- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
-- First - double check that you have the right sized fuse. If you're using a 15 instead of a 30 - it'll blow for sure.
-- Maybe the light is too bright for your circuit. Try a dimmer bulb.
-- Next, have you had anything installed in your car BEFORE this started happening??? More specifically, on the same circuit as the one that is blowing??? If yes, you'll need to make sure that a no wire is touching any metal part of the car, or that no screw pierced a wire and now makes contact with metal or water.mthat can easily cause a short and blowbthe fuse.
Take a few moments to inspect the condition of the wires, make sure everything looks good and use electrical tape to repair if need be.
It sounds like you've got a short in there somewhere, for sure.
Since you've traced back and found nothing - I'd try disconnecting the lamps from the wiring harness and see if it blow again. If it doesn't - then it is a bulb or lamp assembly issue. If it continues to blow the fuse - you're going to need to keep tracing back further.
Your Lights Have A Direct Short Some Where Causing Fuse To Blow - Common Problem With Older Vehicles Especially If They Have Been Used For Towing / Plowing .
Check Light Sockets and Bulbs , Look For Frayed Or Melted Wiring
If a bulb blows white the gas mix in the globe is incorrect and you probably got hold of a bad batch of globes from your supplier. Try buying your bulbs from another source and see if that works out better.
If you are handling the bulbs with your bare hands that is why your bulbs keep blowing out. use a washcloth to put the bulb in or rubber gloves, anything that will keep your hands from touching the bulb.
This means you have a short. I am assuming you are talking about the fog light fuse. Does this fuse blow whether the fog lights are off? or just when turned on?
If the fuse blows when the switch is off the switch is bad too. If the fuses only blows when the switch is turned on you have a short in the wiring or bulb.
I don't know if you have test equipment so first I would say to remove both driving bulbs from their sockets and see if there is corrosion. Fix that problem if there is corrosion.
Then install a fuse without the bulbs and see if the fuse blows. If you have a test light you can bridge the fuse panel without putting a fuse in. If there is a connection you have a hot wire grounding. If there is no problem install one light, fuse or bridge the fuse holder and see if 1 light works. Try each side. This way you can isolate the problem. Then visibly inspect wiring.
Obviously a short somewhere. Check sockets for corrosion, rust etc where current could be traveling across, as well as take a look at wiring into rear if you can get to it. One other thing you could try to isolate, would be to try one bulb in at a time, perhaps one will cause fuse to blow & other won't, which will give you a reference point to start looking.
hi mate if you keep blowing fuses disconnect your front fog lights and try again if your dash lights work then a bulb has failed and gone to earth if it still blows the fuse disconnect the dahs pod (clocks) and reconect the fog lights if it does not blow the fuse the it probably is the dash pod or something associated with the pod hope it helps
it sounds like the wiring is all wrong as if its a bad earth on the car after he wired the fog lights maybe you should check and see if there is any wires hanging down underneath the bonnet that have been stripped back or see if there is and loose wires on the back of your lights or fuse board if you dont find any problems there take out the radio in the car i find that most problems to do with bad wiring or electrical problems in cars is to do with bad wiring on a radio i.e not having been installed proberly. hopes this helps