Question about 2005 Chrysler Pacifica

Open Question

2006 pacifica has code po141 replaced o2 sensor ,cleared code light comes back on after car is driven twice,cuold intake gasket cause this

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 14036 Answers

SOURCE: I HAVE A 2003 CHRYSLER 300M SPECIAL 3.5HO AND

yep po132 shorted to voltage po152 shorted to voltage.this means lean conditions .you got in take leak .if you get a high voltage conditions you got rich mixture.bad plugs or stop up air filter.

Posted on May 01, 2009

Ad
chargerhp
  • 813 Answers

SOURCE: i am replacing the intake gasket on my 2005

If you are looking at the engine from the front and the large hose is at the bottom right the tightening sequence is from upper left to right 6237 bottom left to right 5148 just like I typed it torque is 250 inch pounds on lower intake and 105 inch pounds on the upper intake. So when you look at those numbers you tighten 12345678 in that order to 250 inch pounds in 3 increments then install the top intake.

Posted on Feb 25, 2010

  • 1 Answer

SOURCE: The ABS light is on my 2006 Chrsyler Pacifica Touring

Each wheel has an ABS Speed Sensor. The connectors for each of these is located in the wheel wells. The rears are up behind attached to the inside storage compartment in the wheel well and the front ones are located behind the plastic mud gaurd behind the shock. You have to pull the black plastic christmas tree holder out to get to them. There is a red safety clip on them that you have to move. I put an OHM meter on mine and they all checked at 558. I'm experiencing the same problem and have to start looking at a different problem now.

Hope that helps for your first go around of troubleshooting.
5d4c6677-07a9-41f4-8476-13b87caf5d72 1.03.01

Posted on Oct 16, 2010

hfmiles
  • 1165 Answers

SOURCE: What is the drive cycle for a 2006 Chrysler

Go to www.obdII.com for information.

Posted on Feb 15, 2011

  • 4 Answers

SOURCE: check engine light on in car 2006 pacifica have

Take car to Auto Zone or Advance they can read it for free. You can get the part you need

Posted on Jul 30, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hello I have a 96 Pontiac sunfire with codespo172


PO141 is caused by the O2 heater circuit wiring has a high resistance like an open or short to ground. the heater circuit element in the O2 sensor has an open or short. code PO172 is set when the O2 sense too much fuel is supplied and not burning completely. could be caused by a bad MAF/dirty sensor caused by dirt on the sensor wire or dirty air filter/over oiled filter if you use a K&N filter that requires it to be oiled. fuel pressure is too high causing too much fuel to enter cylinders. even fuel volume can cause this like a dirty injector allowing too much fuel to enter the cylinders. since these codes deal with the O2 sensor replace the sensor as they are a problem then clear codes and drive to see if codes reappear. or if you have a digital volt ohm meter you can test the wiring, check the MAF sensor wire for dirt and clean with intake cleaner.

Sep 03, 2014 | Cars & Trucks

1 Answer

2006 Dodge Caravan Getting Two codes: Po135 and Po141


Sadly people don't know that trouble codes only tell the mechanic what to test, not what to replace. And auto parts stores are in the business of selling parts, not giving advice.
Code 135 means there is a problem with the heater inside the o2 sensor for bank one in front of the catalytic converter. Code 141 means the same thing for the o2 sensor after the cat.
Since it is very rare to have two O2 sensors fail at the same time, chances are the problem is lack of power going to the sensors.
The power circuits would need to be checked which requires a shop manual to get the testing procedures and wiring diagrams.

Aug 05, 2014 | 2006 Dodge Grand Caravan

1 Answer

Po141 keeps coming on even though the part was changes and the code cleared from computer, why?


The P0141 code refers to your o2 sensor heater circuit. while many times replacement of the o2 sensor can solve this problem you possibly have a short or open in your o2 sensor heater circuit. Also was the proper o2 sensor changed p0141 is the bank 1 number 2 sensor. Bank 1 refers to the side of your engine where the #1 cylinder is located sensor 2 should be the second sensor on that side depending on how many sensors you vehicle has. hope this helps

Oct 12, 2013 | 2001 Chevrolet Impala

2 Answers

Check engine light


The code is for a slow response for bank 2 sensor one. This is the sensor before the catalytic converter on the side with cylinder 2.
It means the data going to the computer is not within range, not necessarily that the sensor is faulty.
Since you have replaced it twice, I would expect to find a cylinder miss, faulty injector, vac leak, or other problem with the engine.

Jul 04, 2012 | 2008 Chrysler Sebring

1 Answer

The Check Engine light came on in my 2006 Sebring Convertible. I had the code read at Autozone - P1128 (general fault?) and P0132 - O2 Sensor. I then took it to my dealership to have it serviced. They...


This code can also be caused by a thermostat that failed open. Is the engine heating up normally or taking longer than usual? Are there any symptoms? Did they run tests on the sensor? Personally, I perfer mechanics that confirm the fault before replacing parts. Too many of them do that. Be thankful that yours doesn't.

Jun 25, 2017 | 2006 Chrysler Sebring

1 Answer

Po141 o2 sensor code comes on my 1999 chevy s10 I've replaced the sensor. The check engine light came on again.


You should have 4 O2 sensors and it sounds to me like the wrong one was replaced. Bank 1 Sensor 2.

Jun 24, 2011 | 1998 Chevrolet S-10 Pickup

2 Answers

Check engine light. code po141 codepo122


po141, may be a bad o2 sensor, rear sensor after converter. the po 141 is low voltage to tps, try replacing the oyxgen sensor first and then reset the codes and drive if the po141 comes back then replace the tps,

Apr 15, 2010 | 1998 Chevrolet S-10 Pickup

2 Answers

Emission code po141 what is the problem thanks


P0141 - Heated Oxygen Sensor (HO2S) Heater Performance Bank 1 Sensor 2

HI, this code if for a fouled O2 sensor that you will need to replace asap.

Jun 01, 2009 | 2003 Honda Accord

1 Answer

2002 Alero check Engine light Codes P0132, P0137


Code P0132 is O2 sensor voltage high bank1 sensor 1, P0137 is O2 sensor voltage low bank 1 sensor 2, P1189 indicates a fuel control problem bank 1. It could be either the O2 sensors or a convertor. Could also be intake manifold gaskets. GM had a lot of problems with the lower intake gaskets leaking on the 3.1 and 3.4 engines that was linked to their Dexcool coolant. In fact they just lost a class action lawsuit about it. check with the dealer and see if the intake problem has been taken care of. Hope this helps.

Jan 16, 2009 | 2001 Oldsmobile Alero

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...