Question about Cars & Trucks

1 Answer

My 96 Chevy blazer won't accept gas every time I

Posted by on

Ad

1 Answer

Codes or no Evap Codes, the issue is in that system
You need a schematic of the evap system, so you can
test the solenoid or valves,mainly the vent solenoid, if that
applies Not the purge valve, that is up front & opens to allow
engine vacuum to draw out fuel fumes from the tank.

Posted on Jul 09, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 169 Answers

SOURCE: '96 Regal Purge Canister Valve?

ADAM
THE PURGE SOLANOID IS ON THE ENGINE WITH A RED CONNECTOR ON IT. IT IS LOCATED ON THE REAR OF THE ENGINE ABOVE THE REAR VALVECOVER. YOU ARE ACTUALLY LOOKING FOR THE CANISTER VENT SOLANOID AND IT IS IN THE REAR OF THE CAR AND THEY FAIL OFTEN. GET THE PART FROM G.M. AND THEY CAN TELL YOU EXACTLY WHERE IT IS. THE G.M. PART IS UNDER $30.00.

Posted on Aug 26, 2008

savdragon
  • 37 Answers

SOURCE: Mustang GT 4.6 EVAP Canister Purge Valve Location?

You will need to remove the right front wheel & wheel well liner. The canister purge valve is behind the cover. It should have two tube going into the bottom and one on the side near the top.
You can fix it!
If this helps you out please rate me!
Brett

Posted on Mar 19, 2009

  • 102 Answers

SOURCE: '96 Chevy Monte Carlo- codes P0441 and P1655

it will be the evap solenoid that will be the problem,not sure where it is in that car, sorry

Posted on May 18, 2009

  • 532 Answers

SOURCE: I need to locate the canister purge valve and the

look above the spare tire under the back of the box

Posted on Oct 24, 2009

  • 37 Answers

SOURCE: 2004 Chevy Cavalier 2.2 eco Automatic 94,000 miles

in my experience the usual culprit is the evap cannister. the problem is it gets moisture in it and freezes during winter thus cracking the plastic. if you lay under the car and look at the evap box it black plastic and if you see a loose or cracked hose or the box itself is cracked that is most likely it. as a side note you can check the gas cap and buy a new one to see if that rectifies the situation. lastly i don't think the gas tank should be suspect as you would probably notice if gas was leaking out of the tank. if you take the car to a dealer or shop they can do a smoke test and determine where the leak is.

Posted on Oct 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel pump in 96 Chevy Blazer replaced by mechanic, gas gauge didn't work after, took back, gas gauge only goes halfway now. What is causing this and what is remedy?


incorrectly and half assed installed. putting a fuel pump in a chevy is very difficult and takes patients. most mechanics dont have that so go to another shop and make sure they fix the problem before you pay.

Oct 18, 2012 | Cars & Trucks

1 Answer

96 chevy blazer won't start.


your gas pump is maybe your problem

Jun 29, 2012 | Cars & Trucks

1 Answer

96 chevy blazer won't start.


I'm following another issue like this on a 1996 Jimmy.
This engine requires 60psi or more fuel pressure to run.
You need to have someone check the fuel pressure at the rail- throttle body with a gauge.

Jun 29, 2012 | 1996 Chevrolet Blazer

1 Answer

How do you clear code P0440 after you change gas cap


if the gas cap was the problem it will clear it self in a week or two .Or you could take to the auto parts store and they will do it for free .You need need a reader or scaner to clear it I also have a 96 chevy and get this code from time to time it means that there is a small leak someware in the EVAP system or some times it sets off falsey . This system runs 8 differant self tests everytime you start the vehicle . But P0440 isn't a code to worry to much about it won't damage your vehicle in any way

Apr 18, 2012 | 1996 Pontiac Sunfire

1 Answer

I have a 96 Chevy Corsica and it won't start.... I


If you have a healthy spark (a blue snapping spark), it would not be a problem in the ignition system or the module. An orange, weak, or intermittent spark could point to trouble in the ignition.
I would check the timing on it, maybe it is a timing chain problem. It should have fired and ran a bit with the starter fluid. The fact that it didn't, even with a good spark, well, probably needs a little shop time investigating. Jumped timing from a worn chain? Low compression in one or more cylinders? A couple of things you need to consider.
Good luck.

Mar 31, 2012 | 1996 Chevrolet Corsica

1 Answer

Will a throttle position sensor cause my 96 model Chevy blazer 4.3L vortec get bad gas mileage I'm only getting 225 miles to a full tank


I would replace both o2 sensors and take the mass air flow sensor off and clean it with a non-chlroated brake cleaner.Also a tune-up sure won't hurt sparkplugs,plug wires,distributor cap and rotor.Your fuel milage should increase.

Jan 13, 2012 | 1996 Chevrolet Blazer

1 Answer

98 Chevy blazer won't start up but will crank ,,


Try giving it a shot of starting fluid. You don't say if it's actually firing. If it tries or runs for a few seconds off of the starting fluid then try changing the fuel pump relay. It's inside of the glove box on the left hand side behind the little door. If that doesn't work it's most likely the fuel pump.

Jul 21, 2011 | 1998 Chevrolet Blazer

1 Answer

My 1996 chevy blazer won't start. we changed the the fuel pump, fuel pump filter checked the relay and she turns over once we put gas in the carb. body. help please


Have you ever put in the gasoline tank any injector cleaner yet because the cleaner will unclog the injectors so full amounts of gasoline can get into the piston chambers the right amounts so try putting injector cleaner into your gas tank. When you put this into the gas tank to remember that it takes time for the cleaner to get to the injectors so you might have to keep trying to start the vehicle many times for the cleaner to unclog the injectors. This will not hurt your vehicle at all so go try this.

Jun 11, 2011 | 1996 Chevrolet Blazer

2 Answers

Chevy blazer wont start 2002


if it turns over there are a cocuple of things to check. crankshaft sensor and the coil pack maybe the computer.id start with the crankshaft sensor

Jun 29, 2008 | 2002 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...