Question about Lincoln Navigator

1 Answer

Search Fixya...what causes gas guage to read empty when i have full tank on lincoln navigator

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 2 Answers

Wireing diagrams for ponitac firebird 88 5.0 pass code key

Posted on Jul 09, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 67 Answers

SOURCE: check gauges light

Possible bad guage, bad wiring, or bad sending unit. Check each one independently of each other, start with wiring first, then sending unit.

Posted on Aug 27, 2008

  • 2 Answers

SOURCE: 2005 Nissan Pathfinder Gas guage malfunction

I just fixed this problem last weekend in my 2005 Pathfinder. It's not the fuel sending unit itself, it's the fuel level sensor that is attached to the sending unit. I'm not a mechanic, but know a little about fixing vehicles and I did it myself in about 2 hours. The dealer may tell you they need to replace the whole fuel sender, but that is false. The sensor costs $80-90 from the dealer or from Courtesy Nissan in Texas. They will ship it to you. You don't need a "special nissan tool" to remove the sending unit, unless they call a hammer and screwdriver "special". It's a simple locking ring. You could probably have any shop do it for $100 labor if you supply the part. You can find instructions if you search Nissan forums. The Frontier has the same problem (since it's the same truck with a different body) so look in Frontier forums as well. Good luck!

Posted on Jan 11, 2009

CMV9
  • 594 Answers

SOURCE: gas gauge reading empty even when tank is full

Usually if the gas gage does not work yes it is true it may be the sensor if it is electronicly controlled. the sncor will more than likley be in the tank. here is how to remove your gas tank.

  1. Before servicing the vehicle, refer to the precautions section.
  2. Relieve fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:
    • Negative battery cable
    • Fuel filler and vent hoses
    • Fuel tank skid plate
    • Fuel tank wiring connectors
    • Fuel supply and return lines
    • Fuel tank
    • Fuel pump assembly
      7924bg17.gif Fuel pump assembly mounting
To install:
  1. Install or connect the following:
    • Fuel pump assembly
    • Fuel tank. Tighten the bolts to 27 ft. lbs. (36 Nm).
    • Fuel supply and return lines
    • Fuel tank wiring connectors
    • Fuel tank skid plate
    • Fuel filler and vent hoses
    • Negative battery cable
  2. Start the engine and check for leaks.

Posted on Apr 16, 2009

  • 2 Answers

SOURCE: gas gauge reads empty but tank acts like it's full

I also have a 04 with a 1.8L. same problem. I took the fuel regulator off. It is a black box behind the rear tire under car. It only has 2 bolts to take off. After that there is a couple of vent hoses from the tank going to this box. Unplug them and 1 electrical connection. The electrical connection and one vent is connected to a T connection on the box that you can unplug by twisting on the T. Take that T off and look inside where you unplugged the hose on this T. There is a spring and a little plunger inside this tube. The plunger gets stuck. I took a little screw driver and some PB blaster and worked that plunger back and forth a couple dozen times and it unfroze. Put it back together gassed up just fine. I did not look but I was told regulator can be replaced for 200$. But a can of blaster is cheaper.

Posted on Jun 10, 2009

  • 580 Answers

SOURCE: 2001 hyundai sonata 4 cl can't pump fuel into tank @ normal rate

The sending unit in your tank is going bad replace it.

Posted on Jul 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 lincoln ls that has gas guage reading only a quarter tank when full. I know there is 2 pumps on this car, one is the primary pump under passenger back seat and a jet transfer pump on drivers...


Fuel pumps outside the gas tank have nothing to do with fuel gauge readings. There is a fuel level sender unit inside the tank with a float which supplys variable ground circuit to the gauge. If you can find the wire to this unit, you can ground it to see if the gauge now goes to full. If so, sender unit in tank is bad, or has bad wiring/ground.

Jan 30, 2015 | 2002 Lincoln LS

2 Answers

Fuel guage wont read


The wire to the sender in the fuel tank is shorted. If it was open or disconnected it would read full.

Feb 12, 2014 | 1989 Chevrolet C1500

1 Answer

Fuel tank full. guage reads empty, and dash display says 0 miles to empty.


check the sending wire to see if you have a bare spot
if you don't know where the sending wire is we don't know either
as what year
model
etc

Jul 12, 2017 | Jeep Cars & Trucks

1 Answer

The fuel light on my 99 navigator is mis reading


the fuel level sensor in the fuel tank is faulty the tank will have to removed to access it

Jan 21, 2010 | 1999 Lincoln Navigator

3 Answers

Gas gauge is not reading correctly. Shows a full


the problem is caused by a defective gas gauge sending unit, this part is located inside the gas tank, you must remove the gas tank to replace it.

Dec 02, 2009 | 2002 Cadillac Deville

1 Answer

Gas guage not reading accurate


Your sending unit inside of the fuel tank is probably faulty. Unfortunately you have to drop the tank to change it.

Sep 08, 2009 | 2000 Chevrolet Silverado

1 Answer

My gas gauge is always reading full why 1999 cavalier


Hi

The most likely cause is that the fuel sender in the tank is faulty or that the wiring to the sender is bad.

Less common causes are a faulty fuel guage or circuit in the instrument panel.

Test the sender as it is the most likely cause and easiest to eliminate.

First inspect all connections that are readily visible to insure that they are secure & free from dirt or corrosion.

Disconnect the fuel tank sender wire at the tank. The guage should continue to show full (ignition on). Ground the wire from the sending unit at the fuel tank to any good grounding point on the car. The gauge should go to "Empty". If it does this is a strong indicator that the sending unit is at fault.

Hope this helps. Please do rate my answer. Thanks

Sep 02, 2009 | 1999 Chevrolet Cavalier

2 Answers

The gas guage still reads full when there is only a half tank


U are going to have to replace the fuel guage sending unit in the fuel tank, there is no other part that will cause this problem

Feb 04, 2009 | 1998 GMC Yukon

1 Answer

Gas Guage


its the float in the tank i have the same problem. it also does it when it gets to 1/4 and could be empty.

Aug 17, 2008 | 1988 Suzuki Samurai

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

fordexpert

Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...