Question about 2006 Land Rover Range Rover Sport
Can anyone help me and tell me where the range rover sport 2006 immobiliser is located? thankyou
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The last one of these I saw the filter was in the tank.This is after checking the manual that said it was in the RH rear wheel arch.
Posted on May 16, 2009
reset service light. The SIA information is stored in the instrument cluster EEPROM and can only be reset by using T4. (Dealer tool)
Posted on Feb 25, 2010
Never change your oil while the engine is hot! Let it cool for a few hours, oil can burn you badly.
Be sure you have a safe area to do your oil change. Level, solid ground is a must so that you can safely jack up your car. I also like to put something on the driveway or garage floor underneath the engine in case you spill. Cardboard or a piece of plywood are great for this.
Before you even start to do your oil change, be sure you have everything you need to get the job done.
What You'll Need
Before you remove the oil drain plug, be sure that your recycling container is positioned underneath the oil drain. An oil change can be no fun if most of your time is spent cleaning up oil. When you remove the drain plug, let it drop into the top of the recycling container. There's a screen on top that will keep it from dropping into the muck.
Let all of the oil drain out, then replace the drain plug, tightening it to your cars torque specifications (or "snug but not too hard" if you are sans torque wrench.)
Put the cap on the oil recycling container so you can drop it off at a location that accepts used oil -- most full service gas stations accept it.
Next you need to remove your old oil filter. Using an oil filter wrench, turn the filter counterclockwise until it's free. Be careful with it, it's still full of old oil that can spill and make a mess. Some oil filters can be reached from the top, but for most you'll have to be under the car.
With the old oil out and the old filter out of the way, it's time to put the change in oil change. But before you install the new oil filter, you have to prep it. Before you screw the new oil filter into place, lubricate the rubber gasket on the end of the filter with some new oil. Next, fill the new oil filter with oil to about 2/3. It's ok if you go over that amount, it just means you might spill a bit when you screw it on.
Carefully screw the new oil filter into place. Remember, it has oil in it so don't forget to hold it upright. It screws on clockwise. You don't need a wrench to install the new oil filter. Screw it on as tight as you can get it with one hand. Overtightening the oil filter can strip its threads and cause a leak. Of course, not tightening it enough can cause a leak. So screw it on as tight as it will go with one hand, but no more.
Now you're ready to fill the engine with oil. Unscrew the oil fill cap and insert your funnel. I like to buy the 5-quart containers of oil (cheaper) but if you're using single quarts that's fine, too. Check your owner's manual to find out how much oil your engine holds. Pour a little more than 3/4 that amount into the engine. For example, if your car holds 4 quarts of oil, add 3 1/2.
If you're using a 5-quart container of oil, there is a guide on the side that shows how much oil you've put in.
You're not finished yet so don't drive off.
We didn't add all the oil because there may still be a little oil here and there we didn't account for. Check your oil and add more until you're at the right level.
Be sure to put your oil cap back on! Oil spray can cause a fire.
Posted on Oct 29, 2010
Tips for a great answer:
Sep 24, 2014 | 2010 Land Rover Range Rover Sport
May 08, 2014 | Land Rover Discovery Cars & Trucks
Nov 29, 2011 | 2006 Land Rover Range Rover Sport
Nov 17, 2011 | 2007 Land Rover Range Rover Sport...
Feb 03, 2010 | 2006 Land Rover Range Rover
Nov 08, 2009 | 2006 Land Rover Range Rover
Nov 07, 2009 | 2006 Land Rover Range Rover Sport
Sep 15, 2009 | 2006 Land Rover Range Rover Sport
186 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: