector to the crankshaft position sensor.
  4. Remove the crankshaft position sensor bolt.
  5. Remove the sensor
Reverse Order to install except note that:

Use a twisting motion when installing the sensor.

Install and tighten the crankshaft position sensor bolt and tighten to 9 N·m (80 ±15 in. lbs.).

Posted on Aug 16, 2008

66 chrgr
  • 1011 Answers

SOURCE: Crank sensor location 1999 dodge durango

the crank sensor is located passenger side back of the engine were the trans and engine come together .there are 2 - 13mm.bolts that bolt to top of the engine.

Posted on Feb 22, 2009

  • 245 Answers

SOURCE: location of speed sensor for a 2003 dodge durango

the speed sensor for this vehicle is actually in the rear differential of the vehicle. this is the sensor that runs the speedometer also known as the vehicle speed sensor. there are also two speed sensors in the front one on each wheel known as wheel speed sensors these are for the abs system only

Posted on May 17, 2009

polarcycle
  • 1392 Answers

SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?

it is located on the right side of the motor, in the trans area. Actually in the bell housing.

Posted on Jun 23, 2009

  • 491 Answers

SOURCE: Replace crankshaft position sensor

Remove the left front wheel....(drivers side). Remove all accessory belts. Remove the crankshaft shaft pulley.......remove the plastic lower timing belt cover.....and there it is! It is mounted with one bolt.
The wiring runs down the right side of the timing cover while looking at it from the drivers side of the car.

Posted on Aug 17, 2009

Testimonial: "I ended up having my mechanic do the work. He did say he had to move all those parts to get to the sensor. "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 99 Durango 5.9 rpm goes up and down rep. Crsen wires plugs cap rotor bug still runs really rough


Check to see if all the vacuum hoses are connected to the right source.
Regards
Sir Dana

Apr 27, 2017 | Dodge Cars & Trucks

1 Answer

2003 dodge durango while driving lost acceleration, shut it off, restarted then drove fine for about 4 miles did the same thing but this time it didn't want to start. After a couple minutes it started


sounds like the crankshaft sensor gets warm and then opens up, once cooled off it closes again ( it is a transformer in epoxy housing ) I would replace it.

Apr 28, 2015 | 2003 Dodge Durango

1 Answer

Troubleshoot crank position sensor location


For testing crank sensor,check the help link below:---How to test Crankshaft Position Sensor? http://fordrepairhelp.blogspot.in/2012/03/how-to-test-ford-focus-crankshaft.html
----------

How to test Crankshaft Position CKP Sensor?

---------------
Crankshaft Position Sensor Operation?

----------------
Replace Camshaft position sensor and Crankshaft Position Sensor? http://technoanswers.blogspot.in/2012/06/2005-dodge-durango-replace-camshaft.html
----------
GMC Crankshaft Position (CKP) Sensor Replacing? http://schematicsdiagram.blogspot.com/2011/12/gmc-crankshaft-position-ckp-sensor.html

------------
These details will help.
Thanks.

Nov 25, 2012 | 2000 Cadillac Escalade

1 Answer

Check engine light, 03 dodge durango


could be what you say
run the fault codes to get a better idea

Jul 08, 2017 | 2003 Dodge Durango

1 Answer

What is a P0339 code for a 2005 Dodge Durango


crankshaft position sensor A CKT intermttent, this problem code means=== p0339--crankshaft sensor bad or a loose wire. have a good day!!

Oct 29, 2010 | 2005 Dodge Durango

1 Answer

How to change srankshaft sensor 2000 dodge durango


The crankshaft sensor is up underneath the engine - passenger side, near the exhaust. Disconnect the electrical connector, and one bolt holds it in

May 12, 2010 | 2000 Dodge Durango

2 Answers

Problem with crankshaft sensor


no you dont have to remove the transmission it on the passenger side under a bracket at the corner of the tranny. if you remove the backet you have easy access. i changed mine in thirty minutes.

Jul 19, 2009 | 1999 Dodge Durango

2 Answers

2000 Dodge durango wont start after driving for a while.


i had the same problem in a dodge ram pick up. ended up being the coil. when the coil got hot my truck would die or not start again until the engine had cooled down. replaced the coil, and whalaaaaah. no more trouble. good luck!!!!!!!!!!!!!!

Apr 21, 2009 | 2000 Dodge Durango

2 Answers

I have a 2000 dodge durango, I have a code P0320.


above me is right it's a faulty crankshaft position sensor. Hard to get this out so it may be cheap enough to have them change it at the shop. Only a $32 part

Apr 14, 2009 | 2000 Dodge Dakota Quad Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...