Question about Nissan Stanza

1 Answer

Cv joint front replace

Wheel is tilted and moves forward and back in gear took apart and the cv axle was not in all the way came right out could that be the problem???

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Contributor
  • 27 Answers

Movement in the wheel is pulling the axle out of the trunion end. Have some one check the front suspension.

Posted on Jul 09, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

garyq1970
  • 73 Answers

SOURCE: DO DODGE HAVE UJOINTS ON

Yes they do have U-Joints on the front axles.

Posted on Sep 03, 2008

  • 14 Answers

SOURCE: 94 Geo Prizm CV or driveaxle?

on this type of vehichle, you have two axles in the front; one going to each side. Chances are that the boot at the axle joint was torn and that is why you are having problem. In teh past people used to replace the boot, this day and age its actually cheaper to replace the axle. So you would need to replace that side of the axle (the half shaft).

Posted on Nov 20, 2008

  • 507 Answers

SOURCE: average repair cost for cv joint or axle replacement

Average time should be around 2-3 hours. Every shop charges different hourly rates. Dealerships will be around at least 80 an hour, smaller shops will run lower.

Posted on Jan 05, 2009

  • 14036 Answers

SOURCE: severe bearing noise from front wheel bearing/cv

you have to replace bearing and hub as a unit.you have to remove remove brakes and caliper rotor set them aside dont disconnect brake line. get a piece of clothes rack wire to hold brake caliper .do not let it hang by brake hose. you got to remove hub nut. best way to do that is loosen it a litttle while tire still on weight of car keep wheel from turning .

Posted on May 03, 2009

  • 1118 Answers

SOURCE: 2004 camry, vibration right front

If the wheel is in balance and there is no other signs of what is causing the vibration than yes that cv joint should be chk. Is the strut ok? might want to chk. that too.

Posted on May 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Grinding noise stops when I turn right.Is it rhe right axle?


Most likely one of the drives or cv joints

Oct 12, 2014 | Cars & Trucks

1 Answer

Front driverside tire hesitates when the vehicle starts moving


Sounds like you have a bad wheel bearing. These cars are known for that. It could also be a bad CV joint [axle] , but it won't usually make your wheel hop. Jack car up and try to move wheel top to bottom. There should be no play at all. Try spinning the wheel while it is off the ground, if it's a bearing, you will hear a grinding noise. If it's a bad CV joint, you will hear a clicking. Let me know if this was helpful to you, and until you get it looked at, I wouldn't drive it, as the wheel can fall right off if it's a bearing. Good luck

Jan 04, 2013 | 1997 Chevrolet Cavalier

1 Answer

99 geo metro automatic transmission grinds when put into gear,it happened with no warning of a malfuction,what happened?


CV Joints can break internally and cause the sound similar to trans problems.

You will either need a new axle/CV Joint, or to probably replace/rebuild the Transaxle completely.

You may be able to tell more from underneath with someone turning the wheel as you watch the CV Joint housing to make sure it's moving at the same time on both ends. If one end of the shaft moves, the other should move equally, not just the axle shaft, the ends that go into the trans and through the front wheels!


Good luck!

Mar 21, 2012 | Geo Metro Cars & Trucks

1 Answer

I believe i have an axle problem every time i put it in gear and lose all power theres hard banging noise ect.


Your cougar is a front wheel drive and the axles are called cv joints. Under your car going to each front wheel is a metal rod with a rubber boot at each end. Under each boot is the joint that allows the wheel to move up and down side to side while putting power to the tire. If your boots get torn, water and dirt destroy these cv joints. You can jack up the front of the car and with the motor off and trans in neutral, turn the front tires to see where the damage is at. Replacing the joints on fords takes special tools.

Feb 25, 2011 | 2001 Mercury Cougar

1 Answer

When four wheel engaged truck will not move forward to the right, will move forward to the left and straight chevy 1500 03


I would suspect you may have a right or left CV joint binding on either front drive axle.
I would have the truck put on a hoist and the axle joints checked for wear. I believe you will find your answer there.
Good luck.

Jan 30, 2010 | 1999 Chevrolet K1500

1 Answer

2004 camry, vibration right front


If the wheel is in balance and there is no other signs of what is causing the vibration than yes that cv joint should be chk. Is the strut ok? might want to chk. that too.

May 31, 2009 | 1998 Toyota Camry

2 Answers

Inner cv joints


inner cv joints are the joints on the inner half of the axle shaftswhere they go into the transmission. sometimes the easiest thing to do is replace the axle shafts

Jan 05, 2009 | 1996 Chrysler LHS

2 Answers

I broke the front wheel drive on my 84 corolla.


sounds like you might have a broke axel or cv joint

Dec 06, 2008 | 1984 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...