Question about 1992 Dodge Daytona

Open Question

Turn signals don't work on 1992 dodge daytona

They just don't work everything else does

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jturcotte
  • 8142 Answers

SOURCE: my turn sinals don't work.

according to autozone.com, your flasher is on driver side, under dash, driver side of steering column, mounted in relay bracket. The hazard flasher is there also. If your hazards work, turn them on to help you locate both flashers, then replace the one that isn't clicking!

Posted on Oct 20, 2010

  • 5370 Answers

SOURCE: turn signals don't work checked

For turn signal wiring diagram and troubleshooting.Please click on the link below:--- http://technoanswers.blogspot.com/2011/05/turn-signal-wiring-diagram-for-2000.html --------------- This should help.Thanks.Helpmech.

Posted on May 01, 2011

  • 7353 Answers

SOURCE: I have a 2007 Dodge

replace the COMBINATION SWITCH

Posted on Aug 26, 2011

canwoodjc
  • 3301 Answers

SOURCE: Dear Mechanics :o) I Have

check both fuse boxes,, One is under the dash inside the van, the other is under the hood,,

Posted on Sep 14, 2011

canwoodjc
  • 3301 Answers

SOURCE: 1996 Dodge Caravan 3.8 V6 ...the turn signal

you may have a second flasher unit , one for the emergency flashers and one foe the turn signals, some Caravans do . if yours doesn't happen to be one of them, you have a short in the switch itself, and will need to remove the steering wheel to replace it,, be careful, and follow the instructions for air bag safety when working with anything near the air bag,, remove the neg battery terminal first ,, then the positive,, and wait 10 minutes before doing anything else, this gives the system to discharge . when your done, hook up the battery in the reverse order

Posted on Sep 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to get to the tail light bulb on 92 dodge daytona iroc


Remove the plastic panels inside the cargo area to get to the backs of the tail light assemblies.

Apr 19, 2014 | 1992 Dodge Daytona

1 Answer

My turn signals don't work but the hazzards flash


if your hazzards flash, that means your bulbs will be good but, your turn signal fuse is blown. you should check that first, & don't forget to turn off your hazzards before you can see if your turn signals work again. give it a try.

Dec 01, 2011 | 2000 Dodge Caravan

1 Answer

Turn signals on my 1992 Park Avenue blinked slower and now donot work at all. My emergency flashers work fine and all blink but I have no turn signals and nothing lights up when signal is left or righ


About your 1992 Buick Park Avenue 3.8L SFI OHV 6cyl. the Flasher is located:
Hazard flasher: Front seating area, driver side, under dash, mounted above kick panel

Turn signal: Front seating area, driver side, under dash, driver side of steering column, mounted on support bracket

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Nov 11, 2011 | 1992 Buick Park Avenue

1 Answer

My dodge daytona will ony go backwards, and not forward,it thad a used transmission replaced in it is it the transmission again


only reverse can be two things, either the shifter cable is not properly adjusted or is attached in such a way that there is not sufficent travel on the trans pawl. The other, more expensive cause is the trans is shot. Those trans are all over the place though, in junk yards or on ebay and are not real difficult to replace-pretty much any trans from a late 80's to mid 90's chrysler/dodge/plymouth will work.

Apr 14, 2011 | 1992 Dodge Daytona

1 Answer

Im replacing a thermostat on a 92 dodge daytona i know that the spring gose down which way does the oblong side go


the body of the thermostat goes in towards the engine block ,do not fit it the other way round as engine will overheat

Jan 21, 2011 | 1992 Dodge Daytona

2 Answers

Head lights wont stay on


Check your steering column. There is a switch that cancels the turn signals in there. If it's bad, your signals will act funny and this also affects the hazard switch. Banging on the dash is what triggers the signals to work as the vibration goes into the steering column also. You might also want to check the fuses, relay switch, located inside the the left fender next to the steering column. Sometimes, the radio and the turn signals will go funky at the same time. Make sure your radio is grounded.
Hope this helps.
Cheryl
1990 Dodge Daytona 2.5 ltr. Automatic

Nov 27, 2009 | 1990 Dodge Daytona

Not finding what you are looking for?
1992 Dodge Daytona Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...